Help! Diamond Not Starting Up - Touch Diamond, MDA Compact IV ROM Development

I recently tried to unlock my uncle's Diamond. I used Hard SPL1.4 from this site, and it finished that successfully. After restarting, I went through the whole screen calibration and so on, then I went to the kitchen to get some food. By the time I got back, the Diamond wouldn't start at all. I haven't tried a hard reset, but I don't think that would do me any good since the phone doesn't start up at all. Is there anything I can do? Or will I have to tell my uncle I ****ed his phone..
Just a quick detail, I did notice that after it started up again, the area next to the SIM card slot heated up quite a bit. I don't know if that's related, but I figured I'd tell you anyway.

The Hard SPL of choice is the 1.93. Any who, try and place the device into bootloader mode (tri-colour screen).
Hard Reset Your Device:
• Soft reset button and hold the vol. down + Circle button until u see the grey screen. REMEMBER THIS WILL ERASE EVERYTHING SAVED ON THIS ROM (i.e. contacts, calender, etc.)
Bootlaoder Mode:
• Soft reset and hold the volume down until u see the tri screen
Do you see the Hard spl 1.40? if yes, then just a hard reset and see what happens
IF none of the above worked, take out the BATTERY for a bit and try the above options all over again.

Hi, thought i would add to this thread.
Mine also did this, it worked fine for a week with Windows Revolution 6.5 rom then it randomly turned off and refuses to turn on.
Bootloader mode / hard / soft reset none work.

Related

Diamond just keeps resetting itself

I just flashed macadam ROM and now my phone keeps soft resetting itself it gets to the touch diamond screen..hangs up and then soft resets..
Please Help
pls refer to http://forum.xda-developers.com/showpost.php?p=3433851&postcount=22
Another option is to flash a stock ROM
i tried stupitly somethings at my new pda, (i set up one rom called DiamondC_HSPL057.exe on Diamond) and now..., soft reset , hard reset, power button ,charge sign, doesnt operate...i tried with full battery but nothing..please help!!!!
i dont think that is a diamond rom.
theres nothing on here named like that.
you might well of bricked it.
If dead try:
...…holding the power button, volume down and hard reset button the same time
.....you can see the bootloader again and (you have to quickly flashed it because it will only sync for few sec) quickly flashed a fresh copy of olipro hardspl and it will be back to life
.....now u can flashed your new rom as a you did before

Big problem with frozen screen and posible solution dont work, please help me.

First thank's for four help and read this thread.
The problem is:
My exca100 the last week work fine but the monday the exca reboot and frezeeng in green WM screen, i leaves it all night but it does not continue.
I try reflashing but the problem is, the image is corrupted (I cant unlock the exca, so that it does not initiate windows)
Can any one help me.
ONLB 1.30.0000
SPL 1.30.0000
Brightstar shiped 1.30.514.2
labtelcel said:
First thank's for four help and read this thread.
The problem is:
My exca100 the last week work fine but the monday the exca reboot and frezeeng in green WM screen, i leaves it all night but it does not continue.
I try reflashing but the problem is, the image is corrupted (I cant unlock the exca, so that it does not initiate windows)
Can any one help me.
ONLB 1.30.0000
SPL 1.30.0000
Brightstar shiped 1.30.514.2
Click to expand...
Click to collapse
what do you mean by( I can't unlock the exca)?
Hard Reset
Hard Reset will most likely solve the problem. I had the same problem.
TO HARD RESET:
-Turn off the phone
-Hold 2 soft keys
-press the power button for 3-5 seconds(still holding two soft keys)
-black screen will show up saying that pressing send key(green) will restore your settings to original settings.
-press send(still holding two soft keys)
-the end.
NB: YOU'LL LOSE YOUR PHONE'S DATA.
For Hard-Reset see sticky "a picture tells a million words"
The hard reset dont work, frezz in HTC screen I wait 2 hrs.
I dont want unlock, I want normal funcions.
labtelcel said:
The hard reset dont work, frezz in HTC screen I wait 2 hrs.
I dont want unlock, I want normal funcions.
Click to expand...
Click to collapse
Don't understand bolded?
You have tryed Hard-Reset not work, remove battery for about 5 mins and replace, try again "Normal boot then if not work try Hard-Reset"
Sorry for my poor english, Im from mexico.
I try the master reset many times it does not work, of several ways, extracting the battery for 5 minutes, 1 hr, 3 days, and it does not complete the reset, freeze in the htc screen, or another times in windows mobile logo screen.
When attempt to change the flash (for solving the problem) the process does not continue of 3%, this happens so I cant execute the jump USPL aplication.
In summary:
reset hard not work (hold 2 soft keys / turn on / black screen / send key)
Change the Rom for repair de damage not work (I cant load the aplication for jump USPL)
Write Rom direct in the bootloader (3 color screen) not work (hold camera button and tur on)
Any idea?
Change bootloader?
Another powerfull rom?
Special software?
Special combination to delete all in the internal memory without entering Romupdateutility locks or windows?
Please helpme to recover my excalibur.
this is so easy to fix,
your old rom now crashed, hardreset can't help you,
to repair,just download a new rom then open bootloader mode.
boss_of_any_phone said:
this is so easy to fix,
your old rom now crashed, hardreset can't help you,
to repair,just download a new rom then open bootloader mode.
Click to expand...
Click to collapse
Just shows sometimes can miss the obvious, bootloader in sticky & flash original ROM in stickys too..
Dont work the reflash in bootloader (try 10 times), I flash the rom and the phone frezz in the same screen (WM logo screen).
Help.

