Develop Bugs

Enter password to decrypt storage

Hello everyone. I have a xperia m c1905 from a friend and when i turn it on, shows me this message. As he said to me, he didnt something. I tried with flashtool with the bl button and shows me that the "phone bootloader cannot officialy unlocked". After that, I tried to flash the firmware with 2-3 different firmwares with no luck. It shows me this message
30/034/2015 15:34:36 - INFO - Device connected in flash mode
30/034/2015 15:34:44 - INFO - Selected C1905 / 15.1.C.2.8 / CE
30/034/2015 15:34:44 - INFO - Preparing files for flashing
30/035/2015 15:35:22 - INFO - Please connect your device into flashmode.
30/035/2015 15:35:23 - INFO - Opening device for R/W
30/035/2015 15:35:23 - INFO - Reading device information
30/035/2015 15:35:23 - INFO - Phone ready for flashmode operations.
30/035/2015 15:35:23 - INFO - Current device : C1905 - YT910CE629 - 1274-5498_R1C - 1272-2325_15.4.A.1.9 - WORLD-i_15.4.A.1.9
30/035/2015 15:35:23 - INFO - Start Flashing
30/035/2015 15:35:23 - INFO - Processing loader.sin
30/035/2015 15:35:23 - INFO - Checking header
30/035/2015 15:35:23 - INFO - Flashing data
30/035/2015 15:35:23 - INFO - Loader : S1_Root_dbe9 - Version : loader_MSM8X30_10 / Boot version : S1_Boot_MSM_8227_5 / Bootloader status : ROOTABLE
30/035/2015 15:35:23 - INFO - Processing partition-image.sin
30/035/2015 15:35:23 - INFO - Checking header
30/035/2015 15:35:23 - INFO - Flashing data
30/035/2015 15:35:23 - INFO - Processing kernel.sin
30/035/2015 15:35:23 - INFO - Checking header
30/035/2015 15:35:23 - INFO - Flashing data
30/035/2015 15:35:24 - INFO - Ending flash session
30/035/2015 15:35:24 - ERROR - ERR_SEVERITY="MINOR";ERR_CODE="0017";ERR_DYNAMIC="0x8020001C ";
please help me

It'd been an usual thing and had been long discussed.
Whatever your rom is, whatever the kernel, whatever it's single or dual sim. It just, attack. Randomly!
My community call it "Ebola" since what causing this is still unknown.
But the worst thing is that the physical NAND (internal drive) is damaged because of this, so you CAN'T just re-flashing your phone (whether via Flashtool or recovery).
Only thing currently known to fix this is to replace the phone's main board (yes the whole board, because the NAND is planted on that).
Or you just sell your phone (one-at-a-time or separately) then get a new one, that's what we're doing here.
Hope it's clear to you,
good luck..
p.s. here one of our member sell his Xperia M separately because of Ebola :
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

[ROOT] [GUIDE] [CWM] FOR Wing Hero V45 - Wing Hero 40S [ MTK 6572 ] 100% Working Root

[ROOT] [GUIDE] [CWM] FOR Wing Hero V45 - Wing Hero 40S [ MTK 6572] 100% Working Root
Hello , I am from Vietnam
Here , I will guide you how to root and install CWM RECOVERY
Info My Devices
Hardware : MTK6572
Chip: Media Tek
Model : V45
Build number : SW_T97057Z3_M11_WINGTECH_V009_20141028
Build date UTC : 20141027-134105
Android v : 4.4.2
Baseband v: MOLY.WR8.W1315.MD.WG.MP.V43, 2014/07/18 11:38
Kernel v : 3.4.67 ([email protected]) (gcc version 4.7 (GCC) ) #1 SMP Mon Oct 27 21:38:09 CST 2014
Click to expand...
Click to collapse
Here are the procedures
1. Download Files Given Below.
2. Install Drivers From " Tools And Drivers.rar "
3.Open SP flash tool and load Scatter "MT6572_Android_scatter.txt"
4.Chose recovery_cwm.img and make tick only on recovery.
5. Click on download
6. Connect phone with "USB Debugging on"
7.Double click on "RUN.bat" from " Tools And Drivers/adb/" (press yes if phone asks for permission)
Flashing will start
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Video Demo:
Cách ROOT và Cài CWM WING HERO 40S - WING HERO V45 [MTK6572 - 4.4.2] by Hưng Thịnh
Now For Rooting
1.Put "UPDATE-SuperSU-v1.94.zip" in your sdcard
2.Connect phone with debugging ON
3.Double click on "RUN2.bat" from " Tools And Drivers/adb/"
4.You'll be in recovery mode now "install zip" and choose "UPDATE-SuperSU-v2.46.zip"
5.Your Phone is now rooted reboot enjoy.
6.Hit Thanks.
Download
SP_FLASH TOOL: Download

không được bac ơi

[Help me] - M8 can not turn-on wifi on Android 6.0

Hi every one, i flash a new cook rom to my HTC M8 Sprint.
SkyDragon M8 v1.5 Marshmallow http://forum.xda-developers.com/htc...the-worlds-first100-m9-port-m8upload-t3064838
Now i can not turn on wifi. When i try airplane mode then turn airplane mode off, it show an error message "Fail to load drive, reason: Unknown Error (1)"
I try some others rom, i still get the same error. So i think may be i do something wrong.
Please tell me how do i fix it. Thank you.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

Your firmware is not correctly installed.
Now it shows - 1.54.651.8 (4.25.651.18) (in red)
It should show - 4.25.651.18 (in green)
You should update it to Marshmallow 6.20.651.3 to run a Marshmallow ROM
All you need are in Sprint forum - http://forum.xda-developers.com/showthread.php?t=2729173
NOTE : SkyDragon ROM v.1.5, v.1.5.1 & v.4.0 do not support Sprint device. Other SD versions support Sprint pre-Marshmallow only.
So.. try other ROM after you updated firmware to Marshmallow.

