Hello, while i was replacing my screen i lost all of my screws
Anyone know what type of screws are in HTC 8S ? or What Size?
Searched a bit but there is nothing about screws for HTC 8S, only Torx T5 ...
Related
Hi Guys,
When my plane landed today and I turned on my S630 i was greeted with a broken LCD, so am needing to replace it.
On Ebay I notice there are lots of dash/S620 LCDs available and I found one online site that lists one screen for the 620/630/dopod 720 so was hoping that I could grab a 620 screen and be done with it.
Can anyone confirm or reject if this screen will work?
Thanks
Gordo
(Unfortunately I don't have a small torx driver handy so am not able to pull the 630 apart to check the part number at the moment)
I broke my LCD during a housing swap, switching from black to the softbank burnt orange housing, purchased an S620 replacement screen off ebay, and it worked fine, actually I think it's brighter, crisper, and has better color than the original
finally have replaced my screen and after having some issues due to the front metal bezel lifting off which then meant that the first replacement screen I got (a dash or s620 screen) did not fit, so i then found a specific S630 replacement on ebay and had the same issue and tried a little harder to remove the bezel and then was able to install the new screen.
The other issue I had when disassembling the phone was that there is a screw below the camera which i broke while removing the rear housing, so i'm not sure what the correct method is for removing it.
Gordon
uses same lcd as S710/SPV E650/DOPOD C730
Hello I'm new here. My name is Damir and I have HTC touch pro 2 T-Mobile nice phone
I have few questions
I have problem with flex cabel, I want to chage it but I can't find to buy. Is the same flex like in HTC tilt 2?
I have problem with housing, cracked at the corner. I can't find anywhere to buy used (secondhand) or new one. I wonder can I put housing from HTC Tilt 2 and change touchscreen (digitizer not display) or I must find original housing ((
Help plsss ))
no one? If someone has a defective cell phone I would like to buy (with undamaged housing)
touch-pro2 said:
Hello I'm new here. My name is Damir and I have HTC touch pro 2 T-Mobile nice phone
I have few questions
I have problem with flex cabel, I want to chage it but I can't find to buy. Is the same flex like in HTC tilt 2?
I have problem with housing, cracked at the corner. I can't find anywhere to buy used (secondhand) or new one. I wonder can I put housing from HTC Tilt 2 and change touchscreen (digitizer not display) or I must find original housing ((
Help plsss ))
Click to expand...
Click to collapse
The Tilt 2 housing might fit. I compared an ATT one to tmobile one and it looks like the AT&T has an extra small button on the side but it doesn't look like it's big problem. I didn't check the flex yet. If you want to buy an ATT full housing you'll need one that has the middle frame with it, the one that the motherboard snaps into. There are some out there that don't have it.
So I need Full housing from tilt 2, digitizer (touch screen). The display, motherboard, flex, and everything else inside is the same, all the rest will fit
touch-pro2 said:
So I need Full housing from tilt 2, digitizer (touch screen). The display, motherboard, flex, and everything else inside is the same, all the rest will fit
Click to expand...
Click to collapse
It looks like it might, but I can't guarantee that it will. Here is an original tmobile housing but it'stoo expensive: http://www.htcrepairparts.com/full-coverhousing-for-htc-touch-pro-tmobile-p-2886.html
It is expensive :/ it not be bad to try to install this housing of tilt 2 but I'm afraid it won't fit, speaker, front key, display and rest :/
Does anyone ever put HTC One (M7) LCD into HTC One Dual SIM (802w) or can confirm that they use the same LCD? I just recently saw HTC One Dual SIM (802w) with cracked digitizer being sold very cheap. I did some research in the internet and seems like both use the same LCD piece as they seem to have the same cable size and connector position, but use different size of digitizer, also have different dimension. If they use the same LCD then I will try to separate cracked digitizer and replace with new one, if separation breaks LCD then I will buy HTC One (M7) LCD and put it into HTC One Dual SIM (802w) as its price seems to be cheaper than the other.
Thanks in advance.
I've just replaced my HTC One M8 digitizer assembley and the phone will not boot up and just displays a rainbow array of pixels covering the screen.
Does anyone know what might cause this. Before I replaced the screen I replaced the SIM card assembly and tested before I reassembled the phone. In the process of re-assembly I tore the ribbon that was attached to the screen, hence the need for a new digitizer assembly. I've checked over and over to see if there's a loose cable or damaged part but to no avail.
Can anyone give some advice?
Regards, Mark
Hello everyone,
I recently began repairing my old HTC 10 and was trying to find an earpiece speaker replacement to finish my revamp. I recently bought a supposed HTC 10 earpiece from WitRigs but the part is completely wrong and doesn't fit at all in the midframe housing. Now i'm stuck and stumped on where to get a real part. Is there anyone here with experience replacing this part on their phone? Any tips on buying legit HTC 10 batteries would be amazing too.