i tried rooting my phone .. now it wont get past the model number screen that shows up when u power on ur phone .. it just stays there .. it has cmw i tried factory reset and formatting cache.. yet nothing seems to work .. what should i doo
trexhdr said:
i tried rooting my phone .. now it wont get past the model number screen that shows up when u power on ur phone .. it just stays there .. it has cmw i tried factory reset and formatting cache.. yet nothing seems to work .. what should i doo
Click to expand...
Click to collapse
Don't Panic Just follow these steps
1) Press VOL DOWN+POWER+HOME Button till Logo is displayed once displayed release the keys
2) U will be Warned Just press Vol UP key to continue
3)Connect it PC...Open Odin
4)Just flash the OFFICIAL FIRMWARE
5)Reboot to Stock Recovery
6) Factory RESET
7) DONE:laugh:
Related
What should i do , i was trying to apply CM7 , and after probably failing , i ended up with red motorola logo , and then i somehow founded this.
Please help , my phone is only 3 days old.
It doesn't show any error , screen says:
Battery OK
OK to Program
Transfer Mode:
USB
sLvW said:
It doesn't show any error , screen says:
Battery OK
OK to Program
Transfer Mode:
USB
Click to expand...
Click to collapse
the above means u have entered bootloader...this is useful when u r flashing an sbf..
power on the phone with vol down button..u will enter stock recovery,,now press vol+ and vol- at the same time..here u have to clear cache and all.and reboot..
if u r still stuck at M logo then reflash an 2.2 sbf and then install CM7..
for more info follow FAQ for CM7 quarx
All the best
"on the phone with vol down button..u will enter stock recovery," I can't enter this, Either i'm not able to , or if it has something todo with phone , i dont' know. ;\
remove the battery and reinsert it..
and while powering on the fone, hold the vol down button...(hold the vol down button and then press power button)
sLvW said:
What should i do , i was trying to apply CM7 , and after probably failing , i ended up with red motorola logo , and then i somehow founded this.
Please help , my phone is only 3 days old.
It doesn't show any error , screen says:
Battery OK
OK to Program
Transfer Mode:
USB
Click to expand...
Click to collapse
I followed this guide and was successful due to prior knowledge to modding fw for symbian phones and a little bit of android ..
In my attempt to install cm7
i enter boot loader ,flash sbf
and then install cm7 using clockwork recovery method and gapps
If u dint understand even one thing i said above ..i'll be glad to help u step by step
Hey Guys I hope someone can Provide me with a piece of an advice, i flashed my samsung i8150 using odin with firmware I8150XXLM6_I8150OXXLC1_XSK, everything went fine , but after i flashed my phone the touch screen is not responding anymore, im not able to click on the menu key the recovery mode or anything the whole thing not working , system boots normally , it's just the touch screen not responding, is it a software issue or my phone just got bricked?
kill2blade said:
Hey Guys I hope someone can Provide me with a piece of an advice, i flashed my samsung i8150 using odin with firmware I8150XXLM6_I8150OXXLC1_XSK, everything went fine , but after i flashed my phone the touch screen is not responding anymore, im not able to click on the menu key the recovery mode or anything the whole thing not working , system boots normally , it's just the touch screen not responding, is it a software issue or my phone just got bricked?
Click to expand...
Click to collapse
So before you flash the files everythings working fine right ?? Try flash the ClockworkMod >>> http://forum.xda-developers.com/showthread.php?t=1446593
After you flash the CWM , boot into it (volume up + home key + Power) from there you can select the command without using the soft keys. wipe data/ factory reset, cache partition, Dalvik cache and try again . Hope this help
kill2blade said:
Hey Guys I hope someone can Provide me with a piece of an advice, i flashed my samsung i8150 using odin with firmware I8150XXLM6_I8150OXXLC1_XSK, everything went fine , but after i flashed my phone the touch screen is not responding anymore, im not able to click on the menu key the recovery mode or anything the whole thing not working , system boots normally , it's just the touch screen not responding, is it a software issue or my phone just got bricked?
