Whats going on people... I have tried to update the rom on my phone. I had to first unlock the phone. that went well but now i turned on the phone and after it loads up it shuts off if i try to do anything. The only way it will stay on and i can use it is by keeping it pluged in..... Please help....
you would prob have more success getting help if you
1. stated which phone you had
2. stated which rom you changed to
3. posted this thread in the forum of the device in the case of it being a htc device
Related
Sorry if the post has already been mentioned in another forum before.
I have an O2 XDA Orbit and i'm looking to put Fracoons Artermis rom on it http://forum.xda-developers.com/show...o♦.
I'm pretty new to flashing phones and PDA's but i'm quite experienced with a PC so shouldnt need to much help!
I was wondering what steps I should ensure to take to make sure that I dont turn it into a brick, I could do with a complete guide! I've also been told that i'll need to run the Artermus USPL program after connecting the phone. But any help and advice would be a great help. Is there anyway to backup the phone in the state it is at present if or if it doesnt go wrong?
Thankyou for the help and sorry again i've this has already been asked by someone else! Will really appreciated it!
There is no assurance that the process will not make your device a brick. But it happens only on a rare case. Many 1000s of users have upgraded without problems however a few has got their devices a brick.
There is no point taking a backup as the new ROM will give you different files. Anyway, to make sure you don't end up with a bricked device:
-Charge your device fully
-Run USPL
-The process should complete successfully!
-Upgrade ROM.
-Never disconnect your Pocket PC or turn of your PC when the upgrade is going on.
-If your stuck anywhere, don't try to do anything stupid but come here and post.
-Your device should be fine
-Even if some devices get bricked during one of the upgrade process, there is still a high chance of bringing your device back to good working condition with the help of a Factory ROM and so don't worry and go ahead.
Regards,
Carty..
that's my biggest concern so far... my XDA II SHOULD be able to run WM5 but i'm very concerned that i could turn it into a brick... the reason for this is: the XDA is the only phone i have at the moment.
If it bricks, then i'm literally screwed... i have the HimaUpgrade File that does not need an ID, and as i'm pretty fluent with English, i see no problem in using an English ROM.
The Wiki is a good place to start... but i still don't know if i REALLY need active sync to be running or not, since i cannot understand what good that would do if the device is in Bootloader Mode anyway.
Reason for this is that sometimes i read "Active Sync should be on" and sometimes i read the complete opposite... it's freaking me out.
Device should be Synchronized always for the best choice. All un-official ROMs will require this. However, factory ROMs can be flashed directly from Bootloader mode.
That is why I said when you think you screwed the process of upgrading, mostly your device will be stuck at bootloader or you can access bootloader screen and only a factory rom can go from here.
PS: I wont guarantee if the above will be true on all conditions.
Regards,
Carty..
I flash all my ROMs in bootloader mode, including my own, so it's not restricted to the official ROMs. But you need a working ROM to get it back alive.
I'd recommend using a laptop for flashing or use a USV. If some guys cut your power your computer would crash right in the middle of the flashing process - won't happen on a laptop with a working battery.
This is what I want to know. How do I flash in bootloader mode?
okay, i did it this way: first of all you need a rom to flash your device with, but i guess that should be clear
To put your device into Bootloader Mode you have to press the On/Off Button, the Directional Pad AND the reset button (mostly at the lower left corner) simultaneously.
Release the Reset Button first after about a second, and then the other two Buttons.
Your Device should say "Serial" on its Screen... by that time you can put your Device in the Cradle or connect it via a USB Datacable to your PC.
Also: connect the Cable/Cradle directly to your PC, not to a hub as that could cause Problems during the Flashing Process.
Now you can start the Flash-Program, wait approximately 30 Minutes (if you are just flashing the ROM and nothing else) and follow the Instructions that came with your ROM WORD FOR WORD as these instructions are working for most people.
I'm not saying that flashing is without Problems though... when i flashed my XDA II with WM2005 yesterday, i was not able to send/receive Textmessages (SMS), so i had to reflash the device again with the last ROM released by O2, which sucks.
Hey i hope all is good.
