No sim/no recovery problem on a T889.. Help :/ - Galaxy Note II Q&A, Help & Troubleshooting

Picked up a Note 2 T889 a few days ago. The phone was on 4.3 stock when I got it.
I flashed a 4.3 rom, but when it finally started up, there was no SIM card recognized - even though the phone worked fine before I flashed the rom. Being the quick thinker I am, I downloaded the 4.3 stock and attempted to flash it through Odin without any success. The firmware will lock up when it tries to flash the modem, soft bricking the phone, which I can get around by re-starting the install-recovery-then-everything-else process over.
I tried grabbing the modem.bin and flashing that straight from the stock package, but the phone still says no SIM. When I put the SIM in another phone, it works fine. I've done everything I can think of (short of putting stock back on, because again, stock won't work for some reason) to try and solve the issue. At this point, I'd deal with having stock on the phone if I could get it to recognize the SIM.
I'm going insane trying to get it solved and I know it's something simple.. Anyone?
Thanks in advance.

Related

Stuck at "Samsung" screen after odin flash

I was messing with my Gs2, trying out some new roms (it has been rooted and custom flashed since i got the phone a while ago) and ended up with a soft brick getting stuck at the Samsung screen during boot. No big deal I though (since this is my backup phone I didnt worry about it) and planned on flashing back to stock with Odin and starting over. I flashed the stock 4.1 via odin and it all seemed to go fine, but when it rebooted it got stuck at the same samsung screen. I left it there for like 20 minutes and it never booted. I then downloaded the stock 4.0 and same thing. I am about to try going back in time to the stock 2.3 and see if i can work my way forward from that, but if it doesnt work, what is the cause of the phone not being able to boot after all these stock flashes?
jay-red said:
I was messing with my Gs2, trying out some new roms (it has been rooted and custom flashed since i got the phone a while ago) and ended up with a soft brick getting stuck at the Samsung screen during boot. No big deal I though (since this is my backup phone I didnt worry about it) and planned on flashing back to stock with Odin and starting over. I flashed the stock 4.1 via odin and it all seemed to go fine, but when it rebooted it got stuck at the same samsung screen. I left it there for like 20 minutes and it never booted. I then downloaded the stock 4.0 and same thing. I am about to try going back in time to the stock 2.3 and see if i can work my way forward from that, but if it doesnt work, what is the cause of the phone not being able to boot after all these stock flashes?
Click to expand...
Click to collapse
Im stuck in the same boat with my S4
which ODIN version are you using and are you using the links from SAMMOBILE to get the firmware you need ? also what are your methods of procedure and is odin giving out any errors or saying pass and still no boot ?

Did i Brick my phone?

Recenttly i got a note 2 sch-i317 phone. It was runing the stock 4.3 update from att.
I am on tmobile, so i downgraded the phone to 4.1.1 and unlocked it.
Life is good and the phone is working fine.
then i get the great idea of upgrading back to 4.3 via the OTA update. And there starts all of my issues.
Orignaly i was under the impression i had used a stock att 4.1.1 to downgrade. now looking back i used a rooted version. i dont remember where i found it but here is the name of the file: root66_ATT_I317UCALJ2.tar.md5 (and i had to do a factory reset to get it to boot correctly)
Now here is the issue.
I can not get back into the recovery menu. However i can get into the Download mode.
Tried to flash TW recovery
Tried to flash CWM recovery
Tried to flash I317UCAMA4_I317ATTAMA4_ATT firmware
Tried to flash I317UCALJ2_I317ATTALJ2_ATT Firmware
i installed Kies and installed the usb driver it came with.
At first it did not detect my phone. now it detects my phone. but during the emergency repair, it downloads and extracts the new firmware but sits at 0% (and times out) when it pushes the firmware.
Im at a lost. i have spent 14+ hours in the past 2 days working on this, and i am burning out. help
re-flashed I317UCALJ2_I317ATTALJ2_ATT Firmware
and followed this
http://forum.xda-developers.com/showpost.php?p=49098941&postcount=2
and my phone works again
Woo Hoo !!!!
More goodness here.
http://forum.xda-developers.com/showthread.php?t=2618447

