Develop Bugs

LINUX: phone not connected

Phone will not connect. I am using Linux Ubuntu and I cannot figure out why. I can detect on a windows computer but am new to Linux and am trying to install CWM.....
here is what is says
Original one clcik made by joeykrim and one click installer made by noobnl and firon
busybox by skeeterslint
Press any key to continue...Starting adb server
* daemon not running. starting it now on port 5037 *
* daemon started successfully *
Phone is not connected. Press any key to continue.
I've searched and cannot find!!!!

When you get that message go ahead and unplug your phone from the usb cable and plug it in again. See if that helps.
Sent from my SPH-D700 using XDA App

thanks, but I have tried that multiple times... enough to the point of frustration where I would unplug, plug in, hit enter, (phone not connected)...Repeat x100 haha
Anything else???

Solved:
Figured it out.. just needed root access with the command:
sudo ./run.sh
took 2 times first time failed installation and then the second time it installed....

[Q] Failed first rooting, help please!

I'm sorry if this has been asked before. I tried rooting my phone and this appeared:
Starting ADB server...
* daemon not running. starting it now on port 5037 *
* daemon started successfully *
Checking MTD configuration...
Phone uses the old block size.
Firmware version '3.70.651.1'
Battery is at 100 percent.
The ADB Shell does not have root permissions.
Installing exploit...
Rooting...
Looking for Root...
Got Root!
Checking for needed files...
Pushing res\flash_image to /data/local/flash_image...
Flashing misc partition...
Rebooting in to bootloader...
Verifying bootloader status...
Bootloader shows Firmware Version '1.17.651.1'
hbootpreupdate set at '11'
Verified the phone has the older MTD setup with hBoot Version '2.10.0001'
Verified NAND is locked.
Setting RUU mode...
*
* Flashing Firmware...
*
* It is very important that you do not interrupt this while flashing.
* Unplugging or turning the phone off while it is flashing can easily brick
* your phone.
*
Rebooting...
Waiting for the phone...
error: protocol fault (no status)
** daemon still not runningerror: cannot connect to daemon
** daemon still not runningerror: cannot connect to daemon
** daemon still not runningerror: cannot connect to daemon
Giving the phone time to configure itself...
Rebooting into the recovery...
Waiting for the phone...
** daemon still not runningerror: cannot connect to daemon
** daemon still not runningerror: cannot connect to daemon
** daemon still not runningerror: cannot connect to daemon
** daemon still not runningerror: cannot connect to daemon
** daemon still not runningerror: cannot connect to daemon
It failed and red exclamation mark screen appeared... I tried restarting and after the 3rd try, it worked. I was just wondering if I could try to root again and not brick the phone? I did it once and I'm a bit paranoic... Thank you in advance!

i would use unrevoked.
1. uninstall antivirus, where is my droid, or any app like that from your phone, make sure you have a full battery, if your phone screen is set to time out, change that to never or after 30 minutes(you change that in display settings), make sure you have usb debuging on(settings, apps,manage), uninstall or turn off your computer antivirus
2. download unrevoked
3. install usb/adb drivers from unrevoked site, go to more info on the site and download drivers, then extract to an easy to access folder
4. boot phone into bootloader and select usb at the bottom of the options, then plug to computer and your phone screen should read usb plug, it will try to install driver, select manually on your computer and look for the folder you just extracted.
5. install htc sync on computer and then uninstall it(you only install it for the drivers, but if you dont uninstall it you wont root)
6. right click on unrevoked file on your computer and run as administrator, follow instructions if any and your done.
hope it helps

Honestly had similar problem. Check to see if you have the HTC drivers installed properly. Also apps like PDA NET and other similar drivers can sometimes cause issues. My problem was my USB CORD. It was not connecting properly to my laptop (Toshiba). I went to Sprint store and got a new one. I ran the root program again and it worked fine. This might not be your problem however so, I only rooted a month and a half ago so maybe someone with more experience has more insight, but my USB cable was stock from 2 years ago and was kinda beaten up. Hope you find your answer tho
Sent from my PC36100 using Tapatalk

