Hi All
Replaced one of these and it's not responding properly, it is the type with the bubble at bottom that you slide up to unlock.
If i put 'pressure' on the screen it does respond somewhat.
It was a simple install and i am 99.9% sure all is connected well (have checked/re-checked)
I was unaware there were three versions !!!!
I have just looked at the old ribbon on the broken digi but there is no Rev no ?
I have also been into bootloader mode and reset the handset.
I have also tried this but get an error - It does go into weird mode though, reads memory card then -
Security Fail !
Update Fail !
Press <power> to reboot
.google.com/site/repairlinks/htc/htc-wildfire-s-calibration
Anyone help ? I have been told i need to get it into S-OFF or flash a rom ??
Details below -
*****LOCKED****
Marvel PVT SHIP S-ON RL - so i am still in S-ON mode
HBOOT-1.09.0099
MICROP-0451
RADIO- 7.57.39.10M
Feb 8 2012,18:29:31
Cheers
I think theres some air between the digitizer and the screen
Verstuurd van mijn Wildfire S A510e met Tapatalk
Related
My son's device was briefly immersed in water. After thouroughly drying it over a few days (battery removed imediately) the device seems almost fully functional unfortunately, since wetting the device, he has managed to lose the installed gold card.
I have full fastboot functionality but, when trying to boot the device it remains on the htc screen :crying:
My pc recognises the device as a disk drive but is unable to display it under my pc. :crying:
The device is locked to the 3UK network and has cid H3G__001 but has 2.13.401.2 firmware installed by means of the now non-existant gold-card.
I am not used to the ways of the Wildfire S but have experience with the desire, sensation and one x so I am not quite a complete noob
A few questions:
1/ Is it possible to make another goldcard with the device in this state?
2/ Does anybody have a 3UK RUU available (preferably the latest one) as I have not been able to locate one anywhere?
Any advice or assistance would be very much appreciated.
p.s. I have not been able to unlock the bootloader at htc.dev.
device details:
MARVEL PVT SHIP S-ON RL
HBOOT-0.90.0000
MICROP-0451
RADIO-7.53.39.03M
I appreciate that something may still be irretrievably damaged.
Actually wanted to flash this device, we had to obtain s-off, did everything in aakh, was first downgrade, all downloaded, the phone came in half an hour, and during hboot sought firmware ... I pulled the battery, went back to hboot, first was some sort of mistake, but then update the radio and even something and the phone rebooted and I got a - 1) a white screen and the words htc, and 2) hbut unresponsive buttons. help please. excuse me for my english.
HBOOT:
ACE PVT SHIP S-ON RL
HBOOT-0.85.0024
MICROP-0438
RADIO-26.09.04.11_M2
eMMC-boot
Apr 12 2011, 00:55:45
PC don't see the phone, and I pulled the battery for the night, then insert - to no avail.
buloshnik said:
Actually wanted to flash this device, we had to obtain s-off, did everything in aakh, was first downgrade, all downloaded, the phone came in half an hour, and during hboot sought firmware ... I pulled the battery, went back to hboot, first was some sort of mistake, but then update the radio and even something and the phone rebooted and I got a - 1) a white screen and the words htc, and 2) hbut unresponsive buttons. help please. excuse me for my english.
HBOOT:
ACE PVT SHIP S-ON RL
HBOOT-0.85.0024
MICROP-0438
RADIO-26.09.04.11_M2
eMMC-boot
Apr 12 2011, 00:55:45
PC don't see the phone, and I pulled the battery for the night, then insert - to no avail.
Click to expand...
Click to collapse
Take sdcard out and try to navigate in hboot. Your sdcard might be corrupted. I couldnĀ“t get 90% of what you said you wanted to do...
glevitan said:
Take sdcard out and try to navigate in hboot. Your sdcard might be corrupted. I couldnĀ“t get 90% of what you said you wanted to do...
Click to expand...
Click to collapse
glevitan, you're a wizard! only now the next question aakh not see the phone and exe writes that the battery level is below 30%. But the phone is fully charged and the original wire from sensation xe.
Sorry, the question is solved, I forgot to go to fastboot once did it - everything went well! xda you the best!
Hi folks, I have a WILDFIRE S & have rooted the device and unlocked it also. The only issue iam haveing is turning s-on to s-off, i have tryd several times now to make a gold card, i have gotten this far......
Gold card made, When going to HBoot it says wrong zip, then just hangs on the Jumping to DIAG file.
My HBoot reads as follows...
