Hi,
I have got a galaxy w8150, everything is fine, but the center button doesn't work. It does click normally but has no effect at all.
I also can not boot into recovery mode because of this.
I have tried to update the firmware of the phone but had no luck because Kies freezes in the process (tried differnt recent versions of Kies even in Windows safe mode).
I did hard reset couple of times, it didn't help.
Could this be software fault? Is there any other way to update the firmware?
Thanks in advance
Related
I can`t get the phone in recovery mode.
Here is the issue:
Running Jedi mind trick rom three weeks. One day the phone restarted and got stuck in the boot screen.
The phone restarted and eventually keeps vibrating without display
After trying many times i did got in recovery mode so i could install the rom again (using darkside super wipe and then the rom). After one day it crashed again and again i installed an different rom which also crashed after several hours.
Now i can`t even get to download mode, Is this hardware related or do i need to use an usb jig to get this working again?
Does your phone screen turn on and at least show the Samsung logo? If not, and you said button combo presses do not work using a USB Jig will be your way to go to get back in to download mode.
By the way, did you flash the correct ROMs specifically for our phones? You shouldn't have experienced and crashes. Also, for the vibrating issue without the display, it had been mentioned that it could also be due to a stuck/dirty power button. If you can try, clean up around it.
FineTalent said:
Does your phone screen turn on and at least show the Samsung logo? If not, and you said button combo presses do not work using a USB Jig will be your way to go to get back in to download mode.
By the way, did you flash the correct ROMs specifically for our phones? You shouldn't have experienced and crashes. Also, for the vibrating issue without the display, it had been mentioned that it could also be due to a stuck/dirty power button. If you can try, clean up around it.
Click to expand...
Click to collapse
Yes it does show the samsung logo at starting up but after that it turns off with 1-2 seconds vibrating intervals.
I already cleaned the power button but without any satisfaction.
I did dropped the phone monday but not from a great heigth.
estimated: 1mtr above ground
Yes i did. I used the guides from galaxy2root.com
Well, if you were able to use a USB Jig to get into 'Download mode', get a stock ROM from here and flash it through Odin which is also included in the link. Good luck!
GT-N5100 After OTA 4.2.2 stuck in safe mode. I didn't expect problems from a stock update.
It was working perfectly yesterday. I have wiped it clean, no change.
Kies doesn't seem to offer anything that will recover it.
Does anyone have 4.1.2 for North America? It is the international version tablet.
The one strange thing is that the volume down button does not work now.
Baseband version: N5100XXCMJ2
Build Number: JDQ39.N5100XWCNA1
Any ideas?
Dulie said:
GT-N5100 After OTA 4.2.2 stuck in safe mode. I didn't expect problems from a stock update.
It was working perfectly yesterday. I have wiped it clean, no change.
Kies doesn't seem to offer anything that will recover it.
Does anyone have 4.1.2 for North America? It is the international version tablet.
The one strange thing is that the volume down button does not work now.
Baseband version: N5100XXCMJ2
Build Number: JDQ39.N5100XWCNA1
Any ideas?
Click to expand...
Click to collapse
Try volume up and hold until you see the Samsung on the screen. I use that to boot when hung with odd firmware issues arise.
You can try going into stock recovery holding down home, volume down and power key when powering up.
If you get the notice... you should be able to connect via USB to your computer and use Odin 3.7 and flash a compatible ROM for your device, if available. I don't have a 5100, so I am not able to assist in locating one for you. You should state what carrier your tablet is with. So others can assist with the right ROM.
gooberdude said:
Try volume up and hold until you see the Samsung on the screen. I use that to boot when hung with odd firmware issues arise.
You can try going into stock recovery holding down home, volume down and power key when powering up.
If you get the notice... you should be able to connect via USB to your computer and use Odin 3.7 and flash a compatible ROM for your device, if available. I don't have a 5100, so I am not able to assist in locating one for you. You should state what carrier your tablet is with. So others can assist with the right ROM.
Click to expand...
Click to collapse
T-mobile is my carrier. I tried the phone and text messages and they are not working, yet the mobile data is.
When I tried the home/voldwn/pwr I get the
Warning!
A custom os can cause critical problems in phone and installed applications.
If you want to download a custom os,press vol up key.
