Hi!
After a soft reset the GPRS/EDGE is working perfectly, but when I connect and disconnect form PC (Active sync) the EDGE/GPRS does not connect anymore. I tried to start IE, but I just get an error reporting no network. I'm not able to use GPRS/EDGE unless I perform a new soft reset.
PK
Related
My PDA2k (1.12.00 WWE, Radio 1.02.00, ExtrROM1.12.134WWE)
use to sych fine remotely. with no change in cofiguration, active sych changed its behavior . When I lauch Activesynch it launches a GRPS connection (if not already connected) but fails to launch the VPN connection which used to follow, which causes the synch to fail. Any one had this problem? any solutions or pointers?
Many thnx for any help.
Hi,
How to choose whith way AGPS is connecting to the internet?
I am connected to internet via wifi , and AGPS is trying to connect via GPRS - Its always is failed.
m.t
after i instaled WM6 i cen no,longer connect to GPRS/EDGE even if i set up the connection manualy when i try to connect it says: "the remote party has ended this connection"
_-------------------------------------
iv entered wrong pass
1. Previously when I connected my artemis via USB with AS everything was OK. I connect Artemis to PC without advanced PC connection, today it doesn`t work.
2. When I try to change advanced settings USB to PC/Enable advanced network fuctionality (ON), AS is connecting.
In my PDA appears the problem that I can not give the address IP, it causes that internet doesn`t work.
In the first case AS I received an error that I can`t get the IP address and I should visit MS Page.AS doesn`t connect.
I used SK Tools soft and clean pda, mayby this crash the pda?
I find the isue
http://forum.xda-developers.com/showpost.php?p=1529888&postcount=45
So I followed the directions to offline install W10 to my 8.1 lumia, then installed the .ppkg file to get onto the enterprise branch. Throughout all of this, there was no SIM card, and it was connecting fine to WiFi. Ran the OTA update to 10586.1045, reset to factory and it still connected to my WiFi. Then I reinstalled my SIM card, and it now won't connect to any wifi connections. If I remove the SIM and reboot, it connects to them again. Replace the SIM, reboot again, no WiFi. It can sometimes see one of my signals (2.4, but never my 5g), but it won't connect to either of them.
Thoughts?
Here is the setup I followed: https://forums.windowscentral.com/w...test-10586-xxx-14393-xxx-15063-xxx-build.html
As an update - it appears that the phone will connect to unsecured networks. My networks are WPA2.
change registry to supported device and upgrade to AU or CU (recommended AU for x20 device)