Standby loop - Desire General

When trying to set my Desire into standby mode by pressing the power button it switches on the display again at once. Even trying some other ROMs doesn't fix the problem.
Does anyone know why and has a solution for this problem?

Your power button might be damaged. Look for a screen lock app on the playstore and use it to put your device to sleep instead of using the power button.
via xda app

Same with such an app. Display comes back again.
Volume button sems to be active too cause after display comes back sometimes the volume setting "sound " appears .

No idea or wrong category here?

Did you activate a "volume key wake" that enables volume keys to wake up the device ?
On my Desire these buttons can be a bit hard to push sometimes, maybe you have the opposite effect ?
Edit : such settings may be found in the "display" section of the settings tab

No, even several other Roms didnĀ“t fix the problem.
Also watched: the volume funktion seems to be active in background too cause after almost every "wake up" the ring volume setting is displayed for 1 second.
Seems to be a hardware problem but the Desire did not fall down or sth like that...

When choosing trackball or volume key for wakeup in the settings, the display always switches on and off. Power button still causes a hard reset.

Related

Backlight defaults to zero when restarting XDA IIs

Hi
My XDA IIs is wrking fine except that often when switching back on the backlight is minimised. When I adjust the backlight settings on battery it is OK, but then once again reverts to the slider being minimised upon restart.
The turn off backlight if device not used for is unchecked.
The turn on backlight when a button is pressed is checked.
The power setting is turn off device if not used for 2 minutes.
Any ideas.
Many thanks
Rod King
when you say "restart" are you poking the stylus in the reset hole or holding down the power button?
holding down the power button turns off the backlight, holding it down again, turns it back on
I have had this problem when I changed the backlight setting. Try going into the Backlight properties under the "Battery Power" tab. Place a check in "Turn on backlight when a button is pressed or the screen is tapped."
Then go to the "Button Lock" properties and choose "Lock all buttons except Power button" so that only the power button will wake your unit. If this don't solve it, then it may be a software you installed.
hope that helps..

Power button problem

Hi all,
My XDA IIs works well before. But few days ago the Power button doesnt work properly, it can turn on the phone, hold to turn off the back light, but I can't use it to turn my phone screen off like before. Anyone has same problem ?
Can you see any part of the screen? It might just be that the backlight adjustments are set too low when the unit isn't cradled. You might be able to see the screen in daylight.. or maybe it was inside your home. I forgot where I was at when it happened to me. In anycase, if you can see a bit of images on your screen, go into the Backlight properties and change the setting to your liking.
Good luck..
The problem is i can just press the power button to turn off my phone BEFORE (the screen is completly off), and NOW it doesnt work at all ! When my phone was off, I can press the Power button to turn it on, or when I hold it for few seconds the back light will be turned off, but press once to turn off. I dont know why, if somthing wrong with the Power button it should be doesnt work at all, that's mean i cannot turn on my phone as well. But other functions of the Power button are still work well, except the 'Turn off' :roll:
power off doesn't work anymore
I have the same problem here. I can't use the power button to power off my qtek 9090!!
i can use the power button to turn my pda on and to switch the background light on and off - so the "hardware side" of the power button is working.
however, i can't use the power button to turn off the device. it's very annoying, because i can't put it in my pocket after finishing a call :-(
this should be some sort of a software problem - so i hard resetted my device (a couple of times) - but that didn't help!
can anyone help?
thanks,
lorenz
the ba doesn't turn off it is always on staand by mode. ->settings -> system -> button lock
this will stop any missed call because when the ba is in standby the power button is the only one to work
power on is no problem. i can't put my BA into standby mode. if i press the power button while the BA is turned on, nothing will happen. the screen will stay on, the background light stays on.
i have no way to put it into stand-by with the power button!
try this and see if it works. it's a software app that wil rest, shut down, and turn the screen off. just copy it to your BA temp directory and install it.
power button problem
nemchua
Is your problem solved ?
Because I have the same problem.
Power of switch doesn't work !!!
Any help would be welcome.
power button problem
Does anyone solve the problem???
Had the same problem...
I had the same problem going on for about two weeks or so...never changed anything and it went away all by itself.
The problem has not come back now in over 4 months.
Sure would love to know what the problem was tho...
Greetings,
Noddy
Power Off does not work
Add my name to people with this problem.
The only event I can link it to is this: I deleted my Motorola Bluetooth headset and installed a Logitech headset. I noticed the problem (can't turn OFF with POWER BUTTON) soon after that.
same problem for me ..... someone must know !!!!
I think it is a hardware problem. The contact is not making cleanly. Disassemble and spray time, perhaps.
It's a standard push switch, easy enough to replace, I occasionally list themon ebay but any phone repairier should have them in stock.
Richard
i had same problem yesterday afternoon, but it is ok now. recovered by himself
Write again in two weeks and let us know if it is still healthy. In my case, anintermittent problem became continuous.
Can't turn the screen on after pressing power button
I have a problem with my Bell Atrix. After pressing power button to lock the screen, i can't wake up the screen up by pressing that button again. Could anyone tell me how to fix it pls.

