I ran XDA SER on my sx56 but it didnt unlock the phone. I never even got to the screen that says, "appears your sim is locked" I have tried running it several times with no luck....I have also tried XDAunlock with no luck. Any suggestions?
Now doing a little bit guessing.....
If I´m right, I´m the winner......;-)
I guess you have the radio stack 6.25.02 on your device......
Am I right?
I would say yes.... *yipiieh*
Take a look here:
http://wiki.xda-developers.com/index.php?pagename=Wallaby_HT_Unlock2
Stefan
Related
I am trying to unlock my new Orange SPV 1000 I have used the new XDAunlock to no avail, I successfully installed the new program on the device, ran it and got the message successfull repair!! However when I tried my vodafone sim, it asked for the unlock code!! I have tried several times with the sim in and without. Does this new program not produce an unlock code?
Ideas anybody?
Rom 1.60.00 wwe
12/03/03
Radio version 1.10.00
protocol version 1337.18
Ext rom 1.60.38
Same XDA II Problem
I have the same result. Just received an Orange M100 (XDAII) in UK at my office. Downloaded updated program, ran fine without any errors. Attempted to install my US T-Mobile SIM... asks for unlock code. The Orange SIM works fine. (When in US, need to use local T-Mobile SIM.)
Update program must need another update unfortunately. (Darn Orange)
Follow-up to previous post...
Forgot device details, apologies.
ROM Image: 1.60.00 WWE
Radio Version 1.10.00
Protocol: 1337.18
ExtROM: 1.60.38
Are you sure it isnt asking for the sim code rather than the phone code? You say you used xdaunlock, you should be using xda2unlock.
Response
I stand corrected... I was using the correct (XDA2UNLOCK) version. I failed to type the correct version in my previous post.
Yes, I'm confident this is not a SIM unlock prompt. It clearly states that this is a Network Provider Unlock prompt.
Thanks.
unlock
i also buyd a spv m1000 in switzerland an want to try a unlock.. so friends please help this man... 8)
Having just tried the lastest version of xda2Unlock, I'm having the same problem.
I copy the xda2unlock program and run it with my ORANGE SIM installed. It says all is fine and tells me to switch flight mode on and off.
I do that then take out the battery and install my Vodafone SIM. The M1000 then starts up showing "MY Info". the signal meter shows an exclamation mark and when I tap the screen it asks me for my normal SIM PIN. I put this in and the next screen says "Service Provider is locked, Please input unlock code" and has a box and an ok button.
If I try any number, including my SIM unlock code, it comes up with a box saying "Invalid Unlock Code" and it says "You have tried -2147467258 times, please wait until timeout..."
ROM version - 1.60.00WWE
ROM date - 12/03/03
Radio version - 1.10.00
Protocol version - 1337.18
ExtROM version - 1.60.38
Model Number of m1000 - PH10A
I hope you can help me as I'd really like to get this voda SIM working in it.
Thanks in advance
---UPDATE---
P.S. - Just W4XY's post in another thread from this morning ....
W4XY said:
Actually this is not completely true. There are two versions for unlocking an XDA 2. Unfortunately named the same (xda2unlock.exe), but they can be found in two separate threads in this subforum. Read the first post carefully. The latest version is: http://forum.xda-developers.com/viewtopic.php?t=6963
The newer version writes a lock 00000000 to the phone and then unlocks it. However, this process is still quite secure. I have had no report of a phone not working due to unlocking. All problems were in the end related to SIM cards not working (old or blocked) or the phone itself being blocked (insurance claim). One problem that still remains is that Orange phones do not seem to unlock (but the phone remains working normally). That is being worked on.
Click to expand...
Click to collapse
Good luck with sorting out the ORANGE phones....
hogansghost said:
Good luck with sorting out the ORANGE phones....
Click to expand...
Click to collapse
In the thread http://forum.xda-developers.com/viewtopic.php?t=6963 a new version of xda2unlock (version 2.2) has been posted that should perform better on Orange phones.
And thanks to me for posting the Orange M1000 ROM to you in the first place )))
Just joking, it works great guys, unlocked my M1000 in a few seconds.
Kev
X01HT from softbank
Hello guys,
I have same problem with the above topics, same with my HERME200 X01HT, I already have network unlocking code, but I can not enter the code, because it says.
"You have tried 35 times, please wait until time out" however, I've been waiting for 6days ago but still can not comes out. I still can not enter the code.
What would be the solution for this????
thanks for your sharings
Jhemzz
I just purchased a t-mobile sx56 which was supposed to be unlocked. I am in canada and need it for rogers.
It has XDA Special edition ROM ver 1.2 installed and in the bottom rt corner it says 3.17.
When I insert my sim it says Please input unlock code SID:
I have tried to hard reboot and have reinstalled the rom again and it just defaults to autoconfiguration setup where you can choose your country and provider.
I cannot get to a screen where it asks if i want to unlock the phone.
I have also downloded unlock prgs which i installed on the pda and they cannot unlock...something about wireless not being on.
Do I have to connect a serial cable? I ask because I have a laptop which does not have a serial input.
Any thoughts??? Help
1 Million Cudos for anyone who can get ths unlocked for me..
flamenko
I depends which version your wallaby currently is
http://wiki.xda-developers.com/index.php?pagename=UnlockWiz
My version of wallaby says 5.22...
Update
OkOk I have tried to cook a rom..no luck it still asks for sid unlock code. I have tried pretty much everything known to man. Mr radio version is 6.25 and I have been told there has been little luck with this radio version
CAN ANYONE UNLOCK MY XDA? Is there finally an issue that cant be solved by all the fine minds on this site????
You have to downgrade your Radio stack to Ver 6.24, then use the utility called XdaUnlock in this Forum, it will be OK
Hi!
