On the bottom left of the motherboard in this picture:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
What is that small silver block for, and what do I use to reattach it? Solder?
Thanks!
ok, after more research (thanks to the repair manual which I've attached) I've figured out what this component is called, but still no idea what it is for. Looks like there are 2 of these, one on each side of the motherboard, so if it's not necessary I can live without it.
Component is called "Filter 0.0 Hz 0402", what is that for?
The manual also says to remove/mount using Hot Air, but this is territory I don't have experience with. Do I need some kind of glue/paste to spread before using a heat gun to remount it?
Err I think it's a microphone.
Ok, yeah, I have figured out it's a microphone, and it seems to be the primary one facing in (positioned in the spot where your mouth would be when you talk on the phone), with the secondary facing out for when recording video...
Which brings up the question, how do I mount it? I'm being told that the for "pegs" of the microphone need to remain separately attached to the MB, so some glue wouldn't work since that would make it one big connection like a heatsink. Any ideas?
Related
Hello,
Yesterday I replaced my MB of my HTC so I needed to disassemble the P3300.
After replacing the MB, I reassembled the P3300 but now I see I have forgotten something. Can someone tell me where I must put the plastic? (right on the photo, left is just to show the size of the plastic)...
Thanx
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I don't see the part as a replaceable component on page 61 of the manual:
http://mikechannon.net/PDF Manuals/HTC Artemis Service Manual.pdf
That does not prove anything though.
I wonder if it has snapped off the casing somewhere? Any sign of a snapped off edge on the part?
Mike
no nothing, When I removed the backpanel it came out...
It looks a little similar to the piece mentioned here:
http://forum.xda-developers.com/showthread.php?t=474911
(Yes, I know it's a different phone, but it might have a similar purpose/location)
Just a thought
Mike
im guessing you will have put it back together now but it boes at the bottom of the back casing directly opposite from the little vibration module, i think it is a redundant bit of plastic
No no, you have to put this plastic inside to housing on place, where is stylus insertion hole. Without this plastic, when you put stylus to artemis, the tip will be inserted frequently inside the Artemis, not to stylus tube
and not just the front facing cam i mean that entire assembly complete including digitizer,lcd screen and what ever else is in there
Uploaded with ImageShack.us
I take it you cracked yours?
We just call it the "screen". It's the LCD with digitizer pre-fitted. Earpiece speaker and front cam are not included, you'll have to transfer them from the old screen to the new one.
any idea where i can get one? anything i search for i only get lcd screens and digitizers. i bought 2 digitizers for $45 dollars before i realized replacing one was probably above my ability
http://www.durapowerglobal.com/HTC-Evo-4G-Parts_c_203.html?gclid=CP2supzaj6gCFcm8Kgod9X6sEA
cool so i found them on that site. only problem is how do i know if i have a wide cable or not. its not to easy to distinguish from the pictures ive found. i have hardware v.0003 and im not opposed to opening up my phone to see but i need to know what to look for.
Arnezie said:
http://www.durapowerglobal.com/HTC-Evo-4G-Parts_c_203.html?gclid=CP2supzaj6gCFcm8Kgod9X6sEA
Click to expand...
Click to collapse
That I'm not sure about??
bumping this if anyone knows how to determine a small cable from a wide cable
http://www.ifixit.com/Teardown/HTC-Evo-4G-Teardown/2979/1
you have to open it, it's the cable nearest the charging port. if the bottom two are about the same size then you have the big one. hope that helps
edit:
also the smaller ribbon has the connection a little further into the board where as the big one you'll see it right on the edge of the board
ok cool so from what i remember when i did open it i would have the wide one
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
maybe this will help
This is the only part, the entire ribbon cable connecting the buttons and either the sim or SD card slot(not sure which is which) to the motherboard, that is not shown in any guides I've found on how to replace it.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
It looks to me like you might have to fish the whole thing through the opening for the card slot but I just wanted to double check. Anyone?
Never mind. I was right. You gotta peel back the foam tape on back back to reveal the SD card slot, which turns out as you can see connected to another part, some sensor in the front I guess related to the front cam. You gotta carefully pry it upwards as it's glued down. thin razor blade. Idk, at this point I barely know what I'm looking at lol. This phone is the worst to dig into. Get yourself some near sighted glasses or something. Recently learned this phone has the worst score for repair ability. I do confirm this. Good luck if you're planning on replacing anything in here.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
The screen has cracked for a very long time but still functional. Just now, it fell once again and then a white-ish thin line appeared at the very right corner, but I ignored it as it does not disturbed me. Few hours later, I think i put a little pressure into this pressure (But I'm pretty sure i am not, because my the only thing i did was to put it inside of my jeans pocket) and poof! Half of the screen cannot be seen clearly (refer picture). But still could function as in I could still use the touch screen mode at the affected area. Could this lcd screen problem be saved without replacing the lcd with a new one? Replacing it is my last resort if I could save it DIY. Help me, thanks!
Yeah, sure, via a software update. That'll also give you wireless charging, but only if you charge the phone inside the microwave.
You've cracked the screen! What sort of DIY fix you assume can exist, besides replacing it?
tired of cheap ebay screens, what replacement screen do yall recommend?
OnePlus RMA. It isn't overly expensive.
From memory, it was around £90 for me.
I have a very little Slot over my first Headspeaker near the Camera. There is some dirt and i dont know if other has the same Problems.
I got my Phone around 2 Weeks and for that Price that is a shame.
I attached Photos where you can see it.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Google Support says its normal.
The gap shown in the picture shouldn't be there.
Best Joke ever: Google Support says its normal.
I agree, that gap should not be there. Not on mine. Call them back, tell them you went to Best buy or a VZ store to compare and you have this big gap that they don't.
You said you just got it, return it to where you bought it so you don't get stuck with a refurbished from Google..... assuming you bought it new.
Reading the chat history in the picture, the employee might think of the speaker cutout. You could try to highlight the gap in some color.
This slot is normal, try gently using a clean soft bristle toothbrush to sweep it out. That's what I do. Works great for the speaker grills and charging port as well!
You are right but this was the Beginning of the Chat. They know now what i mean but says the Photos are not enough and want a Video or more Photos.