I was trying to flash the latest firmware during the odin process, the flash failed in odin and then showed "Emergency Recovery Screen" in the screen phone after that I turned off the phone...After that the device "never worked", I tried to do all the solutions, but I did not find the solution to turn on the device, please help in solving this problem.
Note: I opened the device, "disconnected the battery cable and returned the cable", but the device did not work.
Related
So i recently updated to 4.3 on my i747 and i wanted to do an emergency firmware recovery, so i go to Kies and follow the steps, whenever i plug in my phone no matter what port windows will say device had a malfunction last time it was entered, but in kies i can still do the emergency recor but then it stops and says device not pulgged in gives me a note f error and tells me to reinstall drivers and restart my computer. Ive done that several times i even uninstalled and installed Kies but it wont work. Whenever i try to turn my phone back on it says: firmware upgrade encountered an issue. Please select recovery mode in kies and try again. Well i did that but it still wont work. I've unrooted my phone a while back ago and the stuff at the top left corner of the screen says:
Odin Mode
PORDUCT NAME:SGH-I747
CUSTOM BINARY DONWLOAD:YES (4 COUNTS)
CURRENT BINARY SAMSUNG OFFICIAL
SYSTEM STATUS: OFFICIAL
QUALCOMM SECUREBOOT:ENABLE
WARRANTY BIT:0
BOOTLOADER AP SWAEV: 2
what do i do please i need help. Thank you in advance
So I'm an idiot. I was attempting to upgrade from 2.3.6 to 4.0.4 on my (rooted) SGH-T989 Samsung Galaxy S2 Hercules, flashing in Odin 3.07, but placed the .tar in the CSC place instead. Now, I can't even access recovery, my phone instantly boots up into Firmware Upgrade Encountered an issue screen. By an off chance, my phone connected and was detected by Odin once. However, in my attempt to revert to a stock rom, it failed. Now Odin AND KIES won't recognize my phone. I have attempted to re-download Odin/drivers and restart phone/computer. I have tried different drivers. Any help would be much appreciated.
Hi,
If your device is showing up in you PC's device manager as QSUSB_DLOAD or similar... You are bricked, and likely need a repair center to fix it.
I will have your thread moved to your device section for other opinions.
Good luck!
I have been checking the site for almost any issue that i had and I always got a solution, but sadly this time I didn't find anything (probably due to being too busy to make time for searching)
unfortunately the device does not boot at all, it stops at the samsung logo
I cannot go into recovery in order to wipe data or cache
I can go into download mode, but odin cannot get past the initialization and sometimes stops at connection setup. Tried to install TWRP and clockwork but both did not install.
I heard that knocking the phone on the power button side may be of help, but it did nothing
I also left it on the samsung logo for almost 8 hours but still no luck.
Is there anything left to test? am i doing something wrong?
I had almost same situation before due to trying to root my gt-i9192 abd it was solved by samsung kies
Install kies not kies3 and cinbect your phone then go to firmware recovery menu and follow the instructions usually it will ask you to enter device name in capital letters then serial number and it will install complete stock room which is 4.2.2
I have installed Kies 2.6, 2.5 and other older verions. When I enter the model, Kies does not accept it
At the sticker behind the battery the model is GT I9192 but Kies does not accept it
...and is locked. Call your mobile operator for additional support.
I have a Tab S4 (SM-T830) and a while back I tried to root it unsuccessfully. It still worked, but I could not get it to update. Today I tried to update through Smart Switch, and that didn't work as it required I get into recovery mode, but I couldn't since I had TWRP installed. So I went into developer options, and turned off OEM Unlock, the tablet informed me that it would do a factory reset. Now, I get the above message whenever I try to turn it on.
What's worse is I can still get to the download screen on the tablet, but whenever I try to flash the stock ROM with Odin (I've successfully used Odin many times in the past), it sits at the message 'Setup connection" for several minutes, then fails with the error "Can't open the serial (COM) port. I'm really at a loss what to do with this tablet, it seems to be bricked. I loved my Tab S, but this thing has been nothing but trouble.
If there's anyone that has any suggestions, I'd be very grateful.
Thanks!
Mark
I have a Galaxy Tab3 7.0 SM-T210 that we've owned for a long time, but I now want to use it for more things and find it a little clunky and slow compared to our more up to date smart phones. So i wanted to flash with a newer version of Android, but the tablet now appears to be bricked showing the "Firmware upgrade encountered an issue. Please select recovery mode in Kies & try again" screen and it won't do anything else. It won't enter download mode or recovery mode.
I came across these instructions to take me from a stock tab, and upgrade to Android 9.0 theupgradeguide.com/2019/09/17/install-android-9-0-pie-on-samsung-galaxy-tab-3-7-0-lineageos-16-how-to-guide
I loaded TWRP successfully using Odin and was able to set up a Nandroid backup. I then moved on to part 5 to perform a factory reset of the device, which was successful. This is where it started to go wrong though! I chose the reboot option after the wipe, rather than as per the instructions going back to the TWRP main menu. The tab rebooted and would't get past the Samsung logo. It went back in to download mode when I tried, and then tried to flash with a stock version of KitKat Android. Odin recognised the tab connected, it accepted the .tar flash file, and the tab showed the progress bar showing the download happening. Then Odin failed after a few minutes, and then the firmware upgrade failure error message appeared.
After lots of internet searching I've tried the following:
1. Putting it in download mode, doesn't work!
2. Putting it in recovery mode, doesn't work!
3. Connecting it to Kies, device not recognised and latest version of Kies doesn't have the option to manually select your device to reload the firmware!
4. Tried using ADB, device isn't recognised!
So i'm at a loss what to do to fix it, can anyone help?!
I was just trying to do the same yesterday. It all went fine with backing up and wiping, but TWRP didnt accept the image I downloaded.
It is so sad to have a capable hardware limited due lack of manufacturer care (not even saying updates, because they updated the android version at the time, but lack of optimization and how my tablet became sluggish, gave me disgust of any samsung branded device).
Can't you get to TWRP screen anymore?
If you can get to Odin download mode, trying reflashing Odin (perhaps a different version).