what is the default governor for note 2?
Related
i have on my phone these governors :
wheatley - smartassV2 - intellidemand - badass - sakuractive - interactive - conservative - ondemand - userspace - powersave - performance
and i have the following i/o schedulers :
noop - deadline - row - cfq - sio - vr
please can someone tell me what are the best for performance and the best for battery
Smartassv2 + ROW or SIO
Good battery life and optimal performance
Any advice please on what settings are worth adjusting on the app? Mainly the CPU settings including the Governor, Min/Max frequency, I/O Scheduler?
Hi Guys!!!
Please help me editing performance profiles..
Everytime i edit the
1. Power save
2. Balanced
3. Performance
profiles through performance setting above the developer options it gets reset to default. My settings dont save.
Presently im on CM11 RC20...
and i have read about the touch boost(the min and max frequency are same)
so everytime i set max and min value. The min value changes and goes equal to max value.
Can i change this behaviour. Because due to this the frequency getting stick to only max(which i set) and its not going down.
Please help me in editing(min and max values plus governor) these profiles to my choice and save them for permanent.
Thank you in advance.
Just tick the option of 'Set on Boot' and reboot.
Thank you for your reply...
I want to change all the profiles to my choice.
Like i want the below.
1. Balanced profile - from 300mhz to 998mhz governor- ondemand
2. Power Save profile - from 300mhz to 600mhz governor - powersave
3. Performance profile - from 300mhz to 1497mhz governor - ondemand
By setting on boot it is going to default. I want to manual edit them.
Which custom settings do you use? Mine was laggy on interactive so I set it to on demand and input boost and now its usable.
Dear Community,
Can someone describe the direct actions and settings changed (or point me to the right direction) when someone changes the battery saver menu's performance profiles in LineageOS? I tried to set the slider to every position (from battery saving to performance, every step) and then checked the CPU governor and other settings in Kernel Adiutor/EX Kernel Manager but I don't see any change in the parameters (frequencies or timers, et cetera) but I am really curious what are the profile settings changing in the operating system level.
Thank you.
Desperate bump..
Power save
Min: 300 MHz
Max: 1036 MHz
Governor: INTERACTIVE
I/O scheduler: ROW
Cores: 0 and 3 only
Efficiency
Min: 300 MHz
Max: 2460 MHz
Governor: INTERACTIVE
I/O scheduler: n/a (doesn't show in app)
Cores: 0 and 3 only
Balanced
Min: 300 MHz
Max: 2457 MHz
Governor: INTERACTIVE
I/O scheduler: ROW
Cores: 0 and 3 on, 1 and 2 hibernated till required
Quick
Min: 300 MHz
Max: 2460 MHz
Governor: INTERACTIVE
I/O scheduler: n/a (doesn't show in app)
Cores: 0, 2 and 3
Performance
Min: 2457 MHz
Max: 2457 MHz
Governor: INTERACTIVE
I/O scheduler: NOOP
Cores: 0, 1, 2, 3 all on
Source:
reddit.com/r/oneplus/comments/494dcy/pro_tip_use_efficiency_battery_mode/d0p9l9o/
Would be good to see this in the source code of my phone (Redmi Note 4 Snapdragon).