Does anyone know how I can find out the mac address of my xda IIs ? I have a dreytek wireless router at home which uses a mac based access control list. I've tried the addresses that appear in wireless LAN manager ( BSSID and MAC ) but no joy. The only way I can connect is to switch off the access list feature completely
jeff
Hi Jeff,
Switch off the Access control, and let the XDA IIs join the wireless network. Then go into Diagnostic Tools --> View DHCP assigned addresses, and you will get a list of MAC addresses, IP addresses and hosts on the network. Match your phone's name to the MAC address.
Then you can turn access control on again and input the phone's mac address into the "allowed" list.
Thanks for the reply. I've kind of done that as you can see from the DHCP table below
DHCP server: Running
Index IP Address MAC Address Leased Time HOST ID
1 192.168.1.1 00-50-7F-23-97-CC ROUTER IP
2 192.168.1.10 00-00-00-00-00-00 BAD IP
3 192.168.1.11 00-0D-61-4E-A7-F7 0:00:04.600 hubbo
4 192.168.1.12 00-09-2D-0E-49-61 9:24:34.170
(not sure about that BADIP line ! )
I would say my MAC is 00-09-2D-0E-49-61 but it's still not working.... odd.
Is there no way that you can tell the MAC address from the phone without connecting to a network.
Here is a freeware that will allow you to find your MAC with no connection. I used it on my PDA2K.
http://www.freewareppc.com/communication/vxipconfig.shtml
Install on your device. Just turn the wifi on and run the program and it will give you the MAC and additional device info. Don't have the PPC connected to the USB or it will identify that device.
Sorted thanks, whilst in PC World I scanned for a Wireless network, and found three, hehe! Once connected used that utility to get my MAC.
Many thanks!
wifi and drayteck router
hi i see u have a draytech router how did u manage to get streaming video? i have been trying now for hours.I can get the video on my laptop without any problems but my m2000?????
i think the problem lies within the vpn settings as when i try to open http://house:8080 i get the message vpn connection required.
any help would be greatly recived (i have the vigor 2600g)
thanks in advance
delboy
Greetings...I'm trying to determine the MAC address of my HTC TP2's 3G radio. I am setting up a firewall rule to only alow a specific MAC address to pass for specific services. Any ideas as to how to determine the MAC address of the internal radio?
Thanks,
Chris
chrisb009 said:
Greetings...I'm trying to determine the MAC address of my HTC TP2's 3G radio. I am setting up a firewall rule to only alow a specific MAC address to pass for specific services. Any ideas as to how to determine the MAC address of the internal radio?
Thanks,
Chris
Click to expand...
Click to collapse
MAC of the 3g radio...? Certainly you mean the wlan radio.
When I enable wifi in WinMo, there's an "advanced" button at the bottom. Then choose wi-fi info, IP and MAC.
Response....
Not the WiFi radio...the 3g radio as I need access outside my network through a UTM. I guess the first question should have been, is there a MAC associated with the 3g radio?
Thanks,
Chris
chrisb009 said:
Not the WiFi radio...the 3g radio as I need access outside my network through a UTM. I guess the first question should have been, is there a MAC associated with the 3g radio?
Thanks,
Chris
Click to expand...
Click to collapse
Odd.
I'd guess there is, but I've never heard of anyone caring about it lol. IP probably wouldn't work so well either, what about hostname or smth else?
What if you lose your phone?
I'll see what I can dig up.
Edit - wait... if your packets are going thru a layer-3 router (which undoubtedly they are at some point) the MAC will be lost. So this won't work at all, even if you did find the MAC of your phone.
Response...
I couldn't find anything through searches....The IP would be of a dynamic nature so I couldn't use it however the thought about a host name is an idea. I'll have to inspect the packets to determine if a host name is present. On my inital inspection I captured a MAC however that MAC seems to be dynamic and did change a few times using one of two MAC'S thoughout the capture. Also...during the capture I captured IPv6 MAC's....not IPv4. I'm just wondering if the CDMA network assigns a dynamic MAC instead of using a hardware based MAC? I would find this highly unlikely however it could be a possibility.
