i need the rom of the xda zinc, my zinc is not working proberly, and therefore i think a clean sweap and and a rom , will solve the prblem.
the following problems have occured:
keyboard does not function
camera icon is not in today screen or programs screen
camera will not start up
problems with charging
have to make to many resets a day
all these problems have occured and i hope somebody will help, btw, i have done several hard resets
regards peter
the netherlands
hard reset
volume-up + power + soft reset and seleck softkey left
Related
dear friends ,
my phone has shut down and only when you take out the battery and put it back in after which you press any button on the phone it comes on and shows the htc logo after which it displays the following
ipl 3.07.001
spl 3.07.000
gsm 02.69.90
os 3.7.0.0
remains on for about 5-6 seconds and goes off
have tried to enter the boot loader mode by pressing the record button and reset button but it continous to behave in the same manner as mentioned above .
also when i try to charge the phone it shows only a red light
hoping someone can offer a solution to my problem
thanks and regards
I'd also be interested to know about this as my MDA Compact III has just done exactly the same thing.
have you guys tried flashing...that could kill it if not done propertly....but i doubt,the led is on,splash screen appears...info appears...what were last few things you did
according to spl os and ipl you flashed artemis touch 4.02 if i'm not wrong...or maybe tom's v5...try reflashing the same rom or just try a hardreset
Interesting...I've recently flashed the same ROM (v4.02)
I am certain I followed all the instructions about USPL and its been working fine for about a week...then it just went blank!
Will try re-flashing and/or a hard reset.
Thanks for the advice.
mrd5477 said:
Interesting...I've recently flashed the same ROM (v4.02)
I am certain I followed all the instructions about USPL and its been working fine for about a week...then it just went blank!
Will try re-flashing and/or a hard reset.
Thanks for the advice.
Click to expand...
Click to collapse
well...if it worked i'm sure you installed some app or deleted some files...so the system doesn't work...
if so hr will help
dear friends,
took the device in for repairs the fault was with the power circuit board which had to be changed as`informed to me by the technician
i now remember a few months ago the power button stopped working and a few days before the phone went bad it would work intermittently but there was no spring in the button hence it would have to be pressed quite hard for it to work i feel that this loose power button caused the power circuit to fail also my sd card was spoilt and the same had to be replaced
cast me appx in usd 30 for the repairs
thanks
Hi all
I have a problem with my PDA (Qtek S200)
IPL 2.10.0001
SPL 2.G4.4PDA
GSM 02.69.21
THE 7.0.0.7
And it is this:
Made a backup of my contacts over SPBackup, did the flash ROM of everything he turned to run normally, I made the restores the contacts and SMS, ... and when it does reebot it is only by the initial image that presents the data above:
IPL, SPL, ...
We have tried to make the soft-reset (pen of the button and the small button on the camera and nothing)
My question: Does anyone know how solve this?
Best Regards and thanks
Bye
Anybody help me ?
Please it's very urgent...
thanks all
can you do a hard reset using the keys and see if that allows the device to boot again ?
reading your post again, i assume that is what you are trying to do with the camera button when resetting, hmmmm
Ok, if i were you, i would try this next.
Enter bootloader mode by doing the following
To enter bootloader, you need to hold the comm manager button and soft reset
If that allows you to enter bootloader, then try reflashing the rom
let us know how you get on after that.
also it might be worth posting in the forum for this device, if you havent already.
hard reset.....To perform a hard reset
Z3nD3n said:
Hi all
I have a problem with my PDA (Qtek S200)
IPL 2.10.0001
SPL 2.G4.4PDA
GSM 02.69.21
THE 7.0.0.7
And it is this:
Made a backup of my contacts over SPBackup, did the flash ROM of everything he turned to run normally, I made the restores the contacts and SMS, ... and when it does reebot it is only by the initial image that presents the data above:
IPL, SPL, ...
We have tried to make the soft-reset (pen of the button and the small button on the camera and nothing)
My question: Does anyone know how solve this?
Best Regards and thanks
Bye
Click to expand...
Click to collapse
To perform a hard reset
* Press and hold the CAMERA and COMM MANAGER buttons, and at the same time, use the stylus to press the RESET button at the bottom of your device.
Hello again ...
I am happy. Have back by my Qtek. had already done several times the Hard-Reset the PDA but always without success. I often followed and there began to anything on screen (the 3 colored bars, then asked the question of "send ..." where we have to press the green button "call") and then there came into bootloader and there could . He began to install everything right and it was if he had installed a Rom "new".
