I wanted to update my phone from CM9.1 to CM10 and wanted to back it up first. The first backup never went past "clearing space..." so I cleaned out all of my old ROMs and a couple of backups. Then I thought, maybe I don't have the latest version of recovery, so I reflashed Touch recovery. Then I hit the "reboot into recovery" in ROM manager. The phone vibrated and "Samsung" boot animation appeared very briefly....then nothing. I tried pulling the battery and then holding going directly into recovery with the volume buttons and power and it would just vibrate and show the opening samsung boot screen. After trying that a few times, now all I get is the vibration.
Today I tried the "soft brick" solution, but all it does is vibrate every alf second.
So am I bricked?
Your are soft bricked.
Take battery out for ten seconds
Insert back in hold volume keys press power
Let go while continuing holding volume key. Some people hold volume keys and power continuously but that doesn't always gets it.... g luck
Sent from my SGH-T989 using xda premium
To enter recovery, your timing during the phone vibration has to be somewhat perfectly timed.
Power up and keep one finger in the middle of the volume control so both volume controls are pressed simultaneously with one finger on the power button. When the phone vibrates one time, remove finger holding the power button while still holding the volume buttons until recovery appears.
Good luck OP.
When I do this, all I get is a black screen after the initial Samsung boot screen. Am I supposed to follow the instructions on the soft brick thread? Or just do this over and over until something else happens?
Good news guys. I used the soft brick instructions and loaded recovery through odin and it booted up into CM9 on its own! Thanks for the help!
Estimated Prophet Hawk said:
When I do this, all I get is a black screen after the initial Samsung boot screen. Am I supposed to follow the instructions on the soft brick thread? Or just do this over and over until something else happens?
Click to expand...
Click to collapse
Have you tried holding volume up and down at same time while holding in power button at the same time plugging in the power cord this will get you to download mode so you can use odin to flash new rom if possible. Or just turn power on while holding down volume button while it powers up this will get you to download mode without the power cord also.
Sent from my SGH-T989 using Tapatalk
Related
I am having a hard time booting into CWM, what is the right key combination? If I hold volume down and power, the Samsung sign comes on, and then the screen goes black and the phone vibrates every few seconds. I'm able to get into CWM just fine in ROM manager reboot and also with Juggernauts reboot, but it could become necessary to do it manually at some point. Thanks.
CWM boot
Need to hold volume up &down plus power keys when U see Samsung sing let power go holding up&down key till U see CWM
Working perfect, thank you!
So I messed up...
I flashed the new JB, rooted, and unlocked it(FreeGee) and it was working decently. For some reason (that I can't remember now), I had to go back to ZV7 using LGNPST. When I reupdated to ZVB, I think I forgot to unlock with FreeGee and debloated. (at this point, you're thinking "this guy is a complete idiot") After my next restart, I got the dreaded "security error" bootloop.
I didn't panic yet. I went ahead and tried to downdate to ZV7 again using LGNPST. At 85%, the phone rebooted as normal but after the boot screen, it froze showing the "4GLTE" screen at the end of the animation. I tried waiting it out but no luck.
When I tried downdating again, I'm getting the same boot screen freeze. Worst part is I can't access recovery; the phone just restarts and goes through the boot animation.
So now, I'm panicking. Anyone else encountered this problem and/or can enlighten me please?
Go to recovery and factory reset the phone.
Sent from my LG-LS970 using xda premium
kc_exactly said:
Go to recovery and factory reset the phone.
Sent from my LG-LS970 using xda premium
Click to expand...
Click to collapse
I tried accessing the recovery (Vol up + power?) but it just starts the boot animation. Is there any other way to access it? Also, because I used LGNPST, it should open the stock recovery, right?
Power button 45 seconds
Hold the power button down for about 45 seconds. This will truly turn off the phone.
Access recovery using Vol. Up and Power buttons, then factory reset, and reboot.
You will be good to go.
scottyrick said:
Hold the power button down for about 45 seconds. This will truly turn off the phone.
Access recovery using Vol. Up and Power buttons, then factory reset, and reboot.
You will be good to go.
Click to expand...
Click to collapse
No luck :crying:
As soon as I hit the two button combo, I get the red LG globe logo pop up for a second.
If I release as soon as I see the logo, it goes to the boot animation
If I continue to hold the buttons (and wait for the the blind menu on the bottom left), the screen remains black and nothing comes on...even after holding the buttons for 45-60 secs.
arsh89 said:
No luck :crying:
As soon as I hit the two button combo, I get the red LG globe logo pop up for a second.
If I release as soon as I see the logo, it goes to the boot animation
If I continue to hold the buttons (and wait for the the blind menu on the bottom left), the screen remains black and nothing comes on...even after holding the buttons for 45-60 secs.
Click to expand...
Click to collapse
hold the vol down+home button+ power at the same time til captive lights flash once and let got. now youre in stock recovery!
javskies said:
hold the vol down+home button+ power at the same time til captive lights flash once and let got. now youre in stock recovery!
Click to expand...
Click to collapse
HOT DIGGGGIITTYYY!
