Hi all,
My XDA IIs works well before. But few days ago the Power button doesnt work properly, it can turn on the phone, hold to turn off the back light, but I can't use it to turn my phone screen off like before. Anyone has same problem ?
Can you see any part of the screen? It might just be that the backlight adjustments are set too low when the unit isn't cradled. You might be able to see the screen in daylight.. or maybe it was inside your home. I forgot where I was at when it happened to me. In anycase, if you can see a bit of images on your screen, go into the Backlight properties and change the setting to your liking.
Good luck..
The problem is i can just press the power button to turn off my phone BEFORE (the screen is completly off), and NOW it doesnt work at all ! When my phone was off, I can press the Power button to turn it on, or when I hold it for few seconds the back light will be turned off, but press once to turn off. I dont know why, if somthing wrong with the Power button it should be doesnt work at all, that's mean i cannot turn on my phone as well. But other functions of the Power button are still work well, except the 'Turn off' :roll:
power off doesn't work anymore
I have the same problem here. I can't use the power button to power off my qtek 9090!!
i can use the power button to turn my pda on and to switch the background light on and off - so the "hardware side" of the power button is working.
however, i can't use the power button to turn off the device. it's very annoying, because i can't put it in my pocket after finishing a call :-(
this should be some sort of a software problem - so i hard resetted my device (a couple of times) - but that didn't help!
can anyone help?
thanks,
lorenz
the ba doesn't turn off it is always on staand by mode. ->settings -> system -> button lock
this will stop any missed call because when the ba is in standby the power button is the only one to work
power on is no problem. i can't put my BA into standby mode. if i press the power button while the BA is turned on, nothing will happen. the screen will stay on, the background light stays on.
i have no way to put it into stand-by with the power button!
try this and see if it works. it's a software app that wil rest, shut down, and turn the screen off. just copy it to your BA temp directory and install it.
power button problem
nemchua
Is your problem solved ?
Because I have the same problem.
Power of switch doesn't work !!!
Any help would be welcome.
power button problem
Does anyone solve the problem???
Had the same problem...
I had the same problem going on for about two weeks or so...never changed anything and it went away all by itself.
The problem has not come back now in over 4 months.
Sure would love to know what the problem was tho...
Greetings,
Noddy
Power Off does not work
Add my name to people with this problem.
The only event I can link it to is this: I deleted my Motorola Bluetooth headset and installed a Logitech headset. I noticed the problem (can't turn OFF with POWER BUTTON) soon after that.
same problem for me ..... someone must know !!!!
I think it is a hardware problem. The contact is not making cleanly. Disassemble and spray time, perhaps.
It's a standard push switch, easy enough to replace, I occasionally list themon ebay but any phone repairier should have them in stock.
Richard
i had same problem yesterday afternoon, but it is ok now. recovered by himself
Write again in two weeks and let us know if it is still healthy. In my case, anintermittent problem became continuous.
Can't turn the screen on after pressing power button
I have a problem with my Bell Atrix. After pressing power button to lock the screen, i can't wake up the screen up by pressing that button again. Could anyone tell me how to fix it pls.
Hi all,
does anyone sometimes have to press the power button (when phone is completely turned off) twice (2 presses to turn on) sometimes?...
so just to confirm
- handset is off
- push power button once (sometimes doesnt come on
- push for second time (and powers up)
im defiantly pushing for long enough
iv have no issues with the button at all when in the UI or when locking/unlocking display
iv done a few tests where i have turned off. then went to switch on, with the same pressure and sometimes it starts with one, sometimes it starts with two presses,
do u think this is a fault? anyone experience this? normal?
just checking...
thanks heaps!
I had the opposite on my first one. When I pressed the power button to turn screen off, the screen went black for 1 sec and jumped back on lock screen.
brodiecb said:
Hi all,
does anyone sometimes have to press the power button (when phone is completely turned off) twice (2 presses to turn on) sometimes?...
so just to confirm
- handset is off
- push power button once (sometimes doesnt come on
- push for second time (and powers up)
im defiantly pushing for long enough
iv have no issues with the button at all when in the UI or when locking/unlocking display
iv done a few tests where i have turned off. then went to switch on, with the same pressure and sometimes it starts with one, sometimes it starts with two presses,
do u think this is a fault? anyone experience this? normal?
just checking...
thanks heaps!
Click to expand...
Click to collapse
to switch on device you have to keep pressed power button for few seconds or u can keep it pressed until you see lights at the touch keys.. :good:
Hi
brodiecb said:
Hi all,
does anyone sometimes have to press the power button (when phone is completely turned off) twice (2 presses to turn on) sometimes?...
so just to confirm
- handset is off
- push power button once (sometimes doesnt come on
- push for second time (and powers up)
im defiantly pushing for long enough
iv have no issues with the button at all when in the UI or when locking/unlocking display
iv done a few tests where i have turned off. then went to switch on, with the same pressure and sometimes it starts with one, sometimes it starts with two presses,
do u think this is a fault? anyone experience this? normal?
just checking...
thanks heaps!