I have flashed 6.20.654.3 Full Firmware...(fastboot flashable): https://www.androidfilehost.com/?fid=24391638059059027
Now my bootloader still have a red line

Why you said 6.20.654.3 firmware but the screenshot show 6.20.651.3 ?
Do you know that you need to install firmware.zip twice ?
fastboot oem rebootRUU
fastboot flash zip firmware.zip
You'll see -
if failed : FAILED (remote: 90 hboot pre-update! please flush image again immediately)
repeat fastboot flash zip firmware.zip
fastboot reboot-bootloader (to check your current bootloader)
Anyway .. you better ask your question in Sprint thread or wait for someone with Sprint device to advise you further. I can only advise you on general/basic stuff because my device is non-Sprint

Thank you a lot.
I flash new firmware successful, with the green line .
Now i try an other rom.

[Urgent] Need help restoring G3 (D855) to stock (Stuck in Download mode)

Hi,
I am a complete newbie when it comes to this so please explain in simple terms.
So I will explain as briefly as possible:
- I have Windows 10 x64
- Bought LG G3 last week, it had Android 4.4.2 (and was already rooted)
- It had overheating issues and battery died fast so I tried to update Android via LG PC Suite -> Did NOT work
- I read that having root access blocked it, but that I could update manually
- I installed USB drivers
- I setup ADB and Fastboot
- I tried using LG Flash Tool 2014 and the Android 6.0 KDZ but it did NOT work (always said there was connection error)
- I tried using lgg3rootdotcom's method to reset the phone back to STOCK ROM without root and followed their instructions to the letter (set COM to 41 etc)
- I did everything, but then it keeps coming up with an error on LG Flash Tool (at 6%)
- It repeats "LAF : Bin_User_Mode" three (3) times whereas in the instructional video it only showed ""LAF : Bin_User_Mode" once (1)
- Then "[ERROR] : Partition Change factory Partition (Phone!=tot)"
(I want to share images but I can't because I am a new member with restrictions, I will post images later today)
- I downloaded the .tot and .dll from lgg3rootcom's website
- I tried D855 Europe, Hongkong, and Taiwan .tot but NONE worked
- Now my phone ONLY boots into Download mode :crying:
- I cannot get into Recovery mode or Normal boot...
- I REALLY just want to get it back to stock right now... Please HELP!
Any help will be much appreciated! Thanks in advance!

I used exact instructions from this thread: http://forum.xda-developers.com/showthread.php?t=2772199
But it ERROR appears at 6% with "[ERROR] : Partition Change factory Partition (Phone!=tot)"

Also, please ask any questions if you want to know more so you can help me..

{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

[Recovery] Flashing TWRP - issue solved

Good morning all.
I've a problem during the flashing of TWRP.img
- adb-Driver installed
- Mi A2 lite booted into fastboot
- computer and phone can't connect
- phone aborted the fastboot mode after some minutes
Phone Mi A2 lite latest Stock ROM
Computer windows 11 pro

Code:
C:\Users\Username>fastboot boot "D:\Username\Downloads\twrp-3.5.2_9-2-daisy-unofficial.img"
downloading 'boot.img'...
OKAY [ 0.643s]
booting...
FAILED (remote: unlock device to use this command)
finished. total time: 0.665s

Have you enabled bootloader unlocking in developer options?

Tech0308 said:
Have you enabled bootloader unlocking in developer options?
Click to expand...
Click to collapse
OEM Unlock
(Allow bootloader unlock)
yes, i did

{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

And then run fastboot flashing unlock?
It'll erase your data unless you keep volume down button held while running this command

Tech0308 said:
And then run fastboot flashing unlock?
It'll erase your data unless you keep volume down button held while running this command
Click to expand...
Click to collapse
this command doesn't work, i'll get the output of all aviable commands, that's all

Ahh sorry I meant fastboot oem unlock here's the link to a guide, use the first half for what you want, the instructions are valid and still work
Thread '[GUIDE] How to enable Camera2 API persistently and keep bootloader locked' https://forum.xda-developers.com/t/guide-how-to-enable-camera2-api-persistently-and-keep-bootloader-locked.3851414/

Tech0308 said:
Ahh sorry I meant fastboot oem unlock here's the link to a guide, use the first half for what you want, the instructions are valid and still work
Thread '[GUIDE] How to enable Camera2 API persistently and keep bootloader locked' https://forum.xda-developers.com/t/guide-how-to-enable-camera2-api-persistently-and-keep-bootloader-locked.3851414/
Click to expand...
Click to collapse
thank you, that's it