Help with HTC Touch Diamond, won't boot

Hello, this is my first post here. I tried to install Windows Mobile 6.5 as indicated in Gizmodo http://gizmodo.com/5281397/how-to-install-windows-mobile-65-right-now but it didn't work and now my phone won't boot.
The phone is an HTC Touch Diamond from Sprint. I followed all the steps indicated and everything look fine, but after installing the OS the phone displays the screen TOUCH DIAMOND, and then restarts and displays the same thing. I'm able to get into the boot loader (Tri color screen) and says:
DIAM500
SPL-0.57.CMONEX
MicroP-Diam (LED) vB
PSOC-Diam STAGE_EVT v20.
I don't know what to do now
Thanks
try to load back to default setting by pressing the power on button at the top of the phone, before the "Touch Diamond" logo come up, press and hold volume down button and the center button until the three color screen come out, then release the two button you are pressing..
if the problem still happen, that mean the rom you are using should have risk on it..
give it up and try other rom or flash it again..
hope my suggestion can help you solve the problem..
dont worry.
if bootloader is possible as you write
than you can flash all time orig. rom back.
Flash from Olinex 1.40 screen?
okokur said:
dont worry.
if bootloader is possible as you write
than you can flash all time orig. rom back.
Click to expand...
Click to collapse
Hi I have the same issue on my HTC Diamond. I flashed wm 6.5 and it was working fine, then it hanged on titanum weather. I reset and it stayed on the HTC Diamond page, I did hard reset and got the Olinex 1.40 3 color page. It does respond from serial to usb when I plug/unplug. Can I reflash without active sync?
Turns out I was able to flash, but both roms I tried work well on 1st install, but stay stuck on the Touch Diamond screen everytime I restart de device. Is it a problem with the radio not compatible , or is there a specific Hspl for each ROM???
I found solution for this problem. If your diamond won't boot go to bootloader mode and upgrade your radio http://modmydiamond.info/index.php?option=com_content&task=view&id=15&Itemid=26 and after that your dimond worked fine without loosing data.
try to hard reset the phone by pressing vol down key + the center button + reset button.
if the problem is still like dat..
try to install another rom..
davidwong007 said:
try to load back to default setting by pressing the power on button at the top of the phone, before the "Touch Diamond" logo come up, press and hold volume down button and the center button until the three color screen come out, then release the two button you are pressing..
if the problem still happen, that mean the rom you are using should have risk on it..
give it up and try other rom or flash it again..
hope my suggestion can help you solve the problem..
Click to expand...
Click to collapse
Thanks davidwong007 for your help, I was experiencing the same issue as op and your method did the trick. For a minute there I thought I had bricked my HTC Touch. I did step by step what you suggested and ended up in the rainbox screen, once I was able to do that, I knew there was a hope. i did a full factory reset of the phone and voila the phone fully booted, the pain in the butt touchflow loaded. Very important thing I forgot to do in the past is to back up my phone, after the restore you will lose everything on phone, except what is in the internal storage. Thanks again.