Click to expand...
Click to collapse
Are the physical keys such as select, power, and volume buttons working properly after booting? Do u mean the whole touch screen or just the menu and back button at the bottom?
Help..i have same problem..
i too have the same prob
yewsiong said:
Are the physical keys such as select, power, and volume buttons working properly after booting? Do u mean the whole touch screen or just the menu and back button at the bottom?
Click to expand...
Click to collapse
i hav d same problems..
for the touch keys, ie the menu button and the back button.
please help..
thanks in advance:crying:
kill2blade said:
Hey Guys I hope someone can Provide me with a piece of an advice, i flashed my samsung i8150 using odin with firmware I8150XXLM6_I8150OXXLC1_XSK, everything went fine , but after i flashed my phone the touch screen is not responding anymore, im not able to click on the menu key the recovery mode or anything the whole thing not working , system boots normally , it's just the touch screen not responding, is it a software issue or my phone just got bricked?
Click to expand...
Click to collapse
I think it's your phone's way of saying to always make a clean install of any ROM.
Try this:
1. since I suppose that now you don't have CWM Recovery anymore, download it from here and install it via ODIN, just as you installed the stock ROM.
2. enter CWM and make sure (double check) that you follow all of the steps below:
select "wipe data / factory reset"
go to "mounts and storage" and select "format /system". This is extremely important!
on the same page, select "format /sdcard" (be careful not to format external_sd by mistake).
3. flash stock ROM via ODIN
I've recently got the JB update so I installed it, or atleast tried. Because when I try to turn on my phone again it gets stuck on the HTC logo (White screen).
I think somehow my battery went down during the installation and now I can't access my phone anymore.
It's a clean phone, no costum ROM and I haven't rooted it in any way.
Is there a way to fix my problem? (Preferably withour rooting it.)
I tried holding the power and volume down buttons and then selecting recovery but that doesn't work as I just end up getting stuck on the black screen with the Red triangle.
Regards
Sarcks
Sarcks said:
I've recently got the JB update so I installed it, or atleast tried. Because when I try to turn on my phone again it gets stuck on the HTC logo (White screen).
I think somehow my battery went down during the installation and now I can't access my phone anymore.
It's a clean phone, no costum ROM and I haven't rooted it in any way.
Is there a way to fix my problem? (Preferably withour rooting it.)
I tried holding the power and volume down buttons and then selecting recovery but that doesn't work as I just end up getting stuck on the black screen with the Red triangle.
Regards
Sarcks
Click to expand...
Click to collapse
Try going into HBOOT
Hold down Power button & volume down buttons together when the phone is switched off. This will take you into HBOOT.
Select Recovery using the volume down button and press power to select it.
Hopefully it is able to recover and re-flash the firmware.
nookcoloruser said:
Try going into HBOOT
Hold down Power button & volume down buttons together when the phone is switched off. This will take you into HBOOT.
Select Recovery using the volume down button and press power to select it.
Hopefully it is able to recover and re-flash the firmware.
Click to expand...
Click to collapse
That is exactly what I did, but I ended up on the black screen with the triangle (As stated in my first post).
Sarcks said:
(As stated in my first post).
Click to expand...
Click to collapse
Doh missed that bit Sorry to be of little help. Hopefully someone else can proffer a solution.
if it's an unrooted phone, HTC have been very good at fixing phones bricked during OTA in my experience (2 day turnaround)
When you see the phone with the red triangle before you want to enter the recovery press vol - and the power button.....or at least the vol - button. Can't recreate it as i am on a custom recovery. You will bypass the red triangle and will enter the recovery. Maybe a cache wipe wil do, or a factory reset !
MarcelHofs said:
When you see the phone with the red triangle before you want to enter the recovery press vol - and the power button.....or at least the vol - button. Can't recreate it as i am on a custom recovery. You will bypass the red triangle and will enter the recovery. Maybe a cache wipe wil do, or a factory reset !
Click to expand...
