noticed my touch screen does not seem as responsive as my tp was. is theere some settings to fix this?
Related
When the screen auto-dims before timing out and I touch the screen to undim the display, the touch registers which gets annoying, e.g., when that means that menus are popping up in the open app and I have to touch again to close them. Is there a way to emulate iOS behavior here, i.e., when dim the first touch to the screen undims and only successive touches register?
Man, does anyone have a solution for this?
Greetings, using an E975 which recently had to get its screen+digitizer changed, which is working fine except for a little issue, touches get registered about 1-1.5mm lower compared to where I touched. So vertical orientation is a bit off, horizontal appears ok.
Old/original digitizer didn't have such an issue. Rom is official 4.4.2.
I tried pretty extensively for a touch calibration app as well as looked in the menu for a built-in option but no luck. Any ideas?
Hi everyone.
I have recently had my screen replaced. After playing around, i quickly noticed that my keyboard screws up when i start typing.
The faster i type, the worse the problem is.
I checked touch response times and achieves normal times of about 60ms, however, i turned on touch overlay in developer settings and noticed that if i touch opposite sides of the screen quickly (to simulate typing), it would draw lines between the touches as if i was dragging between the two points.
This is what causes my keyboard to do funky stuff and heavily lag when typing fast.
Please note that this never happened before the screen replacement, and a hard reset didnt fix the problem.
Is there any software fix for this, or do i need another screen?
thanks.
nic_coe said:
Hi everyone.
I have recently had my screen replaced. After playing around, i quickly noticed that my keyboard screws up when i start typing.
The faster i type, the worse the problem is.
I checked touch response times and achieves normal times of about 60ms, however, i turned on touch overlay in developer settings and noticed that if i touch opposite sides of the screen quickly (to simulate typing), it would draw lines between the touches as if i was dragging between the two points.
This is what causes my keyboard to do funky stuff and heavily lag when typing fast.
Please note that this never happened before the screen replacement, and a hard reset didnt fix the problem.
Is there any software fix for this, or do i need another screen?
thanks.
Click to expand...
Click to collapse
I mainly work on iPhones, but it sounds like your digitizer is out of calibration. Don't know if there's a software fix for it, but hopefully this will point you in the right direction. Also I'd take it back to the place you had it repaired and see if they can fix if it's still warrantied.
its really really sensitive on touch screen ..
anyone knows how to low the sensitivity touch ?
or my screen problem ?
Same issue here with me, I'm also having the touch problem while playing pubg and also while typing.
If I keep joystick on phone camera side then I face the touch problem, when I keep joystick on charging side then its work but cannot aim faster.
I also tried that *#2663# but still having the same problem.
And I don't received any update to fix this issue.