I really need your help. I have a TILT 2 cell phone and by mistake a friend activated the bootloader. Previously the ROM has been updated. the phone got stuck in that screen and the only way to turn it off is removing the battery. so, i try to reboot the phone and it only loads the bootloader with a flash message saying "no image file". ok, i though, the ROM was damaged and after reading a lot in the forums, i followed the instruction to put a new ROM. I connected the phone the the computer and the message in the phone changed to USB and my PC installed the HTC USB Sync driver (but Active Sync does not detect the phone); anyways, i ran the task 29 and a new rom. I was able to see the progress bar in both (PC and Phone) but then the phone reboots and loads again the bootloader. I tried to use the HARD SPL 1.00 as well but it does the same thing after finishing the flash it loads again the bootloader.
can some help me pls?? i'm new in this and the phone is a work tool for me i really need your help.
rgds
You should do the HSPL before flashing a ROM (unless it was already done).
I would try to flash the newest HSPL, then a ROM.
Hi, and thank you for you reply.
I already did it and apparently it flashed the HSPL . Now in the bootloader says SPL 0.85 OliMex; then i flashed the ROM and it showed me the progress bar in both system (PC and phone) but when it finish it booted back to the bootloader. I just noticed that sometimes (after been off for a while) if i turn it on it boots to the rom but it happens randomly and if I turn it back off i just got the bootloader again.
I really need your help pls
jsolanon said:
Hi, and thank you for you reply.
I already did it and apparently it flashed the HSPL . Now in the bootloader says SPL 0.85 OliMex; then i flashed the ROM and it showed me the progress bar in both system (PC and phone) but when it finish it booted back to the bootloader. I just noticed that sometimes (after been off for a while) if i turn it on it boots to the rom but it happens randomly and if I turn it back off i just got the bootloader again.
I really need your help pls
Click to expand...
Click to collapse
Hrm, have you tried doing a task29? Re-flash the ROM after task29.
yes already tried the task 29 and then flash the rom but the same issue...i've been reading a lot of post regarding issue with the bootloader and follow the instruction but nothing seems to work. I even tried the update from the AT&T site but the same issue...i have no idea what else to do
jsolanon said:
yes already tried the task 29 and then flash the rom but the same issue...i've been reading a lot of post regarding issue with the bootloader and follow the instruction but nothing seems to work. I even tried the update from the AT&T site but the same issue...i have no idea what else to do
Click to expand...
Click to collapse
So you've flashed the stock ROM? Have you tried relocking? Probably won't do much, but worth a shot I guess.
When you flash back to stock you flash the stock ROM, then relock, then reflash stock.
Yes, but the issue persisted.
I have noticed something. If i leave the cell phone turn off for a while (hours) and then i turn it on. Most of the time it works and all the things are fin; but as soon as i turn it off and turn it back on the bootloader starts appearing.
So, now i can use the cell but i cannot turn it off or leave the battery died on me...any suggestions?
BTW, thank you very much for your help
jsolanon said:
Yes, but the issue persisted.
I have noticed something. If i leave the cell phone turn off for a while (hours) and then i turn it on. Most of the time it works and all the things are fin; but as soon as i turn it off and turn it back on the bootloader starts appearing.
So, now i can use the cell but i cannot turn it off or leave the battery died on me...any suggestions?
BTW, thank you very much for your help
Click to expand...
Click to collapse
My phone is never turned off. I'm not sure what else to suggest, you've tried seemingly every step that could remedy this problem. Radio firmware probably won't help, but it shouldn't hurt either - you could try a new radio...
hi , this happened to me, solved it by reloading the rom again via sd, once it finish maybe you will see the bootloader screen again, so with stylus pres the reset buttom a few times until the rom boot , this can take several times to make it boot. after revive your cell , do a task29 then reload the rom again then do a hard reset, this happened to my 2 times, and its still alive ,good luck.
Same Problem
Hi,
I'm having the same problem. Installed the latest official ROM from HTC/ATT (gorgeous), and same problem after install. Whenever you try to reboot, it gets stuck in the bootloader screen. The last 50 tries it will not reboot at all, even after removing the battery and hitting the power button. This used to work occasionally.
Any other process anyone knows for getting the device to read the ROM?
Is the phone just worn out?