Click to collapse
I've tried the factory reset be just like the normal boot it gets stuck on the HTC logo.
Clearing the cache might work but doesn't your phone needs to be rooted for that?
Sarcks said:
I've tried the factory reset be just like the normal boot it gets stuck on the HTC logo.
Clearing the cache might work but doesn't your phone needs to be rooted for that?
Click to expand...
Click to collapse
I cant recall if wiping cache is an option in the stock recovery !?
One can erase cache using 'fastboot erase cache' after getting the phone to restart in fastboot mode. See here and go to the 'Try this first' section. Hope this helps.
Sarcks said:
I've recently got the JB update so I installed it, or atleast tried. Because when I try to turn on my phone again it gets stuck on the HTC logo (White screen).
I think somehow my battery went down during the installation and now I can't access my phone anymore.
It's a clean phone, no costum ROM and I haven't rooted it in any way.
Is there a way to fix my problem? (Preferably withour rooting it.)
I tried holding the power and volume down buttons and then selecting recovery but that doesn't work as I just end up getting stuck on the black screen with the Red triangle.
Regards
Sarcks
Click to expand...
Click to collapse
Sounds like hboot version problem with JB upgrade, what version of HOX you have? what version of hboot? , maybe we can unlock your phone and recover the system with custom rom and then rollback to stock rom.
Regards
I have a problem on my device I tried to replace rum and stuck in the middle and I turn on the phone it shows the logo of LG and stuck I also tried to burn Boot New Way rows CMD and after that I tried to reset the device I thought I left Rikover no Rikover so I can not install a device can a detailed guide of someone who knows it all because I am concerned that your device will not work Thanks in advance.
TheLgMan said:
I have a problem on my device I tried to replace rum and stuck in the middle and I turn on the phone it shows the logo of LG and stuck I also tried to burn Boot New Way rows CMD and after that I tried to reset the device I thought I left Rikover no Rikover so I can not install a device can a detailed guide of someone who knows it all because I am concerned that your device will not work Thanks in advance.
Click to expand...
Click to collapse
Try to go into recovery. Turn off your phone and turn your phone on with the power button + vol down. When the phone turns on,let go and press the same combo buttons again for a few seconds until it shows a factory reset. Click yes for both ( no it won't delete your data) and it will take you to TWRP
ןIt's still not working and I tried it yesterday and now it does not work because it is installed on the device Recovery So how do I solve this problem please help me!
Thanks in advance.
xmagiicsx said:
Try to go into recovery. Turn off your phone and turn your phone on with the power button + vol down. When the phone turns on,let go and press the same combo buttons again for a few seconds until it shows a factory reset. Click yes for both ( no it won't delete your data) and it will take you to TWRP
Click to expand...
Click to collapse
I can not go into recovery it does not give it to boot sends me what it is ??
Might not have installed correctly the operating system ??
sorry dable post
TheLgMan said:
I have a problem on my device I tried to replace rum and stuck in the middle and I turn on the phone it shows the logo of LG and stuck I also tried to burn Boot New Way rows CMD and after that I tried to reset the device I thought I left Rikover no Rikover so I can not install a device can a detailed guide of someone who knows it all because I am concerned that your device will not work Thanks in advance.
Click to expand...
Click to collapse
I had stock recovery and unrooted phone.. Bootloader unlocked..
I updated my phone with version 2.10.720.5 ..
After than phones doesnt starts..
Tried wiping data.. Nothing happens... Please help me.
happiy91 said:
I had stock recovery and unrooted phone.. Bootloader unlocked..
I updated my phone with version 2.10.720.5 ..
After than phones doesnt starts..
Tried wiping data.. Nothing happens... Please help me.
Click to expand...
Click to collapse
Tighten two volume buttons and the power button when you see a black screen and holding down the volume- and power button that would go to bootloader.Telefon must be connected to kompyuteru.Esli got to go to the boot loader, boot into download sistemu.Esli not work then you have forgiven stock rekaveri of loader. https://yadi.sk/d/nWnRAChBnEtxG