[Q] Touchscreen and sim reader both stopped working at same time

I have the ATT sgh-i747. I was using it as normal. The battery was low and i could not charge it before it got to 0%. After it died, I connected the charger and started it back up. When the screen came on, the "no sim-emergency calls only" message was there and the touch screen did not work. Also, the time and date were off. it said 3:59 September 15th. I tried the normal reset (take battery out, replace, turn back on) several times and still the same thing. I had just replaced the sim reader a month ago, as well as the rear camera and speaker, and everything was working as normal. I opened the phone up to make sure all connections were set. Still the same message. I did a factory reset and after I turned it on, still, the touchscreen does not work and it says no sim. I find it odd that both these things would stop working at the exact same time. Also the phone is long past its warranty. Any ideas on what this could be?
Anyone?
Have you tried flashing another ROM?
I don't know how to do that, if you could point me in the right direction I'd appreciate it.
Before anyone can give you advice, we need as many details as you are able to provide.
Was your phone running a stock ATT ROM? What ROM was it running? Are you able to boot into download mode?
Stock Rom, phone is not rooted and I can boot to download
What stock ROM? It's important that anything you flash does not try to downgrade the bootloader if you were on stock 4.3 or 4.4.
I'm not 100% sure. I want to say 4.3. There was a software update for the phone that automatically downloaded about a week ago but im not sure if that is related.
Since you received an update a week ago, you may be on KK.
I suggest flashing Philz Touch recovery via Odin and see if you can boot into recovery. In recovery you can see if the digitizer responds.
Flash the latest tar version from here in Odin: https://goo.im/devs/philz_touch/CWM_Advanced_Edition/d2lte/

Soft brick, do I need to repartition?

So here's the back story. I'm usually good with roms/recovery/flashing. Even did some custom rom work on my old Galaxy S 4G, so not a noob. I have a Wind T999V.
Had Touch-CWM installed, ran a few 4.4 ROM's for a while, tried LP, Liquid smooth. Liked it ok, but wanted to try OctoROM LP. It needs TWRP. Had a few problems with TWRP before on my phone, the Wind variant seems somewhat different in small ways, but figured I'd give it a try again to flash OctoROM since it needs TWRP. Thought maybe the TWRP has improved since I tried last, so installed TWRP, tried to flash Octo, but TWRP wouldn't see my internal SD card at all. The same problem I had before. I didn't feel like digging out a SD card from my camera to put Octo on, so rebooted the phone, installed CWM back, rebooted again, got a bootloop somewhere along the way.
Figured I'd go with Odin back to stock and start over. Grabbed odin (hard now, lots of spam/scam copies) and my stock firmware for the Wind version from Doc's thread. Flash the tar, which took forever (used a sort of crappy cable) and it auto rebooted after like 20 mins of flashing, just stuck at the sammy logo for like 20 mins. Too long, still looped I think.
Grabbed a different cable and a newer version of a good odin I know from my network I had laying around, 3.09, and tried again. At the pulsing samsung logo again, going to wait, but if I did softbrick it, do I need to repartition and a pit file to get the FS back to something different than any of the KK or LP rom's I ran?
EDIT:
Read some threads and took doc's advice and booted into stock recovery and wiped data and cache, and it finally booted. Phew.