To all those who contributed to this "happy ending" my thank you very much.
sry my english
Bye and thanks
hi all,
i am just a user of all those nice roms that keeps flourishing in this nice forum. lately, i have been trying to flash several latest roms just to test/see/found the one i would prefer. unfortunately, and whatever is the rom i just flashed , i always end with my phone stucked - after having worked several hours perfectly - on manilla 3d (" loading manilla 3d...") . i also notices that despite the flash + hard reset, i still have some old SMS in the "new" flashed rom... it seems that something is wrong now when i flash a new rom and not everything is wiped / reinstalled.. and i may still have "old" files generating probably conflicts with the "new" flash..
any hints/idea ? is there even "stronger" than hard rester to ensure i start from scratch ??
tks
eric
i can give you for 100% garantie for two roms without leaks or faults:
1. bepes version : Diamond_bElite_x_0.99x_0407_by_bepe (ie for german)
2. diamond project : TOM_DiamondProject_v3.3
its based on older rom (1.93) but these are the both roms where i was using it until i cooked my own rom.
now its exist so much roms, that nobody can give up a real long test of the roms. flashing, using for two days than result "its stabil" ... for me to early for result.
now, its your turn.
If you still have old SMS on ur phone, then you must not be hard resetting correctly. Ensure you read the guides and follow those directions.
To perform a Hard Reset:
To perform a hard reset
1. Pull out the stylus.
2. With the device turned on, press and hold the VOLUME DOWN and
ENTER buttons, then press the RESET button with the stylus tip.
3. Release the RESET button, but continue pressing the VOLUME DOWN and ENTER buttons until you see a message on the screen.
4. Release the VOLUME DOWN and ENTER buttons, then press the
VOLUME UP button to perform the hard reset, or press any other
button to cancel the reset.
Try this...
Hello, this is my first post here. I tried to install Windows Mobile 6.5 as indicated in Gizmodo http://gizmodo.com/5281397/how-to-install-windows-mobile-65-right-now but it didn't work and now my phone won't boot.
The phone is an HTC Touch Diamond from Sprint. I followed all the steps indicated and everything look fine, but after installing the OS the phone displays the screen TOUCH DIAMOND, and then restarts and displays the same thing. I'm able to get into the boot loader (Tri color screen) and says:
DIAM500
SPL-0.57.CMONEX
MicroP-Diam (LED) vB
PSOC-Diam STAGE_EVT v20.
I don't know what to do now
Thanks
try to load back to default setting by pressing the power on button at the top of the phone, before the "Touch Diamond" logo come up, press and hold volume down button and the center button until the three color screen come out, then release the two button you are pressing..
if the problem still happen, that mean the rom you are using should have risk on it..
give it up and try other rom or flash it again..
hope my suggestion can help you solve the problem..
dont worry.
if bootloader is possible as you write
than you can flash all time orig. rom back.
Flash from Olinex 1.40 screen?
okokur said:
dont worry.
if bootloader is possible as you write
than you can flash all time orig. rom back.
Click to expand...
Click to collapse
Hi I have the same issue on my HTC Diamond. I flashed wm 6.5 and it was working fine, then it hanged on titanum weather. I reset and it stayed on the HTC Diamond page, I did hard reset and got the Olinex 1.40 3 color page. It does respond from serial to usb when I plug/unplug. Can I reflash without active sync?
Turns out I was able to flash, but both roms I tried work well on 1st install, but stay stuck on the Touch Diamond screen everytime I restart de device. Is it a problem with the radio not compatible , or is there a specific Hspl for each ROM???
I found solution for this problem. If your diamond won't boot go to bootloader mode and upgrade your radio http://modmydiamond.info/index.php?option=com_content&task=view&id=15&Itemid=26 and after that your dimond worked fine without loosing data.
try to hard reset the phone by pressing vol down key + the center button + reset button.
if the problem is still like dat..
try to install another rom..
davidwong007 said:
try to load back to default setting by pressing the power on button at the top of the phone, before the "Touch Diamond" logo come up, press and hold volume down button and the center button until the three color screen come out, then release the two button you are pressing..
if the problem still happen, that mean the rom you are using should have risk on it..
give it up and try other rom or flash it again..
hope my suggestion can help you solve the problem..
Click to expand...
Click to collapse
Thanks davidwong007 for your help, I was experiencing the same issue as op and your method did the trick. For a minute there I thought I had bricked my HTC Touch. I did step by step what you suggested and ended up in the rainbox screen, once I was able to do that, I knew there was a hope. i did a full factory reset of the phone and voila the phone fully booted, the pain in the butt touchflow loaded. Very important thing I forgot to do in the past is to back up my phone, after the restore you will lose everything on phone, except what is in the internal storage. Thanks again.
hi evry one...i have a problem with my ks20...i installed application from htc, opera browser build for wm6.1 or 6.5...at first it worked but after soft reset my phone dont open anymore...it stock on the bootloader showing lg icon only...is there anyway for me to hard reset my ks20...please help if somebody knew or experienced this....thanks
Workaround
Turn of your device, press these buttons (volume-down, call and on/off) at the same time and count 20