I just noticed that I get the red exclamation mark when I try to boot recovery. If I follow those steps, it won't mess up Recovery any further?
Sent from my PC36100 using XDA Premium App

Matafeka said:
I just noticed that I get the red exclamation mark when I try to boot recovery. If I follow those steps, it won't mess up Recovery any further?
Sent from my PC36100 using XDA Premium App
Click to expand...
Click to collapse
That just means that you don't have a recovery. You can't mess up a non-existent recovery, and even if you could, it's easy to flash a new one.
EDIT: Run unrevoked, it'll flash ClockworkMod Recovery for you and should fully root you. If you then want to flash Amon Ra, you can do so via Rom Manager or you can flash a PC36IMG of Amon Ra through the bootloader.
(from... Evo/MIUI/Tapatalk)

Thanks for all the help guys, got it working!!!

[Q] USB MTP & Charging Problems

Hi All,
I have run into a problem with my n7105 and I can't work out if it is hardware or software and I have no idea where to go from here.
If you have time please have a read below.
The following is what happens with the phone when I plug it in to USB:
* The phone usually indicates it is charging or takes up to 5min to register as charging and make the connecting sound
* It does not show up in windows as a MTP device
* Won't allow me to tether to the PC from the android settings menu (It says usb not connected)
However:
* USB OTG works fine, I can use a USB stick in OTG mode.
* HDMI Out works and it detects and charges the phone immediately.
* Download mode connects right away and I can flash in ODIN
* When connecting the phone to the wall charger it takes a few min to begin charging, even when switched off.
Another note:
The phone has been dropped about a week ago and damaged the screen near the home button but USB has been working ok until today.
I have done / tried:
* A Factory Reset in recovery
* Flashed the full original stock ROM in ODIN + factory reset
* A different PC
* Remove / Re-install drivers
* A new USB cable
All this and no luck.
Any other ideas? or should I just pay up and send it to a repair centre?
Thanks for any help.

[Help] unbrick, Install rom from ADB

Hello guys, I need a lot of help from you guys
Today was changing the rom on my lg e977, but when I was formatting inadvertently deleted the sdcard also. I can access the fastboot and CWM with all the drivers installed, but when I access via adb I get the message
"* Daemon not running. Starting it now on port 5037 *
ADB server did not ACK
* failed to start daemon *
error: can not connect to daemon "
I believe I'm getting this message, because I believe that usb debugging was not enabled.
Anyone know what I can do?

now i'm getting the message:
error: device unauthorized. Please check the confirmation dialog on your device
but i cant boot the phone, so i need to enable usb debugging via adb, right?

Solved! Used this steps:
1 Make sure you have LG United Drivers already installed, otherwise download from below
2 Download Lg suport tool
3 Put your Optimus G into Download Mode by switching it off, attaching the usb cable to the phone, holding both the up and down volume buttons at the same time and lastly inserting the usb cable into the computer; wait for the drivers to finish loading if doing it for the first time.
4 when your phones conect to pc suport tool then go to software update
5 Click check in the first option. the program will close and a new one will open,wait for the flash process to finish.
6 you must have a internet conection, the whole process takes an hour or less. the phone will reboot when finish.
Sent from my LG-E975 using xda premium

[Q] Having Trouble Rooting my LG Optims E973

Hi
I am trying to root my LG Optimus G E973 (Bell is my carrier)
I followed the instructions exactly as how it is listed here
http://forum.xda-developers.com/showthread.php?t=2181103
But I got stuck when I ran the root package. And the message I keep on getting is
[*] Waiting for device...
* daemon not running. starting it now on port 5037 *
* daemon started successfully *
Any ideas on how I can resolve this?

debugging should be enabled
should be on charge only when you plug in
when prompt put it on mtp, if that fails put it on software mode, it will work