I succesfully installed the Rcmix hd v6.0.0.1 but now I cant get into recovery. I get a white HTC screen when I try enter it. Anything else works fine :S
Download ROM Manager from the market, and reflash it from there.
i tried it but no, i reverted it back to .5 and it works now but idk
Press vol-down and power. Keep them pressed until eng hboot prompts in. Select "boot recovery"
alienmind said:
Press vol-down and power. Keep them pressed until eng hboot prompts in. Select "boot recovery"
Click to expand...
Click to collapse
You shouldn't need to keep them pressed. For me I just hold vol- and as soon as I've pressed the power button (and it's obvious it is powering on - normally instant) I let go.
Just as a by-the-by comment, being someone that looks at a lot of posts I see more issues with RCMix ROM than any other especially about recovery or flashing (even taking into account the popularity or it).
After many attempts at fixing the problems with my phone, I finally decided to give up and call Verizon. They are sending me a Dinc 2 as a replacement, and I will use this until I can afford a newer 4G phone. Question is, how do I get the phone back to stock, so that when they get this phone back to their processing center, they don't call me up and tell me that I have to pay for the phone, or otherwise?
Thanks for any help in advance!
First you need to go to the unrevoked website and download and flash the s-on patch thru clockwork recovery. Then download the PB31IMG.zip ruu from here (http://pvillecomp.com/?page_id=22) place it on your sdcard in no folders and then pull the battery. Replace the battery and hold the volume down button and power button untill a white screen appears. Wait a couple of seconds and it should find the PB31ING.zip and prompt you to press vol up to start the update. Do so and when its finished press vol up again and the phone will reboot. Then pull the battery again and replace it and hold vol down and power. Once the screen comes up it will find the file again but this time select no (vol down) and then select no again when prompted to reboot. Then use vol keys to select factory reset and the power button to select. Once thats done you are compleet stock again.
so reason, i'm delete file build.prop. my phone is hard brick. i press power + volume up it turn on logo htc and off. i press power + volume down. nothing happen and when i charge baterry. no charge. help me
Kent21 said:
so reason, i'm delete file build.prop. my phone is hard brick. i press power + volume up it turn on logo htc and off. i press power + volume down. nothing happen and when i charge baterry. no charge. help me
Click to expand...
Click to collapse
1. Unplug phone - VERY important
2. power on phone, doesn't matter if it is boot looping or whatever
3. hold vol up and power EXACTLY 10 seconds
4. let go of both
5. hold vol down and power till boot loader comes up.
You have no charge because you are running an old ver of twrp, get 2.7.1.0
an0ther said:
1. Unplug phone - VERY important
2. power on phone, doesn't matter if it is boot looping or whatever
3. hold vol up and power EXACTLY 10 seconds
4. let go of both
5. hold vol down and power till boot loader comes up.
You have no charge because you are running an old ver of twrp, get 2.7.1.0
Click to expand...
Click to collapse
hold vol up and power EXACTLY 10 seconds
tks for your help. i'm press 30s. my phone is rescure
Share how I fixed my HTC M8 with the same problem.
Hi,
I just want to share how I fixed my HTC M8 with the same issue. The method is the same but a bit different. I found the solution from googling the below link:
http://forum.xda-developers.com/htc...ter-download-mode-t2853100/page2#post62490577
The essential method is to keep holding down the power button and don't let it go while pressing on the volume up button to reset. At the very moment before the phone resets and shows the HTC logo white screen, switch from pressing the volume up button to the volume down button while holding down the power button. Or you can count 10 seconds and switch before the screen resets.
I hope this helps other people with the same issue.
an0ther said:
1. Unplug phone - VERY important
2. power on phone, doesn't matter if it is boot looping or whatever
3. hold vol up and power EXACTLY 10 seconds
4. let go of both
5. hold vol down and power till boot loader comes up.
You have no charge because you are running an old ver of twrp, get 2.7.1.0
Click to expand...
Click to collapse
Thanks, the pwr + vol-up 10 seconds before the phone hard resets, them pwr + vol-down got me back into hboot and recovery and then out of a build.prop issue.
I have no idea why this is a thing: Getting into the boot loader is usually easy. I can't imagine why when the system doesn't boot normally that the standard procedure to enter hboot changes.
regardless of retarded engineering on qualcom or htc's part, thank you an0ther.
hello friends i have a Problem my htc one m8 stuck on White htc Screen i dont can boot in the bootloader menu what i can do now ? My dvice is rooted , unlocked and it have the trwp installed. When i press power + vol-down Buttons nothing Comes and the vol-down key works.
greets marvin
power + vol down doesn't work if the phone is already on (even "stuck" on the boot splash screen). That button combo only works when powered off, or during a reboot.
Do the following:
1) Hold power + vol up to force a reboot. You may need to hold the buttons for a minute or so, in the current "stuck" condition.
2) When the screen goes black to reboot, but before the HTC logo screen appears (you have about 3 seconds) let go of the power and vol up buttons, and only hold the vol down button. Do not let go until you see the bootloader screen.
