I actually don't like the edge. I find it is too easy to interfere using my phone and have to hold it too carefully to avoid it.
I would like a very slim case that also blocks the edges as I don't use the edge features.
Anyone?
doesnt seem that any case maker will make a case that perhaps only a handful of people may use
wont seem like a wise business decision
I highly doubt it. I have an Incipio case and the sides stand off enough I never really accidentally touch the edges while holding my phone.
Horem said:
I actually don't like the edge. I find it is too easy to interfere using my phone and have to hold it too carefully to avoid it.
I would like a very slim case that also blocks the edges as I don't use the edge features.
Anyone?
Click to expand...
Click to collapse
I have this case. It sort of blocks the edges of the screen.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Just turn off your edge panels, or move it to the left side
Sjaool said:
I have this case. It sort of blocks the edges of the screen.
Click to expand...
Click to collapse
Blocks the speakers too, will sound very muffled.
Speak presidio grip raises the side over curve.
Related
Just wanted to post this in case anyone else had done this besides me (it was stupid on my part so don't laugh)...
I had purchased the 3-pack screen protectors from the AT&T store a while back for $9.99. I had installed one of them and it was smooth, but didn't quite feel right. I used it for a while and then I began to see small scratches and wondered why it scratched so easily. This started to distract me because I like the look of a "clean" screen. So I decided to remove the protector. Well, when I went to remove it, I realized that when I installed it, I must've only removed the sticker tab applicator thingy in the corner and not the whole protective sheet. So what was scratching was only the protective sheet, not the actual screen protector! I removed the protective sheet to expose a nice, new, smooth screen protector! I know, I'm an idiot. Just wanted to let anyone else out there know to check this in case they notice theirs scratching easily and wondering why... Oh well, you live and you learn...
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
imb951 said:
Click to expand...
Click to collapse
gotta love the asshats!
now as for a reply:
i use the at&t ones as well and i love them. Very glass like feel to them!
I just bought this case and it looks great and could of been a great case. The only problem is that it doesn't fit the phone. Th SGS2 has wiggle room and moves inside the case. You can also pull it out easily, and it creaks when you hold it. I don't know if its just my case or a production problem.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
falconeight said:
I just bought this case and it looks great and could of been a great case. The only problem is that it doesn't fit the phone. Th SGS2 has wiggle room and moves inside the case. You can also pull it out easily, and it creaks when you hold it. I don't know if its just my case or a production problem.
Click to expand...
Click to collapse
The cut-out in one corner indicates that it's probably designed for the Korean version of the phone, which is slightly thicker, hence the wiggle room you describe.
Yup, that corner is where the antenna is on the Korean version.
Thanks for the info after the fact
What case is it?
zxz88 said:
What case is it?
Click to expand...
Click to collapse
I'm assuming it is an SGP case.
I like the idea of the flip case but the Nillkin TPU case I think will provide more protection other than a screen. I find the phone to be slippery without a case and therefore with the flip case I think it will pretty much will be the same (maybe not). Can you give me some pros and cons of each?
I have the flip case.
Pros: Looks good, no bulk
Cons: No protection from the sides or back, nothing holds the cover to protect the screen if dropped. Finally, the glue on the sides starts to wear out, the skin becomes lose with use. I posted a pick of it earlier
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
tamarian said:
I have the flip case.
Pros: Looks good, no bulk
Cons: No protection from the sides or back, nothing holds the cover to protect the screen if dropped. Finally, the glue on the sides starts to wear out, the skin becomes lose with use. I posted a pick of it earlier
Click to expand...
Click to collapse
Thanks, I ordered the Nillking case. It's cheap enough that I can always get something else if I don't like it. Thanks again.
Do this...You can have both
http://forum.xda-developers.com/showthread.php?t=1382188
Yes,take both, and use either depending on where you are.
thanks .
Sent from my PG86100 using Tapatalk
Anyone know a bag which has enough room to hold an s3 with a mumi tpu skin case? I really need the skin case because at work and at home I want to see the phone and especially the notification led, but to carry it I want some good protection against dust and dirt. A screen protector is not an option for me. Thanks for any hints and pointers!
I was just thinking about this after i got back from golf and having the phone in the cart it got dusty. I'm probably going to use the cloth bag that you get when you buy a bottle of Crown Royal. It's free and pretty lightweight although i don't know how smooth the insides of those bags are.
Yea something like this would be really handy... It needs to be a snug fit tho. I guess it wouldn't be too hard to make with the right material although surely someone's making something like this already?
Just for completeness I've now got this sleeve. The s3 lurks out about 2mm which I can live with. I finally did apply a scree protector (dipos crystal clear) so I think I'm fine now.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
So I placed an Order for a Custom Printed HTC One Case.
http://www.case-custom.com/htc-one.html
It looks like it's printed onto the case apposed to the POS Sticker Cases you find for the iPhone, lets see how long it lasts.
Taken with my HTC One
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Taken with my Samsung Galaxy Tab 3
I'm really tempted. How well does it fit? Does it seem like it would protect the phone well? How bulky?
stevedebi said:
I'm really tempted. How well does it fit? Does it seem like it would protect the phone well? How bulky?
Click to expand...
Click to collapse
It fits great almost too good kind of a pain to take the phone out of it, it's extremely slim.
Only one Gripe about it is the top and bottom only go a part of the way up the phone, and the headphone port is sharp, I feel they should of rounded off those edges and corners
I have been looking for exactly like this. But the durability is a little concern, feel free to post some updates that how it lasts.