I have a strange issue, I think. I was taking some notes with SNote when I noticed in the top right hand corner what looked like a very faint pink trashcan icon. Upon further inspection, it appears to be a circuit board outline. There are also two very pink 1/2" squares along the right hand edge near the bottom of the phone. There are also three equal size and spaced dots on the bottom right hand corner. Very faint, but noticeable on the white backgrounds.
There are there no matter what app is running.
Has anyone had this issue? What causes it? It happened nearly instantaniously while I was simply using it in my hand.
I just went to ATT. They say it is screen burnout. Turns out it is an app that I always have open. Under warranty, I just have to call Samsung
QUOTE=BigBeefy;61503394]I have a strange issue, I think. I was taking some notes with SNote when I noticed in the top right hand corner what looked like a very faint pink trashcan icon. Upon further inspection, it appears to be a circuit board outline. There are also two very pink 1/2" squares along the right hand edge near the bottom of the phone. There are also three equal size and spaced dots on the bottom right hand corner. Very faint, but noticeable on the white backgrounds.
There are there no matter what app is running.
Has anyone had this issue? What causes it? It happened nearly instantaniously while I was simply using it in my hand.[/QUOTE]
Related
Hi. Is anyone else finding the screen calibration with the s pen is irregular in a vertical area all down the left side of the screen? Not right at the left edge, but just in a bit. It's hard to explain, but if I write in this area one letter draws too big and the next letter smaller (only horizontally).
Sent from my GT-N7100 using xda premium
I'm having the same problem. However on the left side as you go more towards the bottom it gets further worse. As you go more down on the left side the pen writes more to the right of where you are actually writing. And when you more towards the right side of the screen (middle). It goes back to normal where it's exactly precise.
hi all
i have same problem and check in the agency and thy tell me to change the screen
but at the end i found my problem <<<<<
it's the protecting cover i have , it's came with two magnetic in back side and in right side so there is a blind circle in one part in the screen and get error and fault axis so when i get the mobile from the cover it's work fine so check if cover or nay magnetic around your mobile
So I'm wondering if anyone has noticed this on their device, or if I'm just going crazy. The metallic frame/band that runs along the outside of the phone appears to be raised slightly higher in relation to the glass on the right side of the phone (facing you) than on the left. If I run my finger over the screen and the edge there is a noticeable difference between the screen and the frame on the right side of the screen but not on the left, top, or bottom. I don't know if this is just some sort of imperfection, like the glass is recessed on that side or if it's just how the phone is. Anyone see something similar on their device?
I notcied it on mine too.. Just slightly though.. Not enough to notice until I pick it out. Thought I was the only one with eyesight going bad.
CitrixLemon said:
So I'm wondering if anyone has noticed this on their device, or if I'm just going crazy. The metallic frame/band that runs along the outside of the phone appears to be raised slightly higher in relation to the glass on the right side of the phone (facing you) than on the left. If I run my finger over the screen and the edge there is a noticeable difference between the screen and the frame on the right side of the screen but not on the left, top, or bottom. I don't know if this is just some sort of imperfection, like the glass is recessed on that side or if it's just how the phone is. Anyone see something similar on their device?
Click to expand...
Click to collapse
You are not the first person iv heard of with a problem like this so i would have it checked out by the people you got it from and get an exchange if possible..
I have noticed this too. I have a Verizon S4 and have been looking for anyone else with this problem. I don't know about you but it is driving me nuts having the unevenness feeling when I hold the phone. Please update if you try to get a replacement.
So far my new zenwatch has been great. However, I have noticed in a couple apps such as Multi Calculator for wear, that buttons at the bottom like . and at the top like ac/c don't respond very well. Then I noticed that throughout the entire watch interface, the top and bottom 1/4 of the screen (not the bezel) are entirely unresponsive to touch. I wanted to see if this was a defect or possibly a byproduct of that curved glass not allowing the capacitive sensor to extend beyond that middle portion of the screen. Does anyone else notice this?
I've mostly been marking it up to bad aim on my part but it seems to me that I often miss touches in the upper right corner. Too soon to tell if it's the watch or just my shakiness.
Yeah I thought my aim was off too. Try dragging from the top on the watch face screen. You'll notice it actually starts to pull it down a few millimeters from the top. I was hoping it was a defect so I could just exchange it but my fear is that they all do it and it is not fixable via software.
I agree that the first couple of millimeters of the actual screen don't respond but nowhere near 1/4 of it.
I notice this on my zenwatch after using an lg g watch, g watch r and moto 360 all side by side. The zenwatch also seams less accurate on thing nlike minuum keyboard and generally with scrolling. I suspect a cheaper less accurate digitizer has been used?
On mine I can hit the topmost part of the screen, the bottom, and all corners. I turned on "Show touches" in the developer options to make sure it registers where im touching. If you test it that way, you can see if its a defective screen or just accuracy issues.
I've noticed a black, cloudy, vertical line on the right of my phone. Just besides the yellow stain. While I know that the yellow stain comes from the glue, I'm not sure what the black one is. It's always present, unlike yellow which is visible only at higher temperatures. When I press my finger on the spot, it kind of disappears. What is this and can it be fixed? (without changing the screen, of course)
As the title says my unit has a pink/yellow/purple/whatever it is in the bottom left corner. In any case the color is distorted in that area and I keep noticing. Does it go away? It can only be seen on white (I spend all my time on google now so this is an issue)