HELP....cannot turn on my mobile after flashed a new rom (Energy Rom) into my Diamond

I flashed a new rom (Energy Rom) into my Diamond before.
After power on.......
just "TOUCH DIAMOND" on the screen
and after few seconds....
"R 1.08.25.20
G 52.44.25.24U
D 2nergy ROM" (in red colour)
appear on the right bottom screen
then stop...
It cannot run window mobile6.5 now.........how can I do???
I cannot connect to PC .......
Have you tried to manually open the bootloader, connect it to PC and than flash another rom ? (maybe the original one will help)
i had the same problem with my pro. but my pro somehow fixed itself, i just kept pulling the battery out and wait a minute then put the battery back in and turn it on then like the 12th time it loaded up very slowly so i ran to my computer and loaded another rom. but i'm sure you tried that.
have you tried a hard reset, it's differnt from each carrier i think but it's something like hold the phone upside down and press the volume down button and then put your stylus in the reset button, idk if it will work but what can it hurt. but just rememebr there is a couple differnt ways of doing it and i think it's by the carrier.
Sorry to hear that..
I would recommend a hard reset first. Do that by reseting your phone using your stylus then immediately hold the volume down button and the enter button (the round center button on your dpad).
Keep holding them until you are prompted to hard reset. Follow the instructions. After the hard reset, if your phone still doesn't boot enter bootloader manually by reseting uing the stylus and hold down the volume down and the button with the backward arrow on your dpad. Keep holding until the phone enters bootloader. Connect your phone using USB to your computer and flash a new ROM. If no ROM works, the original should work.
Hope this helps. Good Luck.
I have same problem and hard reset helps to fix that...I recomend after that to change energy rom because it can happens again...

ATT TILT 2 owned since released stuck in Boot Screen

I have a Stock TILT 2 (TP 2) never flashed running basic programs Mobile Shell never had any issues with it, haven't installed new software in a few weeks , but I soft resetted it this morning and it keeps getting stuck in the boot screen. when first turned on it will run through boot screen then load screen for a millisecond then back to boot screen and never advances again , I've tried battery out sim card out Sd card out everything, even tried hard reset , but wont allow me to hard reset with front buttons and power, is there another way to hard reset , is it possible my phone just bricked for no reason ? thanks for any help ?
have you tried to do a hard reset via the pc? the original rom is on the htc website so you can try useing the exe file there. there is also an updated rom you can try to flash there. hope that helps
You might try sending it to the bootloader screen and reflashing. I don't know if it will work, but I thought it might be worth the effort.
I did notice that HTC removed the original shipped ROM for the Tilt2. I'm sure it is floating around here somewhere. If not, I have it and can send it to you when I get home.
Thanks I have original rom and just released wont work.
dod you see anythign on teh screen? if you do, then hard reset may fix it.
Power off your phone (or take teh battery out). Then press and hold teh call and hang up button while press teh power button. it will enter the hard reset mode. (remember hard reset will erase all the info on the phone and rever tot the stock setting).
jcterry said:
I did notice that HTC removed the original shipped ROM for the Tilt2.
Click to expand...
Click to collapse
wow, thank god i dl'd it when i dl'd the updated rom... and they still have the image of the old rom right beside it... lol
as for op, you can try to enter the bootloader with the following steps
Remove the back cover from the phone.
Hold the Volume Down button.
Use the stylus to press the reset hole.
Or if the device was powered off, press the power button whilst holding down the Volume Down button.
and try to flash from there
hope that helps again

Categories

Resources