Otherwise, press the volume down key to cancel.
At this screen I can't press either button. Neither will do anything. I know the volup was just working.
I get different screens by either using the volup or voldwn. So this would indicate the vol buttons are fine as I knew yesterday.
I also was not wanting to do anything to void the warranty at this point since it is less than 1 month old.
OK, well then as long as it was an OTA and you did not root... I would take it back to T-mobile and ask for a replacement. They should be able to give you a replacement if they cannot reload the ROM and correct the issue.
gooberdude said:
OK, well then as long as it was an OTA and you did not root... I would take it back to T-mobile and ask for a replacement. They should be able to give you a replacement if they cannot reload the ROM and correct the issue.
Click to expand...
Click to collapse
Samsung said to stop by a best buy where the samsung store is inside and have them reflash it with a US carrier firmware.
That seemed like a good idea, but he was unable to get to his server where the firmware resides. He also made mension of the fact they have heard of this model having these issues. So he was unable to do anything after an hour of computer issues with reaching their internal site.
Stuck in "Safe Mode" Issue Corrected
:laugh:
The Samsung reps at my local BestBuy could not fix it. They said they could fix anything. Not this apparently.
I remember that sometimes after firmware loads need to be cleared out. So I found this procedure, which is part of a manual firmware update, and figured maybe it would clear the issue causing safe mode.
If Galaxy Note 8.0 N5100 stuck at booting animation after Step 10 then go to recovery mode (press and hold the Volume Up, Home and Power buttons together) and perform Wipe data/Factory Reset and Wipe Cache Partition task before selecting reboot system now function. In recovery mode use Volume keys to navigate between options and Power key to select the option. Please note, performing wiping task will erase your device internal memory data and not external SD card data.
YES, no more safe mode!!
Ok so, Galaxy note 2 Gt-n700.
One day randomly turns off (not rooted/flashed). Go to turn the device back on and it gets stuck in a boot loop on the first screen, keep rebooting till it ran out of battery.
tried to go into recovery mode Vol up +middle +power. Nothing.
Then tried the other one.. Vol down + middle + power
hit continue at the firmware install and get RPMB: INVALID RPMD Data
Now googling this comes across alot of advice for PIT files and ODIN. when i tried to "install" this it comes up with an error that i cannot remember at the moment on ODIN basically saying cant its broke.
I have now got the phone saying that there is a firmware update and to connect to KIES and do emergency recovery. The damn phone will not connect to KIES and i have reinstalled KIES and all the drivers 500 times. Tried all usb ports.
Now im about 5 minutes from throwing this phone off a wall.
Can anyone help.
Much helps needed.
What ROM did you use before that happened?
If you not on 4.3 bootloader, try to flash oldest stock, one file, firmware through odin.
iJaake said:
Ok so, Galaxy note 2 Gt-n700.
One day randomly turns off (not rooted/flashed). Go to turn the device back on and it gets stuck in a boot loop on the first screen, keep rebooting till it ran out of battery.
tried to go into recovery mode Vol up +middle +power. Nothing.
Then tried the other one.. Vol down + middle + power
hit continue at the firmware install and get RPMB: INVALID RPMD Data
Now googling this comes across alot of advice for PIT files and ODIN. when i tried to "install" this it comes up with an error that i cannot remember at the moment on ODIN basically saying cant its broke.
I have now got the phone saying that there is a firmware update and to connect to KIES and do emergency recovery. The damn phone will not connect to KIES and i have reinstalled KIES and all the drivers 500 times. Tried all usb ports.
Now im about 5 minutes from throwing this phone off a wall.
Can anyone help.
Much helps needed.
Click to expand...
Click to collapse
Is your phone still going in bootloops?Try to enter download mode by pressing volume down+home button without pressing power and see if still goes into download mode.If it does then your power button is faulty.Two scenarios to that either power button is stuck on "pressed" mode which you can resolve by taking out the cover and screws and pushing out the power button (look up youtube video) or worse the power button needs to be replaced totally.If power button is working fine try what the above user stated flash the previous working stock version or flash the latest 4.4.2 stock ROM and see if it bootloop is resolved.
im having the same problem how did you fixed it ??