[Q] Back to stock from Lollipop

Hi everyone
Long time xda follower, newly registered, since I needed to ask a Q.
I rooted and switched to Lollipop on my ATT S3 (i747) a few months ago, Lately, I've started noticing battery issues as well as network issues with this ROM. I figure it is time for me to go back to stock.
However, if I remember correctly, when I tried previously the phone refused to downgrade back to stock. Kies was helpless because the trip counter had been reset (or something similar).
Please, is there a good how-to on downgrading this phone from Lollipop back to stock? If yes, would someone please point me to it?
Much thanks in advance.
lsiravi
Hmm.. I am going to give this a try:
http://forum.xda-developers.com/galaxy-s3/general/fix-s3-to-factory-unroot-stock-recovery-t2323847
lsiravi said:
Hi everyone
Long time xda follower, newly registered, since I needed to ask a Q.
I rooted and switched to Lollipop on my ATT S3 (i747) a few months ago, Lately, I've started noticing battery issues as well as network issues with this ROM. I figure it is time for me to go back to stock.
However, if I remember correctly, when I tried previously the phone refused to downgrade back to stock. Kies was helpless because the trip counter had been reset (or something similar).
Please, is there a good how-to on downgrading this phone from Lollipop back to stock? If yes, would someone please point me to it?
Much thanks in advance.
lsiravi
Click to expand...
Click to collapse
lsiravi said:
Hmm.. I am going to give this a try:
http://forum.xda-developers.com/galaxy-s3/general/fix-s3-to-factory-unroot-stock-recovery-t2323847
Click to expand...
Click to collapse
Nope! No go!!
Triangle away reset the counter.
The stock recovery works well. I was able to boot to recovery and wipe the data and all that.
Odin says "SW Revcheck Fail" when trying to download the stock rom.
I rebooted into Lollipop, downloaded Triangle away again and reset the counter. Still Odin fails with the same message.
I tried flashing ROM first then the recovery as it was suggested in that link. Nope. Again "SW Revcheck fail". For the record, my SWREV appears to be 3. It is supposed to be 0. Triangle Away does NOT reset this. It did reset another counter (as reported by Triangle away itself - was 5, got reset to 0).
I remember *this* was the problem previously as well, hence the original Q:
How *do* you get back to stock from Lollipop on the Galaxy S3/ATT?
Meanwhile, although Keis failed to recognize the device, I tried to run a firmware recovery manually. It took a long time and in the end failed. It also messed up the recovery, so I had to flash CW again to make it bootable. I'm still back up with Lollipop at this point, but I don't want Lollipop.
Anyone anything else I can do? Any other guide out there to downgrade?
Thanks again
L
The thread you linked is for the international version of the s3.
Before flashing anything else, you need to confirm the bootloader on your phone to ensure that you don't flash anything that attempts to change the bootloader if your bootloader is mjb or newer.
audit13 said:
The thread you linked is for the international version of the s3.
Before flashing anything else, you need to confirm the bootloader on your phone to ensure that you don't flash anything that attempts to change the bootloader if your bootloader is mjb or newer.
Click to expand...
Click to collapse
Right. I finally figured it out.
First the 4.1.1 FWs weren't flashing (in other words SW REV CHK FAIL) was basically indicating that my Bootloader was far ahead of the 4.1.1. I dropped 4.1 after I figured that part out.
Next, I tried to flash a 4.4 (UCUFNE-rooted-odex is available as a zip-flash) through CWR, which didn't work (no boot, stuck at splash).
Next I got hold of a 4.3 (UCUEMJB-2024954-REV04-user-low-ship), which successfully flashed through Odin (repartition checked), but there was no sound, IMEI indicated null. Service Mode yielded a blank screen.
I flashed TWRP through Odin (was working on CWR since the beginning) and then flashed the UCUFNE-rooted-odex above on top of 4.3 through TWRP, which was successful, still no sound/IMEI/service mode.
Finally I got hold of the UCUFNE-Modembaseband zip (a small one - 20MB) and flashed that through TWRP. Both sound and IMEI came back.
I'm at 4.4.2 now, but an OTA update from ATT failed (probably because it went through TWRP)
Now I'm back to stock, albeit rooted ROM (because of the Rooted-Odex 4.4 flash), but I am a happy camper.
Thanks to XDA for various bits of info here and there. But essentially *this* is how you go back to stock from Lollipop.
L

Categories

Resources