I like the idea of the flip case but the Nillkin TPU case I think will provide more protection other than a screen. I find the phone to be slippery without a case and therefore with the flip case I think it will pretty much will be the same (maybe not). Can you give me some pros and cons of each?
I have the flip case.
Pros: Looks good, no bulk
Cons: No protection from the sides or back, nothing holds the cover to protect the screen if dropped. Finally, the glue on the sides starts to wear out, the skin becomes lose with use. I posted a pick of it earlier
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
tamarian said:
I have the flip case.
Pros: Looks good, no bulk
Cons: No protection from the sides or back, nothing holds the cover to protect the screen if dropped. Finally, the glue on the sides starts to wear out, the skin becomes lose with use. I posted a pick of it earlier
Click to expand...
Click to collapse
Thanks, I ordered the Nillking case. It's cheap enough that I can always get something else if I don't like it. Thanks again.
Do this...You can have both
http://forum.xda-developers.com/showthread.php?t=1382188
Yes,take both, and use either depending on where you are.
thanks .
Sent from my PG86100 using Tapatalk
Related
Finally found a case I like, the Momax i Case Pro.
Price was around $11 USD shipped.
Reason I like this case is thick enough for basic protection and thin enough not to add any bulk.
I been looking at some of the slim case, most of them doesnt add protection to the screen side of the phone.
I think this is a great case for people who wants a slimr cases but wants protection to the edge on screen side of the phone.
The edge is made out of soft rubber materials and thin hard plastic.
As you can see the edge that stick out on the screen side is very thin.
Just enough to cover the metal-like that goes around the SGS2 screen.
Rubber button are easy to press.
Back is thick enough for camera screen not to touch a flat surface.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
can you post a shot from in of the case implemented on
Wow nice case.
can i buy it from e-bay?
@rouvax
Sorry I didnt really catch that.
Do you want a shot inside the case?
I think there some pics on ebay !
@Perperz
Yup. Around 11USD shipped
A photo from in front of the phone while case is on ,
Sent from my GT-I9100 using XDA App
From the photos it appears this picks up dust/lint easily?
Can you say?
Case*Mate, Barely There Brushed Aluminum Case
Got this today locally and only grabbed it cause I was able to get it way below its retail. After putting it on the phone, I really like it. I loved my Incipio feather lite and this is actually better imo. The edges actually snap over the phone and the bottom and top are actually covered a tad more than the feather lite did on my gs2 (this could be from the different style of phone though).
The aluminum on the back feels pretty nice and the paint is actually nice on the rest as it isn't slippery like I thought it would be. Sweaty hands my make it slippery though.
You can get these at at the case mate website for $40, or at the AT&T store for $40 as well.
I don't think this will protect the phone to well in a massive drop, but it will obviously protect it from scuffs and help keep the battery cover like new (cause we like $40 cases that protect $20 battery covers ).
Mainly I got this cause I don't like bulk and at more than half price, I couldn't pass it up. XD
On to the pics -
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Yeah, it looks nice. I also had considered buying this but because of its price, i decided to go with the Rock Case haha.
Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
IMAK Transparent Crystal Clear Hard Cover Case Shell Compatible for OnePlus On... http://www.amazon.com/dp/B00L4APLTA/ref=cm_sw_r_tw_awdm_KudYtb0155H8V
I ordered the above case from Amazon due to Prime shipping. Below are a few quick thoughts and photos. Photos are not the best but should give you an idea of fit.
It is exactly as advertised, a clear hard snap on case. I tend to prefer no case or a thin TPU, but at least with this case I can see the phone(I hate covering a phone with a bulky case). Even though I prefer no case, this one does look good on the phone.
Pros:
-Cut outs for power and volume are tight, but even with my sausage fingers I can hit them easily.
-looks great
-good build quality
-fits perfectly
-cheap $10 shipped
Cons:
-goes without saying but minimal protection
-biggest gripe I have, the lip on each side is equal in height to the screen. So no sitting the phone face down.
-company stamped their logo on the back. It is small so I don't mind, but it looks like a drunk cross eyed person did it. It is off center and crooked. I will have to figure out a way to rub it off it is that bad.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
sent from my OnePlus
Does the case interfere with the flash when you use it?
I've bought one too. Now the wait begins.
NNID: leugim
So here I have two pretty cheap accessories products for OnePlus One
Casebase Premium Tempered Glass Screen Protector TWIN PACK
I would say its a great value product as you get two for £9.99. I have an experience with Nillking product where I found this is more fingerprint resistive. Its crystal clear, no picture distortion, no sharp edges. Pretty happy with it
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Cotechs® - Gel Case Skin TPU
This is really cheap but good quality gel skin. All the cut outs are in right place and align. Its really tight so it fits and hold really good. You can choose from different colour variations. For this money you can't get wrong
Good set up. So far I'm waiting on a screen protector. I thought I would be fine without a case but something like this case would be good.
Too bad they don't ship that case to the US...
Sent from my One using XDA Free mobile app
Is the lip so high that you can lay the phone face down without it resting on the screen?
Unfriendly said:
Is the lip so high that you can lay the phone face down without it resting on the screen?
Click to expand...
Click to collapse
I would say yes.but cos its so cheap the piece from piece may differ
I have both cases in hand.
Nagebee is really bulky! Twice the thickness of the Ringke. Nagebee has a super deep finger print hole, it's like sinking your finger into a deep well,very uncomfortable. The Nagebee is also slippery even though it has a texture on the outside edges. The case is basically garbage in my opinion.
I like the Ringke case for now, very slim but I will be on the look out for more cases to be released that have a bit more rubber and shock absorption to them.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
There's actually another thread for cases(where I posted pics of both with the phone in them) but I'll add that I have both these cases as well. And today was my first full day using the ringke case and loved it. Best case I've ever used.
Yes the nagebee is bulky but it'll protect your phone in case of a fall or something and that's the point of it basically. Im going to use the nagebee during my work days and the other one on the weekends.
Sent from my VS995 using Tapatalk
I have the nagebee too, but I haven't been able to take it apart to put the phone in it. Plus without a tempered glass I will stick to the defender.
Sent from my LG-LS997 using Tapatalk