I suggest you reflash the shipped rom to your device and after the flash finishes and your device begins to boot immediately remove the battery to turn it off before it boots. Then replace the battery and press and hold the Send and End keys and while holding them down press the Power button and follow the instructions to factory reset(hard reset).
hi. i want to list what has happened to my htc and now it ended with black screen
1. i did an application update thru play store
2. it hangs and stays at the same screen for hours
3. i pull out the battery and turn it on
4. errors start to pop up and i cant get into the phone anymore
5. i do restoring the phone a few times but still it says that the ip is not the same
6. now it blanks on me
however when i turn it on and plug it into pc it still recognizes.
anyone can help on this? really need help. thank you.
Already reported this thread to be moved to Q&A so..
stankyou said:
Already reported this thread to be moved to Q&A so..
Click to expand...
Click to collapse
thanks. i am really very confused by this problem created
can anyone help on this please? thankssss!!!
haveVIn extinction
Have you tried to fully recharge your phone first?
Are you rooted? Are you able to get into recovery mode? Do you have a previous nandroid saved?
If you are not rooted, try rooting your phone, following the instructions posted here on the forum.
Hope your Desire works again.
So I just wanted to flash omega rom onto my T-Mobile i9505 galaxy s4. It worked, but the wifi didn't work, and it said that I needed to flash a file through odin. I flashed the file, but an error occurred in odin. Then, I unplugged my phone, and booted it into twrp recovery. All of a sudden, it asked me for a password, which I did not set. So I hit cancel, then did a wipe of the cache and user data. I then tried to go and flash an old rom, but all of my microsd card files were not there! The folders were showing up, but not the files. Then I tried to boot my phone and it wouldn't boot at all. After trying to install a stock firmware through odin, the phone turns on for 2 seconds, then shuts off. I can't get into recovery anymore either.
First, do you mean you have a T-Mobile M919 S4 and you tried to flash an i9505 ROM?
You are able to, but I want to just clear things up.
Let me write a little something, then we'll see if we can get you back to where you want to be.
- Sometimes when things don't go 100%, you gotta take a deep breath, step away and then go over the steps you took to get to the point of where the issue started. When in doubt on what to do next, youccan read around the threads on xda and other resources. After doing a little research and you still have doubt, just ask questions by posting the issue likeyyou're doing now.
The natural reaction is to fix the issue, and to do this and that without being sure. The combination of the latter with a little panic and perhaps not enough patience, can make matters worse. I'm not saying all of the above pertains to your situation, but some of the comments may, as they have to me during certain situations. Anyway, something to keep keep in mind for the future
Now to the issues at hand.
Can you get into download/ODIN mode?
Power down the phone and pull the battery.
Wait 10s and insert the battery but Don't power on the phone.
Hold power button & volume down button at the same time until the screen turns on.
When you've read the above, let me know if you're able to get your S4 into Download/ODIN mode.
Fixed
The problem was that the phone was just completely out of battery, and I was trying to flash the stock firmware onto it but it could not boot into it because there was no battery. Charged it, and could access recovery and the phone booted! Yeah I guess I wasn't patient and made a simple mistake. OP, Please close thread thanks!
bob10123 said:
The problem was that the phone was just completely out of battery, and I was trying to flash the stock firmware onto it but it could not boot into it because there was no battery. Charged it, and could access recovery and the phone booted! Yeah I guess I wasn't patient and made a simple mistake. OP, Please close thread thanks!
Click to expand...
Click to collapse
Ah, :good: to hear.
I sometimes forget to add that step and another into my tutorial/how to posts:
- Prior to ROM installation, please make sure you have at least 50% battery charge available.
- Please check your usb cable to be in good working order.
The above are 2 reminders are a of couple of the most overlooked steps prior to flashing ROMs and other associated goodies
Ok i have read a lot of threads talking about this but every link is either dead or goes to spam websites. Please help
I soft bricked the phone installing radios not it will not turn on. cant get to odin or bootloader. When i connect it to USB without battery it comes up OMAP4440 but cant find any drivers for it (again links are dead). I have the latest Samsung drivers but it doesnt help. Also the phone seems to be rebooting every 2 seconds (like other threads have said it would too).
I just need to be able to get into recovery or bootloader to flash stock. I can get it from there. Anyone have anything?
Edit: should not this is Sprint gnex with stock 4.2.1. CWM recovery has been installed. Its rooted and unlocked. Dont think it matters in this case but never know.