Help - Volume up button brings me to home screen!!

Hi,
I have a AT&T Tilt2 on which suddenly the volume rocker up button stop working as volume button and then brings me to the home screen from within any app!! I am unable to figure out why this would happen - its a stock AT&T ROM with some apps that I installed like - OperaBeta, HDWallS, Resco.
Even when I hold down the call drop button for sometime, the device does not lock! It vibrates but does nothing - just shows me the home screen.
Any idea on why this would happen ? has anyone seen this happen to their cell too ?
Thanks
Dhanvi
My volume buttons occasionally acts up too. They suddenly act as up and down keys rather than volume up and down keys. Very rarely though. A soft reset makes it go away each time.
...guess it was having an identity crisis...
I've been having problems with my volume buttons. And soft reseting doesn't solve the problem. The volume buttons work in the lock screen. But when i'm at the home screen they just open and close the volume screen.
I have a tilt 2 with the stock rom.

[Q] Home button wake vs. power button

so it seems i can wake the phone with either the home button or the power button. thats all good. the problem is when im using poweramp with its lockscreen enabled. if i wake the phone with the power button, the poweramp lockscreen immediately appears. if i wake the phone with the home button, i get the normal lockscreen and then after a couple seconds, the poweramp lockscreen appears. i cant find any settings anywhere that would possibly treat home button wake differently than power button wake. anyone else notice this or know of a setting somewhere im maybe missing?

[APP]Ringer Mode Lock - Android 4.2 volume buttons fix

This application blocks the ringer mode to avoid changing the mode when the phone is locked (screen on)
this is a workaround for the following strange behavior / bug on stock android 4.2+:
Note: my phone uses a pattern to unlock screen.
- Steps to reproduce the problem.
1.Lock the phone, and light the screen with power button.
2.Long press power button until the power off menu appears.
3.Press the power button to close the screen.
- What happened.
4.After that, every time the screen is lighted (but not unlocked), press the volume keys can change the volume though no music is playing at all.
The volume keys keep working each time I turn on the screen without unlocking, and it is back to normal when I unlock the phone use the unlock pattern and lock again.
- What you think the correct behavior should be.
The volume keys should not work at all when the phone is showing lock screen, it has accidentally muted my phone and led to missed calls. This is worse than power off menu it self. Since power off menu only appears with long press, but when ever the menu appears once, the volume keys work every time until I re-lock the phone.
And also I don't think the power off menu should appear by long pressing during locking state, since it is quite possible that the power button can be long pressed even in my pocket during taking the phone in or out.
P.S. When the phone is rebooted and went into lock screen the first time, the volume keys will work on lock screen without the necessity of showing the power-off menu.
- Device
GSM Galaxy Nexus (yakju)
Unrooted Android 4.2 (factory image)
https://code.google.com/p/android/issues/detail?id=39828
https://code.google.com/p/android/issues/detail?id=39706
https://code.google.com/p/android/issues/detail?id=40522
Click to expand...
Click to collapse
Play Store Link:
Ringer Mode Lock
added steps to reproduce the problem and fix same bug

Categories

Resources