Well i'm new in this forum. Thanks to the ones who are viewing this.
This is what happened:
I brought 3 Siemens SX56 from the US. 2 locked to AT&T (windows 2002 installed), one locked to T-mobile (windows 2003 installed).
As the bootloader was originally 5.22 for the three of them, I did the typical unlock supplied by XDA DEVELOPERS (replacing the original flash with the XDADEV flash and running xdaunlock.exe)
That worked fine with both AT&T units which are already unlocked.
However the T-mobile one refuses to give me the unlock codes when i open xdaunlock.exe (error getting unlocked codes)
For what i've been reading, this is most likely because win2003 was installed in this one and i heard it's harder to unlock. But that's just what i heard.
Could anyone help me unlocking it?
I really appreciate!
Thanks!
Nicolas.
Ps: you can contact me to [email protected]
:x hi, thanks for xda unlocking software. i can't seem to unlock me xda II. i have the new XDA 2i.
Read:4, ooFF ( o meaning square)
Failed to do magic
search this forum for steps on downgrading ur rom to 2002 or even better is to just load the XDA-Developer rom onto it and it'll unlock it. then after that switch back to your original rom
remember to use xda tools to backup ur original rom on ur computer first!
Reply
Thanks a lot for your response
I already did that. I downloaded the roms from the at&t sx56 and loaded from sd card. The reason i did this is because the xda developers rom wouldn't let me run the upgrade with ppc2003 on it (a usb connection error was displayed)
I installed the 2002 ppc software and after that, i upgraded directly via ActiveSync.
Still i could not get the unlock codes (same error: error getting unlock code).
That's why i need help. Thanks!
interesting havent heard that one before.. have you tried downgrading to another t-mobile 2002 rom and then after that installed xdadev rom? or maybe downgrade the bootloader?
hi
i have same problem as nikoleman
i have a T-mobile pocket pc (i think it is WM2003 beta)
Pw10b1
rom version:4.00.16 ENG T-Mobile
with wallably 5.22 bootloader
i downgrade the bootloader to 5.15 and
the rom to 3.17.03 ENG cooked in kitchen
now infrared is not working and still get error getting unlock code
any help plz
yep
in fact that's the only way it would let me do it.
I backuped rom from the at&t ones and writed it to the t mobile. Then upgraded to XDA DEV special edition and it still throws me the "error getting unlock code" error.
Do you know why might this be?
Hi
I have an XDA 1 and when I try to unlock I get error : Error Getting Unlock Code
xda info
ROM Version 31.17.03 eng
ROM Date 05/15/03
Radio Version 4.21.02
Protocol Version 32S54
can any one help me to unlock it
Thanks
PayableOnDeath
please somebody help me
I guess you have tried the xdaunlock program.
Maybe it doesn´t work with your Radio Version (4.21.02)
You could try the xda manipulator and a serial cable or try downgrading your radio stack...
Stefan
LumpiStefan said:
I guess you have tried the xdaunlock program.
Maybe it doesn´t work with your Radio Version (4.21.02)
You could try the xda manipulator and a serial cable or try downgrading your radio stack...
Stefan
Click to expand...
Click to collapse
do you know where can I get a Serial cable from? (in uk)
and how do downgrade the radio stack?
PayableOnDeath said:
do you know where can I get a Serial cable from? (in uk)
and how do downgrade the radio stack?
Click to expand...
Click to collapse
For cable try ebay. Should not cost much...
For downgrading read this:
http://lumpistefan.dyndns.org/tools/manual2_unlock.htm
But downgrading is very dangerous. I would try unlocking via serial cable....
HTH
Stefan
Hi
Just a Thought does it need a o2 sim in it n the phone part on to get it to work?
thanks
PayableOnDeath
I upgraded to radio 6.24.00 it unlocked fine but I have got No Signal anymore not even on the O2 card the came with it
Please Help me fix it so I get a signal again
Thats the wrong radio for your phone I think. That was not a good move but there maybe a solution, have you tried flashing back to 4.21?
just tryed that this morning
and it worked
also its still unlocked
so now am running a custom rom and unlocked it
I wont have done all this if the battry haddnt of n flat n lost every thing lol
since it was wiped i thought whatthe hell give a go
Thanks LumpiStefan for your great site with the all the tools on, I get paid a week on thursday so on payday keep an eye on your paypal :wink:
oh and also XDA Developers for this great site too
now all got to do is find out how to remove all the active parterships from my pc so i can reuse the old name i had on lol
Here's question..
I have a Blu Angel (obviously) and updated all the system and radioo and extended ROM all with great success and also used you unlock program and it told me the phone was unlockd and stuff. But then ... now the phone part won't work. Everything is running smooth except it tells me "invalid or missing sim" I've tried both with my cingular/at&t card and my sim from denmark.. nothing seems to work.. anybody seen this before or would know what it would be??
Make sure your SIM is inserted correctly. I had the same problem when I replaced the housing on my phone.
PS:
Did you reset your phone after you unlocked it?
danbjergby said:
Here's question..
I have a Blu Angel (obviously) and updated all the system and radioo and extended ROM all with great success and also used you unlock program and it told me the phone was unlockd and stuff. But then ... now the phone part won't work. Everything is running smooth except it tells me "invalid or missing sim" I've tried both with my cingular/at&t card and my sim from denmark.. nothing seems to work.. anybody seen this before or would know what it would be??
Click to expand...
Click to collapse
run the unlock application 3-4 times and u will get it unlocked. it happens eith me too.
krishan2207 said:
run the unlock application 3-4 times and u will get it unlocked. it happens eith me too.
Click to expand...
Click to collapse
Whats the best unlock prog for the MDAIII Please?