Hey guys.A while back I wanted to install adfree so I rooted my e975.Sometime in August I updated the android to 4.4.2 and I think the phone got unrooted.But SuperSU was still installed and I wanted it removed.So I tried a factory reset (settings->backup&reset->factory reset data) but SuperSU was still there afterwards.
Then I thought I should flash the kdz.So I tried to get my phone into download mode (volume buttons pressed and then connect to pc) but the screen shows nothing.I also tried going into recovery (volume down+power button) but that doesn't appear to work either.
Does anyone have any idea what's wrong with my phone?Everything else is working fine so maybe I'm doing something wrong.
Sorry if something doesn't make sense, English isn't my first language.
No one has any ideas?
I think this may be a hardware problem so I should find a way to hide the fact that the phone got rooted in case I need to sent it back.Is there any way to remove SuperSU without flashing the kdz?
sir Impecable said:
Hey guys.A while back I wanted to install adfree so I rooted my e975.Sometime in August I updated the android to 4.4.2 and I think the phone got unrooted.But SuperSU was still installed and I wanted it removed.So I tried a factory reset (settings->backup&reset->factory reset data) but SuperSU was still there afterwards.
Then I thought I should flash the kdz.So I tried to get my phone into download mode (volume buttons pressed and then connect to pc) but the screen shows nothing.I also tried going into recovery (volume down+power button) but that doesn't appear to work either.
Does anyone have any idea what's wrong with my phone?Everything else is working fine so maybe I'm doing something wrong.
Sorry if something doesn't make sense, English isn't my first language.
Click to expand...
Click to collapse
just do a hard reset or press vol+ and connect to pc again or just check out drivers
brijen95 said:
just do a hard reset or press vol+ and connect to pc again or just check out drivers
Click to expand...
Click to collapse
Thanks for helping me brijen95.I just tried what you said and volume down+power key doesn't seem to work.The screen just stays black so I can't do a hard reset.Vol+ and connect to pc doesn't work either.The phone just starts charging after a few seconds.I also just reinstalled the drivers but it didn't change anything.
I had a hard time getting into download mode recently as well. What ended up working for me was holding the volume keys for about 10 seconds, then while still holding the buttons, plugging the usb cable into the phone.
No that didn't work either .
Is there any way to remove SuperSU?Keep in mind that my phone is not rooted anymore.
Edit: Well I just found out that the phone is entering download mode but not showing anything on the screen.I managed to flash the kdz with no issues.
I have a rooted I747 with an android 4.3 rom. The LCD is broken and I am looking to sell it as is. I am wondering if it is possible to factory reset the device with a PC (possibly with kies, odin, or adb). I have seen a kies tutorial but it bricks devices running android 4.3. Any input would be greatly appreciated, thanks in advance.
efaustus9 said:
I have a rooted I747 with an android 4.3 rom. The LCD is broken and I am looking to sell it as is. I am wondering if it is possible to factory reset the device with a PC (possibly with kies, odin, or adb). I have seen a kies tutorial but it bricks devices running android 4.3. Any input would be greatly appreciated, thanks in advance.
Click to expand...
Click to collapse
If the phone still has a stock recovery you can boot into it and factory reset the device. Getting into stock recovery and using it is all done with the volume rocker and power buttons, so the broken screen won't be a problem.
jason2678 said:
If the phone still has a stock recovery you can boot into it and factory reset the device. Getting into stock recovery and using it is all done with the volume rocker and power buttons, so the broken screen won't be a problem.
Click to expand...
Click to collapse
Thanks, I've found that method elsewhere;
Enter recovery by holding the volume up, home button and power button simultaneously while booting. Wait 20 seconds after first vibration. After 20 seconds push the volume down button three times, then press the power button, wait for vibration and reset should be complete.
I am still somewhat curious to know if it is possible to do it remotely with a PC.
Best method I can think of from a PC would be flash this with Odin: http://forum.xda-developers.com/showpost.php?p=52341560&postcount=227
Only flash that if you're sure you were on stock 4.3 with MJB firmware, or you'll brick. Did you have ADB enabled before the screen broke? It would give you a method to check firmware without the screen.
Sorry about the post above. You said broken LCD, but I heard broken digitizer. I thought you could still see what you were doing. I still think stock recovery could work in a pinch; just find a Youtube video and mimic it. Sounds like you've already got the button presses down. Good luck