[Q] HTC ONE X installation fails with Message "FAILED <remote: not allowed>"
While following the process of flashing a new firmware in fastboot mode I am getting the following failure message :
" FAILED <remote: not allowed>"
1. adb shell reboot bootloader
2. fastboot flash zip PJ46IMG_ENDEAVOR_U_ICS_40_S_HTC_Europe_2.15.401.5_Radio_2.1204.127.19_test_272977.zip
Followed the 2 commands ast to go to fastboot mode and 2nd to flash firmware
sending the flash data is SUCCESS with OK message but Failure message appears during writing which is failing with message:
" FAILED <remote: not allowed>"
Attaching here the screen shot of the commands followed and
Need urgent help to resolve this issue.
Re: [Q] HTC ONE X installation fails with Message "FAILED <remote: not allowed>"
At first i don't know if this method works to begin with, but the remote not allowed error is because of the locked bootloader
Re:[Q] HTC ONE X installation fails with Message "FAILED <remote: not allowed>"
Mr Hofs said:
At first i don't know if this method works to begin with, but the remote not allowed error is because of the locked bootloader
Click to expand...
Click to collapse
Thanks a lot for ur quick response...
U r right bcz I checked the bootloader shows its LOCKED. How to unlock the bootloader? Can we unlock it or not? plz help me
Re: [Q] HTC ONE X installation fails with Message "FAILED <remote: not allowed>"
You can check this
http://forum.xda-developers.com/showthread.php?t=1604439
Or make an account on HTCDev site and unlock it there
Hi there,
I have just tried to root my HTC one, and I am now stuck in the boot loader screen and it is showing *Tampered* at the top.
Can someone please advise me, or point in the direction of what I need to do now?
Thanks.
If it says tampered it should say unlocked right below it.... go to this site and follow the instructions to get full root. http://forum.xda-developers.com/showthread.php?t=2699065
jeanxx said:
If it says tampered it should say unlocked right below it.... go to this site and follow the instructions to get full root. http://forum.xda-developers.com/showthread.php?t=2699065
Click to expand...
Click to collapse
I should have mentioned that I only have a Mac.....
Yes it does say unlocked underneath it...
Suggestions?
millhhaus said:
I should have mentioned that I only have a Mac.....
Yes it does say unlocked underneath it...
Suggestions?
Click to expand...
Click to collapse
Once you have unlocked your bootloader then it will show you tampered.
Download a custom recovery (I prefer TWRP) and flash it via fastboot.
Then download @Chainfire Supersu flashable zip from his site and flash it in recovery.
You have rooted your phone.
Ater placing my device into fastboot mode, I have tried flashing my downloaded TWRP file to my HTC One in Terminal using these instructions:
Now let's flash your downloaded TWRP file to your HTC One. Type one of the following commands into your terminal window, depending on which file you downloaded above.
For the International editions, type:
fastboot flash recovery Desktop/openrecovery-twrp-2.7.0.2-m8.img
However I get the following error:
command not found
any help would be most appreciated.
Did you setup your mac to use adb / fastboot commands?
lazydesi said:
Did you setup your mac to use adb / fastboot commabds?
Click to expand...
Click to collapse
I feel like a total N00b at the moment. LOL.
No. How do I do that?
try this
http://forum.xda-developers.com/showthread.php?t=2638673
Thanks for that information.
Now, when I am trying and to flash TWRP via fastboot I am getting this error message:
ERROR: Unable to create a plug-in (e00002c7)
< waiting for device >
ERROR: Unable to create a plug-in (e00002c7)
millhhaus said:
Thanks for that information.
Now, when I am trying and to flash TWRP via fastboot I am getting this error message:
ERROR: Unable to create a plug-in (e00002c7)
< waiting for device >
ERROR: Unable to create a plug-in (e00002c7)
Click to expand...
Click to collapse
hi,
plz try CWM, M8 got some issues with twrp.
philz_touch_6.26.6-m8.img is the stable version plz try that.
http://goo.im/devs/philz_touch/CWM_Advanced_Edition/m8
So I am starting to move forward :
I have followed the instructions to install philz_touch_6.25.5-m8.img by flashing it to my HTC where I get the setup screen for philz_touch_6.25.5-m8.img. I cleared the cache and I then installed the UPDATE-SuperSU-vx.xx.zip using the install zip from sdcard and then rebooted the HTC.