Thanks,
Chris
chrisb009 said:
I couldn't find anything through searches....The IP would be of a dynamic nature so I couldn't use it however the thought about a host name is an idea. I'll have to inspect the packets to determine if a host name is present. On my inital inspection I captured a MAC however that MAC seems to be dynamic and did change a few times using one of two MAC'S thoughout the capture. Also...during the capture I captured IPv6 MAC's....not IPv4. I'm just wondering if the CDMA network assigns a dynamic MAC instead of using a hardware based MAC? I would find this highly unlikely however it could be a possibility.
Thanks,
Chris
Click to expand...
Click to collapse
Please read my edit about layer-3 routers. I'm having this same problem at work, in relation to sniffing VoIP RTP streams passively. When crossing a layer-3 router/switch, the MAC is lost in transit.
Response...
I believe I finally nailed down the actual MAC address. My packet monitor was set for the monitoring a different port on the switch.....should have been set for X1 instead of X0. I'll make the changes to the firewall and all should be good. This exercise is for a handheld utilizing a SIP client tied into my VoIP server....I only allow specific SIP clients to access my VoIP server....helps prevent hacking and unauthorized phone use.
Thanks,
Chris
Response...
I'll report back my findings after I make the configuration changes.....I am assuming this will work as I already have this in place for all SIP providers currently in use.
Thanks,
Chris
Findings....
Ok...one small detail I forgot.....is that MAC addresses change with each hop. With that being said.....the only way to "filter" incoming packets is to filter by IP address. I currently filter all SIP related protocols by carrier/provider IP address. Now this creates an issue due to the fact handhelds outside of the network will have dynamic IP's assigned by the cellular carrier. I'll have to continue to research this....I believe the only work around might be a VPN tunnel originating from the handheld into the network.
Thanks,
Chris
chrisb009 said:
Ok...one small detail I forgot.....is that MAC addresses change with each hop. With that being said.....the only way to "filter" incoming packets is to filter by IP address. I currently filter all SIP related protocols by carrier/provider IP address. Now this creates an issue due to the fact handhelds outside of the network will have dynamic IP's assigned by the cellular carrier. I'll have to continue to research this....I believe the only work around might be a VPN tunnel originating from the handheld into the network.
Thanks,
Chris
Click to expand...
Click to collapse
That's what I told you, twice now...
Actually..
You mentioned loosing the MAC address across a layer 3 router....the MAC address is lost across any router regardless of it's layer capability thus I will implement a different solution.
Chris
chrisb009 said:
You mentioned loosing the MAC address across a layer 3 router....the MAC address is lost across any router regardless of it's layer capability thus I will implement a different solution.
Chris
Click to expand...
Click to collapse
What router operates only at the layer-2 level? lol.
My phone keeps changing mac addresses. Is this normal? And does the mac address changer with every rom I load? I thought mac addresses were phone specific, and not rom specific. As in your phone has a mac address and that it didn't change. Thanks
It should not change, not sure what's going on there.
Hello,
Does someone know how to change / spoofing MAC Address in MIUI?
I already try this method http://forum.xda-developers.com/nexus-s/general/update-18-05-13-spoof-wifi-mac-address-t1385577
Mac address is already change but I still can't connect to the network.
Could you please help me.
Thanks
even i tried to connect to my work network after mac spoofing and was not able to get through.
but what worked for me was to change DHCP to static IP and assign a free ip (to my phone) i found using IP Scanner.
Each time USB tethering is activated on POCO F3, its USB network adapter IP address and the provided DHCP address pool changes since the last time. Hence the connected PC gets a diffrent IP address each time. The phone's IP address (seen as gateway address from PC) is different too each time. As I read somewhere this is a new "great feature" of the Android 11.
Is there any way to prevent this and to keep the same phone's IP address and the provided DHCP address pool for every USB tethering session?
Simple answer, no. This security feature is there since Android Q, it's annoying cause you have to check the IP each time, but it provides a great level of security.
Unless you are willing to downgrade to Pie (which your phone doesn't even allow), there's no easy workaround for you here.