[Hardware] Earpiece Issue - One (M8) Q&A, Help & Troubleshooting

I have a very strange issue with my HTC One M8 and it is driving me nuts. When i take the housing off my phone the earpiece works but when i put the housing on the earpiece stops working. I found out that if I apply a little tiny bit of pressure on the "sister motherboard" where the earpiece is it stops working and as soon as I release my finger it works again. Any ideas?
I was thinking about using some sort of adhesive.

Bump.

Related

earpiece

i just thought i'd post this.
i had a problem with low earpiece volume with my desire. i ordered a new earpiece and when it came i took the phone apart.
upon doing so i noticed the mesh in front of the earpiece had alot of dirt and dust clogged into it.
it was the same on the actual earpiece itstelf, there was alot of dirt and dust covering the front of the earpiece itself.
i cleaned it all off and my earpiece volume is back to how it was when i purchased the phone, but because i had purchased a new earpiece i fitted it.
it is probably worth buying a new one for the sake of about £6.
hope this helps anyone with the same problem...
thanks, always nice with tips like this :>

Dropped G2, Now Speaker sounds weird

Hi everyone.
I accidentally dropped my phone as I was getting out of my car (damn that new coat with all it's pockets!).
Now I noticed that at full volume, the speaker is really hard to understand, and at about 1/3 volume it becomes clearer- but the person becomes harder to hear in terms of loudness.
At full volume it's as though the person on the other side is talking with their lips on the mic and really loudly.
Does anyone know if it's possible to replace the speaker, or what could have caused this? I am familiar with taking the phone apart. I've done it a number of times, but I'm just wondering if it even makes sense to try at this point.
thnx
EDIT: I found this.
http://www.repairsuniverse.com/htc-desire-z-earpiece-speaker-replacement.html
anyone install one of these? requires desoldering, I guess?
I dont think it requires anything really besides opening. I believe that when I swapped my spring the speaker is on the back side of the phone and the entire motherboard is seperate on front side.
thanks scott.
you're correct. no soldering. it has two spring-bent type contacts and it looks like there is a metal bracket around the speaker that has 4 indentations to hold the speaker down over 4 small cavities in the speaker body.
should be easy.
and i found it for 2 bucks to boot!
Yea, replacing the speaker is very easy. First take off the back (4 screws) and then I think there is one more screw to get the speaker loose. But I don't remember exactly. Might be none.

Ren, now earpiece vibrates / rattles during call?

I had to replace the screen and digitiser on my TP2 after shutting it in the boot of a car (clever huh?). I accomplished the swap surprisingly easily after buying a pre-built screen and digitiser from Hong Kong for about £25. It even came with a spudger to help me take it apart I followed a few guides, including this iFixit one, which greatly helped.
Frustratingly though after putting it all back together and making a test call, the earpiece rattles during calls. Not a lot, but enough to make me want to fix it; applying gentle pressure to a certain top part of the bezel reduces the rattle a little bit but I've taken it apart three times and taped up various sections now to see if stops the problem. Unfortunately, no such luck.
Is the earpiece rattle something to do with inadequate insulation (or the ribbon cable running down the back of the screen)? Everything's sandwiched in pretty tight and I've reapplied electrical tape to what I think are the key areas. I've also padded the top area where the earpiece comes through the metal mesh and I've stuck the mesh down with doublesided tape so it can't move about. The problem persists though...
Everything else works fine, and the speaker also works perfectly with no vibrations or rattles (even though I also took that bit apart to inspect it) so I can't figure out why just the earpiece is rattling. Anybody taken their Touch Pro2 apart, had the same problem and solved it?
I have torn apart probably 3-4 TP2 screens and never had anything rattle. Did you lose a screw in there by chance? That is the only thing that would be small enough to rattle in there I think.
The only other thing I could thing that it might be is a bad connection to the vibrator motor. Maybe you have the little ribbon cable pinched or a bit off the socket it fits in.