It worked! Thank you so much!
I couldn't get into recovery last night either.
This is the simplest way, methinks (from command prompt with adb.exe in same folder):
adb reboot recovery
I am not a total noob. I have always done my research and I am well versed with the procedures but this has me stumped. About six months before I had installed Omega ROM (told you i wasn't a noob) and things were fine and dandy. I was running today and bam! my phone just enters into a bootloop (lost my data on endomondo too). But hey! I am an expert right? or so i think to myself and I try getting into the recovery mode / download mode. I press the volume down, power and home button. The warning comes up and all that i have to do now is to press the volume up key right? wrong!! Inspite of pressing the volume up key the bootloop continues. I dont know what i am doing wrong. I am sure it is a really silly thing but i am not able to figure it out myself. I read the posts and all of them deal with other issues. Can someone help me?
Can someone check this up for me? Switch off your phone and try going into the recovery mode by pressing only the vol. down button and the home button pressed together. If it does not show the warning screen prior to the recovery mode then it would mean that my power button is malfunctioning. It would take just two minutes of your time. Please post your results here. Please.
If you press just the volume down and home button not a lot happens not the warning screen anyway. When I boot into recovery I have to wait for the Samsung logo to appear twice or it just reboots. Might be worth pressing all 3 buttons and wait for the 3rd restart before letting go
Edit
It's volume up home and power for recovery if you get download mode and volume up the phone just reboots hence why you go back to bootloop
Sent from my GT-N7105 using Tapatalk
The problem is solved. It turned out that it was not a boot loop after all. The power button got pressed and was stuck in that state thus causing repeated reboots. It was by pressing the volume down and home button without pressing the power button that i figured out that the power button was stuck. So i took out the screws and adjusted the band slightly and now alls well.
OK no power button on the motherboard
So I cannot push vol up power and home
Any ideas please and thank you
And my phone wilnot turn on it gets stuck at the logo screen so I cannot install any drivers
How do you turn it on with no power button?
When it first starts to boot, immediately hold home and volume up and it should boot recovery.
tried
DocHoliday77 said:
How do you turn it on with no power button?
When it first starts to boot, immediately hold home and volume up and it should boot recovery.
Click to expand...
Click to collapse
OK it just vibrates and stays black and vibrates every few seconds till I'll I let go that it stays black
Try the same but volume down instead. If this works you can odin flash the stock firmware. Sounds like something may have been corrupted.
First off, I'll openly admit I'm an idiot and missed the bit about needing to update the bootloader on my T800 and now my tablet won't do anything other than sit at the Samsung boot screen.
I've tried doing the power button + volume down + home button key sequence but it just reboots. Same thing about switching to volume up after it goes dark. I'm not sure if I just haven't gotten the sequence down properly or if it's just a lost cause at this point. Does anyone have any suggestions?
If you've held the power button, vol down and home button simultaneusly the device should boot to download mode. At that point you would select volume up to enter the mode. Are you sure you are holding these long enough and that the device is not plugged in?
If you are on a 7.x.x. rom then you may be having the same problem as me. If you came from the Samsung 6.0.1 rom then you already have the right boot loader.
Plug in charger and then power button all you need to do is stop the boot loop so you can get it in to the mode you need......
stinka318 said:
Plug in charger and then power button all you need to do is stop the boot loop so you can get it in to the mode you need......
Click to expand...
Click to collapse
Thanks, stinka318. Right now, it's stuck in the Samsung Galaxy Tab S boot screen and will sit there until the battery runs out. Are you saying plug it into power right now and hit the power button or do I need to let the battery completely die then plug it back in so it's powered off to start with?
Thanks for the help!
mach281 said:
If you've held the power button, vol down and home button simultaneusly the device should boot to download mode. At that point you would select volume up to enter the mode. Are you sure you are holding these long enough and that the device is not plugged in?
If you are on a 7.x.x. rom then you may be having the same problem as me. If you came from the Samsung 6.0.1 rom then you already have the right boot loader.
Click to expand...
Click to collapse
If I hold the power button, vol down and home button down simultaneously, it will reboot the device but then go back to the Samsung Galaxy Tab S boot screen. I've tried holding that down until my fingers go numb (how long have you had to hold it down for?). I've also tried letting go of the vol down and moving it to vol up once the screen goes black then releasing the power button when the Samsung screen comes up but that doesn't do anything either. Everything that I've ever tried just ends up showing the Samsung screen. So frustrating!
Thanks for the help!
[/I]
barenal said:
Thanks, stinka318. Right now, it's stuck in the Samsung Galaxy Tab S boot screen and will sit there until the battery runs out. Are you saying plug it into power right now and hit the power button or do I need to let the battery completely die then plug it back in so it's powered off to start with?
Thanks for the help!
Click to expand...
Click to collapse
Yep plug it in now and hit the power button it will show the battery charging icon from that you should be able to do thing you need to recover it.
boot into download mode (was mentioned how to do it on this thread already), go to ODIN, flash the bootloader, boot into twrp, wipe everything (to be safe), and flash your desired rom