Looking for a way to completely reset my htc one. Went through a couple roms and atm am sitting at CM11 but want to get back to basic sense 6 as if i had just bought it. Even ARHD would work but i cannot get to the proper firmware version to use it, and even when i did try to use it it didnt want to work for me, kept getting something about protocol failing. Any ideas would help me at this point!
Cek this
http://forum.xda-developers.com/showthread.php?t=2265618
Related
Hi guys,
I need your expertise and ultimately your help!
So i was running Lee droid for months, it was all good, did loads of flashing of roms without never any (massive) issues.
Last week, i decided i wanted to try gingerbread, so I flashed gingervilain and the kernel that went this it. I din't really like it, i missed sense too much so i decided to go back to Lee Droid.
I did a clean install after wiping everything as i've done dozens of times in the past. But ever since a problem has arisen.
Whenever I'm on call, when i move the phone away from my face, the screen doesn't turn on and I can't turn it on at all, even when i press on the power button. Which means i can't hang up. So if i call someone and end up on voicemail, I need to remove the battery to finish the call, and whenever I am on the phone with someone I have to ask the person to hang up as I have no control over the phone.
The phone is to be totally irresponsive.
I tried to re-install gingervillain and had the same problem. So I reverted again back to Lee's rom, from a clean install and the problem persists!!
Last night I tried to format the card and I installed snq's new kernel, but it still doesn't work.
I have no clue what's going on. Could it be a voltage issue???
I'm s-on by the way.
I'm seriously confused at what the fark could be going on!?
Anyone has any idea?
On Lee's rom forum, a poster told me to flash a RUU or WWE rom. But I don't really wanna do that for two reasons :
1. I'm not sure it will work since installing Lee's rom on a clean install didn't solve anything
2. I don't really wanna go through the hassle of rooting my phone again
Thanks!
Using an RUU is your best bet since no one knows wtf is going on. I would say to do that as well and I'm sure maybe a few others would. Yes, you would have to root again (not like it takes forever and not like you have to do anything other than plug your phone into your PC and run the unrevoked utility, seriously). That would be your best chance for fixing it. BTW, using an RUU would wipe everything out and start fresh so it probably would fix the issue.
If it doesn't... well, that's for another time.
u can try go into settings turn off senser
exit settings
then go back in settings again set the senser on again
I see more and more people having the deep sleep bug, rooted or not.
Wish I knew how to fix the damn thing! The only sure thing is that if the phone is at stock condition (rooted or not does not matter), it doesn't have the problem.
When I install some apps, it would start doing this!
Alright, I guess I don't have much choice then! I'll flash a ruu.
Thanks a lot fo your help guys
Hey everyone, I'm Having trouble with tons of issues with my Sprint note 2 that came with version 4.4.2.
I've been struggling for weeks trying to fix this on my own so any help will be EXTREMELY appreciated.
Here's the problem:
-EVERY TIME i make a backup of ANYTHING it does not restore. I sit there waiting on the load up screen for over an hour about 6 times now. I have TWRP version 2.7.0.0 because the 2.7.1.0 does not work and will not work for me for some reason. To fix it i have to flash the complete stock rom on it like it comes from the factory with odin. Then i have to root the phone again and try it all over again. Please if anyone has any idea whats going on here please help!.. i tried recovering with almost every option and i cant find help anywhere! :crying:
-Now this is a big problem. Since i cant recover from my backup when i flash a new rom it is taking a lot of my time. i flash a rom to my device and every time i have no signal. Like i flashed Omni and Liquidsmooth for example and they work perfectly! except i have no signal!.. I've read some forums and they said to type in some numbers to call and reset your phone for latest Profile and crap but it says no signal obviously so i cant call anything. What I'm wondering here is if there is a fix to my problem. I flash my phone to stock every single night after i try and work on it for hours and hours so i can have service the next day at least. I've been doing this for 2 weeks straight and i'm kinda getting sick of it. And if i call sprint support to help get signal back to my device would i get in trouble or something because i'm using a custom rom? so they would most likely not help me?
-I also have an issue with my Sprint Airwave as when i root my phone or flash a rom it immediately stops working! I'm not to worried about that as much as the other issues i have . But i thought i would just throw that out there!
I hope someone knows some of these problems. Like i said ANY help will be greatly appreciated.
Please look into this issue for me as i have spent way to much time on this and i just want a rom on my dang phone ... Thanks for your time!
Have you tried using Philz Recovery instead of TWRP?
ANDROID...A New Digital Revolution Of Incredible Developers
askills said:
Hey everyone, I'm Having trouble with tons of issues with my Sprint note 2 that came with version 4.4.2.
I've been struggling for weeks trying to fix this on my own so any help will be EXTREMELY appreciated.
Here's the problem:
-EVERY TIME i make a backup of ANYTHING it does not restore. I sit there waiting on the load up screen for over an hour about 6 times now. I have TWRP version 2.7.0.0 because the 2.7.1.0 does not work and will not work for me for some reason. To fix it i have to flash the complete stock rom on it like it comes from the factory with odin. Then i have to root the phone again and try it all over again. Please if anyone has any idea whats going on here please help!.. i tried recovering with almost every option and i cant find help anywhere! :crying:
-Now this is a big problem. Since i cant recover from my backup when i flash a new rom it is taking a lot of my time. i flash a rom to my device and every time i have no signal. Like i flashed Omni and Liquidsmooth for example and they work perfectly! except i have no signal!.. I've read some forums and they said to type in some numbers to call and reset your phone for latest Profile and crap but it says no signal obviously so i cant call anything. What I'm wondering here is if there is a fix to my problem. I flash my phone to stock every single night after i try and work on it for hours and hours so i can have service the next day at least. I've been doing this for 2 weeks straight and i'm kinda getting sick of it. And if i call sprint support to help get signal back to my device would i get in trouble or something because i'm using a custom rom? so they would most likely not help me?