Galaxy Note 3 Mic issues

My galaxy note 3 mic doesn't work when I try to talk on a call or using Google now. It does work when I record a video so I am wondering if there is multiple mics and what mic would I need to replace for talking on my phone.
Thanks!
Bump
Bump
Have you contacted Samsung support? If a mic is not working it sounds like a hardware defect.
Same problem - How I resolved it
Sorry for bumping a kind of old post, but anyway...
I had the same problem with the mic not working on my note 3 since the day i bought it, I bought my Note 3 used off Craigslist, and when I got home I realized that the microphone didn't work on calls, but worked just fine on speaker phone. I was somewhat annoyed by this, thinking I got screwed on craigslist again. But instead of throwing a fit about it, I just ordered another charging port / microphone thinking that would solve the problem. I installed it when it arrived, all excited like, only to find out that this didnt fix the problem. I read several posts on this forum and others, many offering what seemed to be viable solutions, disabling noise reduction, cleaning out the mic hole with a pin and so on, none of these worked, the problem still continued.
So tonight I set out on a mission to find the cause of the problem and i did just that... I started by taking my phone apart so that I could clean the mic hole from the inside as well as cleaning the little screen / filter on the inside of the mic hole and stuff like that, I was working in an area that had awkward lighting (my patio), and so I was having to move the phone in different ways so I could see down around the microphone, while doing that I noticed the light glimmering around the area of the mic hole, on the inside, I looked a little closer and I could see that there was definitely something there. I picked at it with my tweezers and what came up, a piece of clear plastic that resembled the plastic you find wrapped around the edges of new electronics, it was about 1/8in wide and 1" long, and it was covering the mic hole.
After removing the plastic, I reassembled my phone and tested it, now the mic works great. it seems that samsung put this thin plastic there to keep things out of the microphone, and it works well, it keeps everything out of the microphone, including the sound of your voice..
Now my Note 3 is what it was supposed to be from the day I bought it, an awesome phone. Prior to tonight its been a regretful purchase and disappointing upgrade to my Note 2, which I had regretted getting rid of, until now...
My note 3 microphone not working
Hi the same problem.as.from.previous comments could.you.please explain how you.cleaned ur microphone out so.I can see if it works I changed the microphone and still no luck kind regards
Picture of the problem area?
wallyb132 said:
Sorry for bumping a kind of old post, but anyway...
I had the same problem with the mic not working on my note 3 since the day i bought it, I bought my Note 3 used off Craigslist, and when I got home I realized that the microphone didn't work on calls, but worked just fine on speaker phone. I was somewhat annoyed by this, thinking I got screwed on craigslist again. But instead of throwing a fit about it, I just ordered another charging port / microphone thinking that would solve the problem. I installed it when it arrived, all excited like, only to find out that this didnt fix the problem. I read several posts on this forum and others, many offering what seemed to be viable solutions, disabling noise reduction, cleaning out the mic hole with a pin and so on, none of these worked, the problem still continued.
So tonight I set out on a mission to find the cause of the problem and i did just that... I started by taking my phone apart so that I could clean the mic hole from the inside as well as cleaning the little screen / filter on the inside of the mic hole and stuff like that, I was working in an area that had awkward lighting (my patio), and so I was having to move the phone in different ways so I could see down around the microphone, while doing that I noticed the light glimmering around the area of the mic hole, on the inside, I looked a little closer and I could see that there was definitely something there. I picked at it with my tweezers and what came up, a piece of clear plastic that resembled the plastic you find wrapped around the edges of new electronics, it was about 1/8in wide and 1" long, and it was covering the mic hole.
After removing the plastic, I reassembled my phone and tested it, now the mic works great. it seems that samsung put this thin plastic there to keep things out of the microphone, and it works well, it keeps everything out of the microphone, including the sound of your voice..
Now my Note 3 is what it was supposed to be from the day I bought it, an awesome phone. Prior to tonight its been a regretful purchase and disappointing upgrade to my Note 2, which I had regretted getting rid of, until now...
Click to expand...
Click to collapse
Hi, thanks for great troubleshooting.
I was hoping you have a picture of the problem area, since I have an issue with my speakerphone. People cannot hear me properly when on speakerphone. I may have to fix the microphone as well on my good old Note 3.

[Q] No sound in call

Hey guys,
I am having problems with a htc one x after repairing the display and digitiser.
First of all the repaired worked like it should but I noticed the top and bottom speakers didn't work afterwards... So I opened it up again and noticed that I placed a piece off tape over some connectors of the speakers at the bottom, so I removed it and i had sound again, but now for some reason there is no sound while calling... Anybody knows if the call speaker is the same as top speaker and which connectors are used for the call speakers? Cause there is no sound at all... Although the other side of the call does here everything, so the mic is doing fine.
Greetings
FGOD
Nvm, problem solves, i forgot to take out the earphone from the old casing for the screen and place it in the new casing
Sent from my iPad using Tapatalk

Categories

Resources