Click to expand...
Click to collapse
I don't think many people would turn their phone completely off so haven't found the issue.
When you power off what will be happening is the phone is off as much as it can be, but these buttons are soft off, the battery is still connected and some power must be drawn to run the power circuitry to detect the button being pressed again to signal to power back up the phone, in the same way when you turn your TV off by the remote, power is still drawn to run the remote sensor on the TV.
To keep the drain on the battery as low as possible so the battery isn't completely discharged over months of storage I suspect the power chip waiting for the on signal again is only sampling every so often to save power so it can be in super deep sleep state. This means depending on where in this cycle you are when you press the power button it might seem like it isn't responding, so typically you have to leave it depressed long enough for it to be "seen".
The better option is to just to put your phone into flight mode if you don't want to be disturbed or want the phone off. I do this overnight and lose no battery power by the morning, so it is as good as off. You can add a button to your home screen to do this quickly, widgets are included already for that.
Regards
Phil
Mine does the same thing.. Sometimes it does it with waking up from sleep also.
Sent from my HTC One X using xda app-developers app
Hi all
wondering if someone might be able to give me hand
my phone is rooted and am running CM10 stable and was working fine for about 3 months.
this morning i went to use the calculator and then the phone rebooted, and will not come back up.
I keeps viberating every coupel fo seconds. Tried to hold down power button but nothing happens. yanked battery and and reboot and i see the samsung slapscreen then it goes back to viberating
I tried to yank the battery, while holding down the power volume up/down to get into recovery but no luck. tried to yank battery and hold down volumne up/ down trying to get into download mode but also no luck
wondering if there might something i can try to get my phone back working
take care
i tried to take the phone apart to see if the power button was stuck but still now luck
Sounds like a power button issue. Its not that it gets stuck physically, the power switch gets messed up and acts as if its being held down. You can replace the switch or try a ghetto fix. I had to remove the power button from the case from my brothers phone. I took it out then plugged the hole with it by taping it on from the outside.
There are a few ROMs out there that allow you to use alternate buttons to turn off the phone and use volume keys to wake it up. So you will only need the power button to turn on the phone when its off completely. For my brothers phone I use a toothpick since I removed the power button.
It is just beginning to mess up on my phone bit it wasn't a severe enough case for me to remove the power button.
I would recommend trying to fidget with the button a bit, trying to see if you can get it out of the power loop (endless vibrating). What I do is pull the battery and press the button a few times. I even flick that corner of the phone a few times. Then I put the batter back in and see if it stopped cycling. If not I try to press the button a few more times and or give it a flick or two with the battery in. There seems to be no direct method that works but it eventually stabalizes.
If it does stabalize, I'd recommend testing to see how sensitive it is. If you can't put it in your pocket or even the slightest movement makes it cycle. I'd say you need to remove the power button or have the power switch replaced. If it stabilizes I would just get a ROM with the options I mentioned and stop touching the power button.
My S3 started randomly rebooting yesterday. The power button also because super sensitive. Just a light brush would cause the phone to register a press.
I edited my .kl files and disabled the power button and remapped it to the volume down button. I haven't had as many problems as I did yesterday but now it shuts down when I plug in the usb cord and it did shut down one more time when I picked it up off my desk.
I thought it was a faulty power button that was causing my phone to reboot but now I'm not so sure. Remapping seems to have helped a little though.
The files I edited were sec_keys.kl and sec_powerkey.kl. For both I disabled key 116 POWER WAKE and remapped it to key 114 which is the volume down key.
Any ideas on how to fix this completely? Is there another power setting I'm missing? I'm 3 months from my upgrade and don't really want to spend cash on this thing.
The power button is a somewhat common issue. Look at some disassembly videos. Maybe you can find a way rig it or replace it. The parts are pretty cheap if youre willing to attempt it.
Sent from my SM-N900T using Tapatalk
I think I have mostly solved my issues. I pulled out the power button and I haven't had a problem since. Between that , the remapped power key and the Auto Screen On app I think I can make it till upgrade time.
So, my phone's Power button and volume button doesn't work. Didn't really have an issue since it never ran out of charge and I could just tap to wake. My phone went out of charge last night. Now I am unable to figure out a way to switch it back on. I thought charging it would switch it back on..but nope..it just shows the battery meter. Is there a way to switch the phone on? I have also tried to teardown the phone and check the naked power and volume buttons..but none of them work. I might have to change the cable tomorrow. In any case, is there a way to switch the phone on without using volume and power buttons?