-I also have an issue with my Sprint Airwave as when i root my phone or flash a rom it immediately stops working! I'm not to worried about that as much as the other issues i have . But i thought i would just throw that out there!
I hope someone knows some of these problems. Like i said ANY help will be greatly appreciated.
Please look into this issue for me as i have spent way to much time on this and i just want a rom on my dang phone ... Thanks for your time!
Click to expand...
Click to collapse
I've had this same problem, I know a bit about flashing custom roms, but only cause i've learned through trial and error. I also have a note 2 on sprint, the L-9000. What I done was found a stock, or close to stock (something was changed cause it shows as custom in my phone instead of stock). that got my signal working again. But what I have read (and anyone that knows more than I do, which is going to be alot of people here, feel free to correct me) is, it has to do with your APN settings which seems to be telling the phone how to interact with the towers. so here is how I would handled it (if there are any devs that disagree by all means enlighten the both of us on this issue)
1. if you haven't already, get a custom boot loader like Clock Work Mod
2. flash stock rom
3. re-boot to boot loader
4. make back up of phone in functioning state and then copy over to your computer
5. download custom roms and tinker away. if you ever brick the phone or mess up and have no service, load the backup from step 4.
so my phone has been running slow for a while now... figured it was nothing and never cared( had another phone to use) now im back on this one as the other broke. i was trying to put the CM 11 on with the 4.4 .... and when i wiped data, the rom wouldnt install and i tried a few times. i would have backed up first but i didnt because it would not let me. and now i am trying to use ADB but my cell wont mount. any ideas? im a froob for cell phones and dont know as much. i have twrp 2.5 and i can get into that boot menu. its a canadian phone.
GT-i9250m i just want to get this cell working again so i dont have to use a htc 8s. i really dislike windows phones.. and i do believe this means i have no os on there atm. i think it was running 4.2 or something idk. thanks for help if anyone can
I have rooted multiple g1s and I have at least installed different roms on the G2 slide, believe I rooted it too but I may have bought it rooted.
When I did root, I know sometimes you have to change the radio, possibly the kernel, and many other things, but I haven't done anything in a long time. This phone thankfully came rooted with FreedomPop through an ebay purchase.
I am seeing things about not running JB modem for Cyganomod Rom 11. I need a refresher and to get up to date with how things work.
Possibly Important: I currently have 2 issues with my phone though, one is that I cannot charge my phone's battery using the port of the phone, and I cannot have my sd card in, otherwise my phone turns off all the time.
Also, I am unable to make Rom Manager do a backup of my current Rom, but somehow I apparently somehow managed to get the recovery to be on my phone... kept giving me errors or just loads forever when trying to flash it.
What all do I need to do to install a CMD11 rom?
Basebane version: S710. 10 S.FL24
Kernel version 3.0.15-1173404
Let me know what else is needed to know for you to better assist me. Please give any advice, tips, warnings, etc. you have.
Thank you in advance.
i cant seem to find all the files i need, i formated data, via TWRP / formated everything, trying to get back to stock, because everytime i turned around something kept uninstalling supersu, one min id have root, the next i didnt think it was kernel issues idk, i wanna start over though, can someone help me. this is what im working with these two photos. i was running SkyHigh-v3.60, and BigDaddyPK1_Aroma1.x
https://forum.xda-developers.com/sp...uide-links-files-update-root-restore-t3366862
Flash the latest TAR file in Odin and you return to stock.
mac.os.x said:
i cant seem to find all the files i need, i formated data, via TWRP / formated everything, trying to get back to stock, because everytime i turned around something kept uninstalling supersu, one min id have root, the next i didnt think it was kernel issues idk, i wanna start over though, can someone help me. this is what im working with these two photos. i was running SkyHigh-v3.60, and BigDaddyPK1_Aroma1.x
Click to expand...
Click to collapse
If you don't want to jump all the way to starting over with ODIN flash, you can just load TDH-JR ROM, which has probably what you want: https://forum.xda-developers.com/sprint-galaxy-s6/development/rom-tdh-jr-rom-t3550677 -- maybe give that a shot.
I fixed it yesterday finally, thanks for the response though but I ended up doing I downloaded like three different Factory ROMs and I tried each one of them thinking that but then I read somewhere that once I upgrade the CPL or somewhere along them lines that I can't go back but they added this stupid ass code that you can't go backwards cuz of the battery issues they had when all the galaxys were blowing up, somet hi ing l8ke that, so after I read about that I went ahead and well obviously at that point you just want to fash yiur factory ROM at that point is the ROM that you upgraded to just grab that same ROM and use the same kernel and everything and I did and it booted but I sold that
S6 i think I'm going to try I'm and check that ROM out that you just posted the one I'm on now the black one that were referring to right now I sold the yesterday after I fixed it but this white one is the better one and I'm about to root it now plus it's already unlocked it's a Galaxy SM g920p 32gig unlock I'm rocking MetroPCS on it right now and I'm getting pretty good signal actually.