hi,
yesterday i replaced the broken case of my xda neo - htc prophet. it was a little fidding, but finally i got it.
but after i powered on the phone, i got a strange problem: when i make a call, only the rear speaker is activated - but when i play a sound, i cannot hear the speaker. so i disconnected the rear speaker and tried again, and surprise: the little speaker behind the LED at the front works.
anyone knows this problem or has an idea how to fix it?
thanks a lot in advance!
Related
Hello all,
I have a l700 on Sprint. My loud speaker is not working.
I searched and I found posts that discuss issues with the speaker not working from what seems like hardware issues. My problem, however, is a little different. I swapped my charging port ribbon because it was damaged and when I booted, everything worked except the loud speaker.
The Headphones work, vibration works. I tried sound about to no avail. I proceeded to order a new speaker unit. I installed it today and it seems that this is still not producing any sound through the loud speaker.
Can anyone help me figure this out? I am perplexed.
Thanks in advance.
Sent from my SPH-L710 using Tapatalk 2
Could someone at least tell me where a better place to post is?
Sent from the wireless world.
It appears the replacement ribbon was messed up. I tried the old one and the speaker works.
Sent from the wireless world.
Hey guys.
Last week I broke my earphone jack plug's tip inside the earphone socket, my loudspeaker was working at that time and that was the only way I could make or receive calls cause the phone jack was stuck inside and the all sound was being sent to my earphone, so I ordered a replacement part for the jackplug and loudspeaker. I cracked the phone open and disconnected that part so I could use the phone's normal speaker while I waited for the replacement part to arrive. When it arrived I connected it and now I can use my earphones again but the loudspeaker doesn't work, not even with the old part, I must add that I used a little bit of plastic to avoid the connection of the loudspeaker and earphone plug to the board.
Can that connection be damaged? but if it is why do I get sound from the earphone but not the loudspeaker? doesn't it use the same connection?
thanks in advance
Tiago
I've had cell phones for over 20 years and have never broken one... till now. I left my GS3 (i747) in my pants pocket and my wife washed them. I took it apart, dried it out, then cleaned it (I was amazed at the amount of corrosion). After putting it back together, everything worked except for the microphones. All the person on the other end could hear was static and crackling, and that was all I get when using Voice Recorder. It works fine with a headset for calls, however. I replaced the microphones but still have the same issue. I also have the same issue if I disconnect the connector for the headset jack so I assume the problem is in the logic board. I also tried it with the new microphones removed just in case I might have messed them up.
Anyone have any idea what the problem could be? How about what the highlighted device on the attached pic of the logic board is that looks kinda like a microphone, i.e. metal can with a small hole in it?
Thanks
Hey everyone. I bought a Verizon Note 4 on Facebook. I met the person and he showed me the phone, everything seemed to be fine. It sat on my desk for about 3 days while I waited on a new screen protector and case. A few minutes after turning it on I realized there was no sound from the external speaker. I factory reset and spent the night googling with no results. I contacted the person and they said it worked fine when they had it. So dead end there.
So here's what I've tried: factory reset twice, replaced the speaker, bent the speaker contacts out, blew out the headphone jack, plugged in out a headphone plug, and installed an app that lets you switch between headphones and speaker. The earpiece and Bluetooth audio work fine
Anyone have any suggestions? Thanks in advance
So I guess that's a no...
Sent from my ASUS_Z00AD using Tapatalk
My situation with my AT&T Note 4 is a little different, but really recent, so I'll add it to this thread. I got a broken phone and refurb'ed it by putting on a new screen.
Two weeks later I was listening to a podcast through the speaker. After a while suddenly the sound went mute. Also, no OS sounds would play. Rebooting the phone fixed it.
A week later, same activity, listening to a podcast. The speaker stopped playing again and several reboots did not fix it. After disassembling the phone and adjusting the spring clips that touch the speaker, and tightening the screws, it still wouldn't play.
I ordered just a replacement speaker part from eBay and put that in, and the sound was tinny but it played. The speaker is bonded into the housing, so the replacement process involved taking it out with a razor blade and destroying it. I used Go2Glue silicone glue to put the new speaker in and I was left with a tinny speaker that sounded blown.
I ordered a new housing that had the speaker bonded in there from the factory, to do the refurb "the right way" which was a tad more expensive. New speaker, still tinny like the last one. So, I'm not sure what is the deal with the initial speaker sounding fine, but dying on me. Then I get two in a row which sound terrible.
One guess is that the audio chip could have gone bad. Another is that my two new speakers are not genuine Samsung. I found this YouTube video a while back (neat if you have 30 minutes to spare) which shows a Chinese Note 4 clone, which apparently has poorer speakers than the real Note 4.
Hey everyone,
Recently i repaired and changed my broken screen and now theres no sound coming off my internal ear speaker. I checked all connections carefully and im sure nothing is broken..
I can hear sound from the speaker on top. The other one is silent too. I bent all connectors a little bit to ensure the connecticity, but now ive got no idea where the probl could be.
Can anybody explain to me where are the connectors for the speaker exactly?
Thank you!
Can anyone upload a working mixer_paths.xml please?
I'm rooted and on actual lineage rom..