3) If you fail to get into bootloader, it's always due to getting the timing wrong. You either started pressing vol down too late, or let go too early. Just repeat Steps 1 and 2 above, until you get it right.
I have TWRP installed, and have managed to run it a few times. Now I cannot start TWRP at all.
From off, if I switch on, the following happens:
1) Screen with Samsung Galaxy A70 - Secured by Knox
2) 0.5 seconds later another screen, "this phone's bootloader is unlocked and it software integrity. .." and "press power key to continue..."
3) 5 seconds later, same screen as (1)
4) 3 seconds later, red letters "this phone is not running Samsung's official software"
5) 3 seconds later blank screen with "samsung" and then booting to android.
In my experience I have to flash twrp every time I want to use it( I don't know the reason but I couldn't fix it ) , for booting twrp on the other hand I turn off the phone first, then I press power button+volume down until the "this phones bootloader..." screen appears, here is the tricky part, you have to quickly let go of these two buttons, press power button, let go of the power button (after the warning disappeared) and then press volume down button (and hold it) until twrp logo appears, this happens really fast so you may need to do it a few times to get used to it.
mobin22 said:
In my experience I have to flash twrp every time I want to use it( I don't know the reason but I couldn't fix it )
Click to expand...
Click to collapse
Yes, same here, the only time I have managed to run TWRP on this phone, is right after a flash.
mobin22 said:
and then press power down button
Click to expand...
Click to collapse
Do you mean volume down?
Zilliman said:
Yes, same here, the only time I have managed to run TWRP on this phone, is right after a flash.
Do you mean volume down?
Click to expand...
Click to collapse
Power off the device, plug into a pc, wait for it to start charge, hold vol up and power till it turns on. Wala boots to twrp. If you have magisk installed,you can use the reboot option within magisk.
mobin22 said:
In my experience I have to flash twrp every time I want to use it( I don't know the reason but I couldn't fix it ) , for booting twrp on the other hand I turn off the phone first, then I press power button+volume down until the "this phones bootloader..." screen appears, here is the tricky part, you have to quickly let go of these two buttons, press power button, let go of the power button (after the warning disappeared) and then press volume down button (and hold it) until twrp logo appears, this happens really fast so you may need to do it a few times to get used to it.
Click to expand...
Click to collapse
Samsung changed how to enter recovery on Android 11. Power off device, plug into pc, wait for it to charge, then hold vol up and power till it turns on. Alternatively, if you have magisk installed, use the reboot options within magisk.
I did that. Thanks!
But it has gone to:
Android Recovery
Samsung /a70qxx/a70q
11/RP1A.200720.012./A705FNXXUB5DVB3
user/release-keys
Use volume up/down and power.
Reboot system now
Reboot to bootloader
Apply update from ADB
Apply update from SD card
Wipe date/factory reset
...
...
...
Where is TWRP? It seems it's gone.
Zilliman said:
I did that. Thanks!
But it has gone to:
Android Recovery
Samsung /a70qxx/a70q
11/RP1A.200720.012./A705FNXXUB5DVB3
user/release-keys
Use volume up/down and power.
Reboot system now
Reboot to bootloader
Apply update from ADB
Apply update from SD card
Wipe date/factory reset
...
...
...
Where is TWRP? It seems it's gone.
Click to expand...
Click to collapse
That's because you're not installing it properly go back to my guide and follow it exactly and stop listening to these other people. I've been modding this device since it first came out with Android 9, I know every inch of this device. You're getting confused by what other people are telling you
MarvinMod said:
5- Press and hold vol down and power till the screen turns blank then immediately press and hold vol up. The device will reboot then land you in the twrp splash screen
Click to expand...
Click to collapse
It fails here, on this step. After successful flash of recovery.tar, power + vol down to reboot, cable still connected, nothing you can do now can bring TWRP up. The phone boots into Android.
EDIT: I think I have now got it. I will update in a few mins.
Zilliman said:
It fails here, on this step. After successful flash of recovery.tar, power + vol down to reboot, cable still connected, nothing you can do now can bring TWRP up. The phone boots into Android.
EDIT: I think I have now got it. I will update in a few mins.
Click to expand...
Click to collapse
After successful flash of recovery.tar, power and vol down to reboot, as soon as the phone screen goes blank, immediately release all keys and press and hold vol up. Must be as soon as screen goes blank. The device will then reboot twice and land you in twrp splash screen. You must hit vol down and power after successful flash then when screen blanks, vol up. If you miss this step, twrp will not hold and revert back to stock recovery.
Here is the notes I made today:
****************************************************************
INSTALL + START TWRP
phone is off
press up + dn
insert cable
go into download (press up)
ODIN 3.14 + AP:tar(vbmeta.img+twrp.img), auto reboot off, press upload
when it succeeds, press dn + pwr until it reboots
then quickly up + pwr until it starts (no need to hold down)
this starts in TWRP
from powered off
press pwr button
goes into twrp or android(system) -- depending on what was used last time
if we used reboot->system last time it will now **Always** go into system!
to go back into twrp:
switch off
power cable until charge
pwr + up until it starts
****************************************************************
The above means that you CANNOT go back to TWRP unless you have a cable and a PC near by.