*** UNLOCKED ***
MARVEL PVT SHIP S-ON RL
HBOOT-1.09.0099
MICROP-0451
RADIO-7.53.39.03M
Feb 8 2012, 18:29:31
i have tryed tons of threads that recon they have done it etc etc. and followed the steps to the letter (even searching
for a diff site to get the reversed key required for making said goldcard).
info on the device its-self...
Model ... HTC Mildfire S A510e
Brand ... Virgin _mobile
Device ... Marvel
Andriod version ... 2.3.5 (Gingerbread) ive not gotten around to doing custom roms on this device as of yet, i want to get this s-on to s-off first.
update...
well i have gold card made yet again from scratch, and have now tryed multiple diag files from diff places , only 2 do anything the rest just hang on Jumping to DIAG.
The ones that do actualy do something get to a grey screen that says Get SW Version ( pressing anything at this time does nothing ), then it says
Verify (something else but it was too quick)
then
Get OEMSBL time out!
Pls chk security flag
Press VOLDN to exit
so i press vol down, (have done this several times now with diff PG76DIAG.nbh from over the net (ie 4 share, filehost, mediafile, u guys also who post links for said file, alot dont work).
then says
Waiting for
GSM ready
then
Power =) Reflash
Vol -Dn =) DIAG so diag is selected and TP Calibration goes on , says all is ok, format goes ok , then i get
Clean S58 Data
Device Info
I select Clean S58 Data and then confirm to clean data and it doesnt say clean ok or anything like i have seen over the net, it just reboots, and has not turn'd S-ON to S-Off, some help i think is needed as i shouldnt be getting Get OEMSBL time out!, Pls chk security flag, Press VOLDN to exit happening.
You'll need an XTC-Clip to get S-Off on the WFS. See this topic.
I get my phone two days ago, and first update went well and second htc update went not so well. It was loading and then transformig it , then it shut down and open to quiently brilliant htc white. It did open and shut down several times no stopping. I try to recover and do factory reset ,no luck.
Informations from phone:
***LOCKED***
ENDEAVORU XE SHIP S-OFF RL
CID-11111111
HBOOT-1.12.0000
CPLD-None
RADIO-2.1204.135.20
eMMC-bootmode: disabled
CPU -bootmode : disabled
HW Secure boot : enabled
MODEM PATH . OFF
Jun 28 2012,11:31:28
HBOOT
SD Checking...
Failed to open usb master mode
Failed to open usb master mode
loading HTCUpdateZipName image...
Failed to open usp master mode
I has contackt to phone delivery in china , but not yet is given any sollution how to solve this problem. Seller sell phones that has 1 year warranty, and i hope that this is warranty case if i do not get better or easy help for anybody.
So i ask . can anybody help me?
I am not very good with any pc programs.
Read this thread
http://forum.xda-developers.com/showthread.php?t=2612177
Hello, few days back it was hanged and i restarted it by taking the battery out, from then its digitizer is not working.
i believe that its is corrupt and i want to reinstall its android operating system.
as now i cant install apps on it so i have it rely on pc and hboot.
BUZZ PVT SHIP S-ON
HBOOT-1.01.0002
MICRO-0622
RADIO 3.35.20.10
DEC 2 2010
Made in Taiwan PC49100
I have tried to install
1- some RUU.exe from pc but they leave me with error : customer id error 131 obtain correct utility for your device.
2 - Update.zip also give signature verification error.
now what can be done.
this problem should be resolved my some software or this device hardware is dead and a punch in software face.
hope to resolve.
Developer150 said:
Hello, few days back it was hanged and i restarted it by taking the battery out, from then its digitizer is not working.
i believe that its is corrupt and i want to reinstall its android operating system.
as now i cant install apps on it so i have it rely on pc and hboot.
BUZZ PVT SHIP S-ON
HBOOT-1.01.0002
MICRO-0622
RADIO 3.35.20.10
DEC 2 2010
Made in Taiwan PC49100
I have tried to install
1- some RUU.exe from pc but they leave me with error : customer id error 131 obtain correct utility for your device.
2 - Update.zip also give signature verification error.
now what can be done.
this problem should be resolved my some software or this device hardware is dead and a punch in software face.
hope to resolve.
Click to expand...
Click to collapse
Look at the downgrade your hboot to 1.01.001 thread and follow its steps. It will fix your ROM and downgrade your hboot as well ( an issue when trying to run an ruu)
Sent from my HTC Desire S using Tapatalk