Unfortunately I have come back to the bootloader screen.
For what the instructions say it should be working now, but it does not seem to be?
Now it seems that whatever I try I cant seem to get past the bootloader....
And when I power down from the bootloader, It shuts down for a few minutes and then boots back into the bootloader.
Not sure what to do now?
millhhaus said:
So I am starting to move forward :
I have followed the instructions to install philz_touch_6.25.5-m8.img by flashing it to my HTC where I get the setup screen for philz_touch_6.25.5-m8.img. I cleared the cache and I then installed the UPDATE-SuperSU-vx.xx.zip using the install zip from sdcard and then rebooted the HTC.
Unfortunately I have come back to the bootloader screen.
For what the instructions say it should be working now, but it does not seem to be?
Now it seems that whatever I try I cant seem to get past the bootloader....
And when I power down from the bootloader, It shuts down for a few minutes and then boots back into the bootloader.
Not sure what to do now?
Click to expand...
Click to collapse
is your problem similar to this?
http://forum.xda-developers.com/showthread.php?t=2784232
May be you are using the wrong version.If you have international device you should try international version of philz/cwm recovery.I would suggest you to use TWRP since it is basically meant for htc devices.
Why am I getting this "FAILED (remote: image error! (BootMagic check fail))" error message all the time?
Davids-MacBook-Air:desktop millhhaus$ fastboot flash boot cm-10.2.1-m7ul.zip
target reported max download size of 1830711296 bytes
sending 'boot' (198067 KB)...
OKAY [ 6.904s]
writing 'boot'...
FAILED (remote: image error! (BootMagic check fail))
finished. total time: 6.905s
millhhaus said:
Why am I getting this "FAILED (remote: image error! (BootMagic check fail))" error message all the time?
Davids-MacBook-Air:desktop millhhaus$ fastboot flash boot cm-10.2.1-m7ul.zip
target reported max download size of 1830711296 bytes
sending 'boot' (198067 KB)...
OKAY [ 6.904s]
writing 'boot'...
FAILED (remote: image error! (BootMagic check fail))
finished. total time: 6.905s
Click to expand...
Click to collapse
because you are using M7 files mate. you need to use M8.
M7 - Htc one - 2013 model
M8 - Htc One - 2014 model
http://download.cyanogenmod.org/?device=m8
Hi there, i need your help. When i flashed twrp to my zenfone 2 go. I get bootloop while oem still locked. I think its wrong twrp.
the biggest problem is i have no any recovery in my device,
so i can't flash firmware from adb updater
I have tried
-unlock oem
still failed:
(Remote: Unlock operation is not allowed)
-erasing and formatinh chache
still failed
(Remote: unknown command)
-flash recovery twrp (with other version)
Failed: not allowed
Thanks you for help me
Hi there,
I try to install lineageos on my xperia xz2 compact but i dont manage to get the bootloader unlocked.
The rooting status says : Bootloader unlock allowed: Yes. so i thought it should be fine but in fastboot mode the command
Code:
fastboot oem unlock <unlockcode>
gives me:
Code:
...
FAILED (remote: Command not allowed)
finished. total time: 0.069s
I tried with flashtool (found this in some forums) but i get some error as well. Even though i am not sure to use this program properly and I also got some
"No device is registered in Flashtool. You can only flash devices."
error message there.
any ideas?
problem solved, I didn't know that I would have to enable "oem unlock" in the device's developper options. what a fail..
Hi. iv'e been trying to unlock the bootloader on my device in order to install custom rom but i get this error everytime i use fastboot flashing unlock:
FAILED (remote: 'Command not support: the display is not enabled')
fastboot: error: Command failed
And yes i checked that OEM Unlock is enabled and USB Debugging aswell. I also tried typing fastboot oem unlock but it says:
FAILED (remote: 'unknown command')
fastboot: error: Command failed
any ideas why unlocking doesn't work? thanks.
I have the same problem
Is there anyone who can help??
I refresh, is there anyone who can help?
I refresh, is there anyone who can help?
I refresh, is there anyone who can help?